Lines Matching full:your
27 #. Depending on your platform, install the package or run the installer
34 The nRF5x command-line Tools allow you to control your nRF5x device from the command line,
37 To install them, visit `nRF5x Command-Line Tools`_ and select your operating
40 After installing, make sure that ``nrfjprog`` is somewhere in your executable path
51 * Connect the micro-USB cable to the nRF5x board and to your computer
60 * Flash the Zephyr image from the sample folder of your choice:
82 To work around this disable the Mass Storage Device on your board as described in :ref:`nordic_segg…
94 Type the command below to add your user to the dialout group to give it access to the serial port.
103 port for a few seconds, and can make your application misbehave if it reads
104 data from the UART. Before running your application, you might want to
133 Due to a known issue in Segger's J-Link firmware, depending on your operating system
161 To use RTT, you will first need to enable it by adding the following lines in your ``.conf`` file:
179 add this to your ``.conf`` file:
195 * Target Device: Select your IC from the list
205 * Device Name: Use the fully qualified device name for your IC
226 * Target Device: Select your IC from the list
232 file that you can find in your build folder.