Lines Matching full:single

70       (should be transmitted in single bus mode).
89       Read command for single/burst read accesses in auto mode. Default value is the opcode
90       for single mode which is supported by all memory devices.
96       Write command for single/burst write accesses in auto mode. Default value is the opcode
97       for single mode which is supported by all memory devices.
153       Number of dummy bytes to send for single/burst read access in auto mode.
170       - "single-spi"
173     default: "single-spi"
175       Describes the mode of SPI bus during the address phase for single/burst
176       read accesses in auto mode. Default value is single mode which should be
182       - "single-spi"
185     default: "single-spi"
187       Describes the mode of SPI bus during the instruction phase for single/burst
188       read accesses in auto mode. Default value is single mode which should be
194       - "single-spi"
197     default: "single-spi"
199       Describes the mode of SPI bus during the data phase for single/burst
200       read accesses in auto mode. Default value is single mode which should
206       - "single-spi"
209     default: "single-spi"
211       Describes the mode of SPI bus during the dummy bytes phase for single/burst
212       read accesses in auto mode. The single mode should be supported by all
218       - "single-spi"
222       Describes the mode of SPI bus during the extra byte phase for single/burst
223       read accesses in auto mode. Default value is single mode which should be
229       - "single-spi"
232     default: "single-spi"
234       Describes the mode of SPI bus during the address phase for single/burst
235       write accesses in auto mode. Default value is single mode which should
241       - "single-spi"
244     default: "single-spi"
246       Describes the mode of SPI bus during the instruction phase for single/burst
247       write accesses in auto mode. The single mode should be supported by all
253       - "single-spi"
256     default: "single-spi"
258       Describes the mode of SPI bus during the data phase for single/burst
259       write accesses in auto mode. Default value is single mode which should