Lines Matching +full:usb +full:- +full:c +full:- +full:connector
7 STMicroelectronics ARM |reg| Cortex |reg|-M33 core-based STM32H563ZIT6
11 - STM32H563ZI microcontroller featuring 2 Mbytes of Flash memory and 640Kbyte of
13 - Board connectors:
15 - USB Type-C |trade| Sink device FS
16 - Ethernet RJ45 connector compliant with IEEE-802.3-2002 (depending on STM32 support)
17 - ST Zio expansion connector including Arduino Uno V3 connectivity (CN7, CN8, CN9, CN10)
18 - ST morpho extension connector (CN11, CN12)
20 - Flexible board power supply:
22 - 5V_USB_STLK from ST-Link USB connector
23 - VIN (7 - 12V, 0.8A) supplied via pin header CN8 pin 15 or CN11 pin 24
24 - 5V_EXT on the ST morpho connector CN11 Pin 6 (5V, 1.3)
25 - CHGR from a USB charger via the ST-LINK USB connector
26 - USB_USER from the USB user connector (5V, 3A)
27 - 3V3_EXT supplied via a pin header CN8 pin 7 or CN11 pin 16 (3.3V, 1.3A)
29 - On-board ST-LINK/V3EC debugger/programmer
31 - mass storage
32 - Virtual COM port
33 - debug port
35 - Three users LEDs
36 - Two push-buttons: USER and RESET
37 - 32.789 kHz crystal oscillator
44 The STM32H563xx devices are high-performance microcontrollers from the STM32H5
45 Series based on the high-performance Arm |reg| Cortex |reg|-M33 32-bit RISC core.
48 - Core: ARM |reg| 32-bit Cortex |reg| -M33 CPU with TrustZone |reg| and FPU.
49 - Performance benchmark:
51 - 375 DMPIS/MHz (Dhrystone 2.1)
53 - Security
55 - Arm |reg| TrustZone |reg| with ARMv8-M mainline security extension
56 - Up to 8 configurable SAU regions
57 - TrustZone |reg| aware and securable peripherals
58 - Flexible lifecycle scheme with secure debug authentication
59 - SFI (secure firmware installation)
60 - Secure firmware upgrade support with TF-M
61 - HASH hardware accelerator
62 - True random number generator, NIST SP800-90B compliant
63 - 96-bit unique ID
64 - Active tampers
66 - Clock management:
68 - 25 MHz crystal oscillator (HSE)
69 - 32 kHz crystal oscillator for RTC (LSE)
70 - Internal 64 MHz (HSI) trimmable by software
71 - Internal low-power 32 kHz RC (LSI)( |plusminus| 5%)
72 - Internal 4 MHz oscillator (CSI), trimmable by software
73 - Internal 48 MHz (HSI48) with recovery system
74 - 3 PLLs for system clock, USB, audio, ADC
76 - Power management
78 - Embedded regulator (LDO) with three configurable range output to supply the digital circuitry
79 - Embedded SMPS step-down converter
81 - RTC with HW calendar, alarms and calibration
82 - Up to 139 fast I/Os, most 5 V-tolerant, up to 10 I/Os with independent supply down to 1.08 V
83 - Up to 16 timers and 2 watchdogs
85 - 12x 16-bit
86 …- 2x 32-bit timers with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder in…
87 - 6x 16-bit low-power 16-bit timers (available in Stop mode)
88 - 2x watchdogs
89 - 2x SysTick timer
91 - Memories
93 - Up to 2 MB Flash, 2 banks read-while-write
94 - 1 Kbyte OTP (one-time programmable)
95 - 640 KB of SRAM including 64 KB with hardware parity check and 320 Kbytes with flexible ECC
96 - 4 Kbytes of backup SRAM available in the lowest power modes
97 …- Flexible external memory controller with up to 16-bit data bus: SRAM, PSRAM, FRAM, SDRAM/LPSDR S…
98 …- 1x OCTOSPI memory interface with on-the-fly decryption and support for serial PSRAM/NAND/NOR, Hy…
