Lines Matching full:nrf5x

5 Nordic nRF5x Segger J-Link
11 All Nordic nRF5x Development Kits, Preview Development Kits and Dongles are equipped
15 * SWD debug for the nRF5x IC
17 * USB CDC ACM Serial Port bridged to the nRF5x UART peripheral
28 #. When connecting a J-Link-enabled board such as an nRF5x DK, PDK or dongle, a
31 nRF5x Command-Line Tools Installation
34 The nRF5x command-line Tools allow you to control your nRF5x device from the command line,
37 To install them, visit `nRF5x Command-Line Tools`_ and select your operating
49 to install the Segger J-Link Software and the nRF5x Command-Line Tools, follow the steps below:
51 * Connect the micro-USB cable to the nRF5x board and to your computer
52 * Erase the flash memory in the nRF5x IC:
80 **Important note**: An issue with Segger J-Link firmware on the nRF5x boards might cause
157 connection (both input and output) to be established between the target (nRF5x board)
158 and the development computer for logging and input. Zephyr supports RTT on nRF5x targets,