Lines Matching +full:resistance +full:- +full:based

7 STMicroelectronics ARM |reg| Cortex |reg|-M33 core-based STM32H533RET6
11 - STM32H533RE microcontroller featuring 512 kbytes of Flash memory and 272 Kbytes of
14 - Board connectors:
16 - USB Type-C |trade| Sink device FS
17 - ST Zio expansion connector including Arduino Uno V3 connectivity (CN5, CN6, CN8, CN9)
18 - ST morpho extension connector (CN7, CN10)
20 - Flexible board power supply:
22 - 5V_USB_STLK from ST-Link USB connector
23 - VIN (7 - 12V, 0.8) supplied via pin header CN6 pin 8 or CN7 pin 24
24 - ESV on the ST morpho connector CN7 Pin 6 (5V, O.5A)
25 - VBUS_STLK from a USB charger via the ST-LINK USB connector
26 - VBUSC from the USB user connector (5V, 0.5A)
27 - 3V3_EXT supplied via a pin header CN6 pin 4 or CN7 pin 16 (3.3V, 1.3A)
29 - On-board ST-LINK/V3EC debugger/programmer
31 - mass storage
32 - Virtual COM port
33 - debug port
35 - One user LED shared with ARDUINO |reg| Uno V3
36 - Two push-buttons: USER and RESET
37 - 32.768 kHz crystal oscillator
44 The STM32H533xx devices are high-performance microcontrollers from the STM32H5
45 Series based on the high-performance Arm |reg| Cortex |reg|-M33 32-bit RISC core.
48 - Core: ARM |reg| 32-bit Cortex |reg| -M33 CPU with TrustZone |reg| and FPU.
49 - Performance benchmark:
51 - 375 DMPIS/MHz (Dhrystone 2.1)
53 - Security
55 - Arm |reg| TrustZone |reg| with Armv8-M mainline security extension
56 - Up to eight configurable SAU regions
57 - TrustZone |reg| aware and securable peripherals
58 - Flexible life cycle scheme with secure debug authentication
59 - SESIP3 and PSA Level 3 certified assurance target
60 - Preconfigured immutable root of trust (ST-iROT)
61 - SFI (secure firmware installation)
62 - Root of trust thanks to unique boot entry and secure hide protection area (HDP)
63 - Secure data storage with hardware unique key (HUK)
64 - Secure firmware upgrade support with TF-M
65 - Two AES coprocessors including one with DPA resistance
66 - Public key accelerator, DPA resistant
67 - On-the-fly decryption of Octo-SPI external memories
68 - HASH hardware accelerator
69 - True random number generator, NIST SP800-90B compliant
70 - 96-bit unique ID
71 - Active tampers
73 - Clock management:
75 - 24 MHz crystal oscillator (HSE)
76 - 32 kHz crystal oscillator for RTC (LSE)
77 - Internal 64 MHz (HSI) trimmable by software
78 - Internal low-power 32 kHz RC (LSI)( |plusminus| 5%)
79 - Internal 4 MHz oscillator (CSI), trimmable by software
80 - Internal 48 MHz (HSI48) with recovery system
81 - 3 PLLs for system clock, USB, audio, ADC
83 - Power management
85 - Embedded regulator (LDO) with three configurable range output to supply the digital circuitry
86 - Embedded SMPS step-down converter
88 - RTC with HW calendar, alarms and calibration
89 - Up to 112 fast I/Os, most 5 V-tolerant, up to 10 I/Os with independent supply down to 1.08 V
90 - Up to 16 timers and 2 watchdogs
92 - 8x 16-bit
93- 2x 32-bit timers with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder in…
94 - 2x 16-bit low-power 16-bit timers (available in Stop mode)
95 - 2x watchdogs
96 - 2x SysTick timer
98 - Memories
100 - Up to 512 Kbytes Flash, 2 banks read-while-write
101 - 1 Kbyte OTP (one-time programmable)
102 - 272 Kbytes of SRAM (80-Kbyte SRAM2 with ECC)
103 - 2 Kbytes of backup SRAM available in the lowest power modes
104- Flexible external memory controller with up to 16-bit data bus: SRAM, PSRAM, FRAM, NOR/NAND memo…
105- 1x OCTOSPI memory interface with on-the-fly decryption and support for serial PSRAM/NAND/NOR, Hy…
106 - 1x SD/SDIO/MMC interfaces
108 - Rich analog peripherals (independent supply)
110 - 2x 12-bit ADC with up to 5 MSPS in 12-bit