99 - 2x SD/SDIO/MMC interfaces
101 - Rich analog peripherals (independent supply)
103 - 2x 12-bit ADC with up to 5 MSPS in 12-bit
104 - 1x 12-bit D/A with 2 channels
105 - 1x Digital temperature sensor
107 - 34x communication interfaces
109 - 1x USB Type-C / USB power-delivery controller
110 - 1x USB 2.0 full-speed host and device
111 - 4x I2C FM+ interfaces (SMBus/PMBus)
112 - 1x I3C interface
113 - 12x U(S)ARTS (ISO7816 interface, LIN, IrDA, modem control)
114 - 1x LP UART
115 - 6x SPIs including 3 muxed with full-duplex I2S
116 - 5x additional SPI from 5x USART when configured in Synchronous mode
117 - 2x SAI
118 - 2x FDCAN
119 - 1x SDMMC interface
120 - 2x 16 channel DMA controllers
121 - 1x 8- to 14- bit camera interface
122 - 1x HDMI-CEC
123 - 1x Ethernel MAC interface with DMA controller
124 - 1x 16-bit parallel slave synchronous-interface
126 - CORDIC for trigonometric functions acceleration
127 - FMAC (filter mathematical accelerator)
128 - CRC calculation unit
129 - Development support: serial wire debug (SWD), JTAG, Embedded Trace Macrocell |trade|
133 - `STM32H563ZI on www.st.com`_
134 - `STM32H563 reference manual`_
139 .. zephyr:board-supported-hw::
145 input/output, pull-up, etc.
147 For more details please refer to `STM32H5 Nucleo-144 board User Manual`_.
150 ----------------------------------
152 - ADC1 channel 3 input: PA6
153 - ADC1 channel 15 input: PA3
154 - DAC1 channel 2 output: PA5
155 - CAN/CANFD TX/RX: PD1/PD0
156 - LD1 (green): PB0
157 - LD2 (yellow): PF4
158 - LD3 (red): PG4
159 - LPUART1 TX/RX : PB6/PB7 (Arduino LPUART1)
160 - SPI1 SCK/MISO/MOSI/CS: PA5/PG9/PB5/PD14
161 - UART3 TX/RX : PD8/PD9 (VCP)
162 - USER_PB : PC13
163 - I3C1: PD12(SCL) & PD13(SDA)
166 ------------
170 240MHz, driven by 8MHz external clock provided from the STLINK-V3EC.
173 -----------
179 -----------
183 VBAT can be provided via the left ST Morpho connector's pin 33.
188 Nucleo H563ZI board includes an ST-LINK/V3EC embedded debug tool interface.
207 .. code-block:: none
218 so its :ref:`installation <stm32cubeprog-flash-host-tools>` is required.
221 the ``--runner`` (or ``-r``) option:
223 .. code-block:: console
225 $ west flash --runner openocd
226 $ west flash --runner pyocd
227 $ west flash --runner jlink
232 .. code-block:: console
234 $ pyocd pack --update
235 $ pyocd pack --install stm32h5
239 ----------------------------------------
241 Connect the Nucleo H563ZI to your host computer using the USB port.
243 :zephyr:code-sample:`hello_world` application.
247 .. code-block:: console
249 $ minicom -D /dev/ttyACM0
253 .. zephyr-app-commands::
254 :zephyr-app: samples/hello_world
260 .. code-block:: console
268 :zephyr:code-sample:`blinky` application.
270 .. zephyr-app-commands::
271 :zephyr-app: samples/basic/blinky
276 https://www.st.com/en/evaluation-tools/nucleo-h563zi
278 .. _STM32H5 Nucleo-144 board User Manual:
279 …https://www.st.com/resource/en/user_manual/um3115-stm32h5-nucleo144-board-mb1404-stmicroelectronic…
285 …tps://www.st.com/resource/en/reference_manual/rm0481-stm32h563h573-and-stm32h562-armbased-32bit-mc…
288 https://www.st.com/en/development-tools/stm32cubeprog.html
291 https://github.com/openocd-org/openocd/
294 https://github.com/STMicroelectronics/OpenOCD/tree/openocd-cubeide-r6