Lines Matching full:should

36       [7:0] should reflect the density value itself and [15:8] should reflect
37       the mask that should be applied to the returned device ID value.
56       Min. time, in nanoseconds, the #CS line should remain inactive between
62       Min. time, in nanoseconds, the #CS line should remain inactive after the execution
70       (should be transmitted in single bus mode).
76       (should be transmitted in quad bus mode).
83       commands, that should be read-cmd and write-cmd respectively, reflect the QPI mode.
111       Mode0 is selected by default as it should be supported by all memory devices.
135       If a non zero value is applied, then Tcem should be taken into
159       This should be useful if 3 dummy bytes are required. In such a case,
160       dummy-bytes-count should be set to 2.
176       read accesses in auto mode. Default value is single mode which should be
188       read accesses in auto mode. Default value is single mode which should be
200       read accesses in auto mode. Default value is single mode which should
212       read accesses in auto mode. The single mode should be supported by all
223       read accesses in auto mode. Default value is single mode which should be
235       write accesses in auto mode. Default value is single mode which should
247       write accesses in auto mode. The single mode should be supported by all
259       write accesses in auto mode. Default value is single mode which should