Lines Matching +full:a +full:- +full:io2 +full:- +full:idle +full:- +full:high

2 # SPDX-License-Identifier: Apache-2.0
10 compatible: "nxp,s32-qspi"
12 include: [base.yaml, pinctrl-device.yaml]
20   "#address-cells":
23   "#size-cells":
26   data-rate:
29       - SDR
30       - DDR
33       - Single Data Rate (SDR): sampling of incoming data occurs on single edges.
34       - Double Data Rate (DDR): sampling of incoming data occurs on both edges.
36   hold-time-2x:
43   sample-delay-half-cycle:
46       Set to use half-cycle early DQS delay when sampling received data.
48   sample-phase-inverted:
53   cs-setup-time:
57       Chip select setup time, in serial clock cycles. A bigger value will pull
61   cs-hold-time:
65       Chip select hold time, in serial clock cycles. A bigger value will release
69   column-space:
79   word-addressable:
85   byte-swapping:
88       In case of Octal DDR mode, specifies whether a word unit composed of two
89       bytes from posedge and negedge of a single DQS cycle needs to be swapped.
91   ahb-buffers-masters:
99   ahb-buffers-sizes:
105   ahb-buffers-all-masters:
108       Any access from a master not associated with any other buffer is routed to
111   a-rx-clock-source:
114       - LOOPBACK
115       - LOOPBACK DQS
116       - INTERNAL DQS
117       - EXTERNAL DQS
119       Selects DQS clock source for sampling read data at side A:
120       - LOOPBACK: use loopback clock from dummy internal PAD as strobe signal.
121       - LOOPBACK DQS: use loopback clock from PAD as strobe signal.
122       - INTERNAL DQS: use internally generated strobe signal.
123       - EXTERNAL DQS: use external strobe signal.
125   a-io2-idle-high:
128       Set if the logic level of IO2 signal output of this controller must be
129       driven high in the inactive state.
130       This property applies to side A of the controller.
132   a-io3-idle-high:
136       driven high in the inactive state.
137       This property applies to side A of the controller.
139   a-dll-mode:
142       - BYPASSED
143       - MANUAL UPDATE
144       - AUTO UPDATE
148       This property applies to side A of the controller.
150   a-dll-freq-enable:
153       Selects delay-chain for high frequency of operation.
154       This property applies to side A of the controller.
156   a-dll-ref-counter:
164       This property applies to side A of the controller.
166   a-dll-resolution:
174       This property applies to side A of the controller.
176   a-dll-coarse-delay:
182       is used to overwrite DLL-generated delay values.
184       This property applies to side A of the controller.
186   a-dll-fine-delay:
194       This property applies to side A of the controller.
196   a-dll-tap-select:
201       Selects the Nth tap provided by the slave delay-chain.
203       This property applies to side A of the controller.
205 child-binding:
208   include: nxp,s32-qspi-device.yaml