Lines Matching full:hold
39 setup, pulse and hold. The setup is used to address the memory. The pulse
40 is the time used to read/write. The hold is used to release memory. For the
42 (6 cycles) for CPU read/write and no hold time is required.
43 Note: Since no hold parameter is available at SMC the atmel,smc-cycle-timing
44 should have additional cycles to accommodate for hold values.
46 No Hold Time:
47 cycle-timing (7) = setup (1) + pulse (6) + hold (0)
49 With 3 Hold Times:
50 cycle-timing (10) = setup (1) + pulse (6) + hold (3)
99 on the bus during the pulse and hold steps of that signal.
112 from the bus during the pulse and hold steps of that signal.
146 is defined as: cycle = setup + pulse + hold