Lines Matching full:burst

89       Read command for single/burst read accesses in auto mode. Default value is the opcode
96       Write command for single/burst write accesses in auto mode. Default value is the opcode
136       consideration by QSPIC2 so that it can split a burst read/write
141       the #CS line can be driven low in a write/read burst access
153       Number of dummy bytes to send for single/burst read access in auto mode.
175       Describes the mode of SPI bus during the address phase for single/burst
187       Describes the mode of SPI bus during the instruction phase for single/burst
199       Describes the mode of SPI bus during the data phase for single/burst
211       Describes the mode of SPI bus during the dummy bytes phase for single/burst
222       Describes the mode of SPI bus during the extra byte phase for single/burst
234       Describes the mode of SPI bus during the address phase for single/burst
246       Describes the mode of SPI bus during the instruction phase for single/burst
258       Describes the mode of SPI bus during the data phase for single/burst