111 - 1x 12-bit DAC with 2 channels
112 - 1x Digital temperature sensor
113 - Voltage reference buffer
115 - 34x communication interfaces
117 - 1x USB Type-C / USB power-delivery controller
118 - 1x USB 2.0 full-speed host and device (crystal-less)
119 - 3x I2C FM+ interfaces (SMBus/PMBus)
120 - 2x I3C interface
121 - 6x U(S)ARTS (ISO7816 interface, LIN, IrDA, modem control)
122 - 1x LP UART
123 - 4x SPIs including 3 muxed with full-duplex I2S
124 - 4x additional SPI from 4x USART when configured in Synchronous mode
125 - 2x FDCAN
126 - 1x SDMMC interface
127 - 2x 16 channel DMA controllers
128 - 1x 8- to 14- bit camera interface
129 - 1x HDMI-CEC
130 - 1x 16-bit parallel slave synchronous-interface
132 - Development support: serial wire debug (SWD), JTAG, Embedded Trace Macrocell |trade|
136 - `STM32H533re on www.st.com`_
137 - `STM32H533 reference manual`_
144 +-----------+------------+-------------------------------------+
147 | CLOCK | on-chip | reset and clock control |
148 +-----------+------------+-------------------------------------+
149 | GPIO | on-chip | gpio |
150 +-----------+------------+-------------------------------------+
151 | NVIC | on-chip | nested vector interrupt controller |
152 +-----------+------------+-------------------------------------+
153 | PINMUX | on-chip | pinmux |
154 +-----------+------------+-------------------------------------+
155 | PWM | on-chip | PWM |
156 +-----------+------------+-------------------------------------+
157 | RNG | on-chip | True Random number generator |
158 +-----------+------------+-------------------------------------+
159 | RTC | on-chip | Real Time Clock |
160 +-----------+------------+-------------------------------------+
161 | BKP SRAM | on-chip | Backup SRAM |
162 +-----------+------------+-------------------------------------+
163 | UART | on-chip | serial port-polling; |
164 | | | serial port-interrupt |
165 +-----------+------------+-------------------------------------+
166 | WATCHDOG | on-chip | independent watchdog |
167 +-----------+------------+-------------------------------------+
168 | ADC | on-chip | ADC Controller |
169 +-----------+------------+-------------------------------------+
170 | USB | on-chip | USB full-speed host/device bus |
171 +-----------+------------+-------------------------------------+
172 | SPI | on-chip | spi |
173 +-----------+------------+-------------------------------------+
179 - Secure target:
181 - :zephyr_file:`boards/st/nucleo_h533re/nucleo_h533re_defconfig`
182 - :zephyr_file:`boards/st/nucleo_h533re/nucleo_h533re.dts`
187 The STM32H533 is a SoC with Cortex-M33 architecture. Zephyr provides support
192 +----------------------+-----------------------------------------------+
196 +----------------------+-----------------------------------------------+
202 input/output, pull-up, etc.
204 For more details please refer to `STM32H5 Nucleo-64 board User Manual`_.
207 ----------------------------------
209 - ADC1 channel 0 input: PA0
210 - USART1 TX/RX : PB14/PB15 (Arduino USART1)
211 - SPI1 SCK/MISO/MOSI/NSS: PA5/PA6/PA7/PC9
212 - UART2 TX/RX : PA2/PA3 (VCP)
213 - USER_PB : PC13
216 ------------
220 240MHz, driven by an 24MHz high-speed external clock.
223 -----------
229 -----------
238 Nucleo H533RE board includes an ST-LINK/V3EC embedded debug tool interface.
257 .. code-block:: none
267 so its :ref:`installation <stm32cubeprog-flash-host-tools>` is required.
270 the ``--runner`` (or ``-r``) option:
272 .. code-block:: console
274 $ west flash --runner openocd
275 $ west flash --runner pyocd
276 $ west flash --runner jlink
281 .. code-block:: console
283 $ pyocd pack --update
284 $ pyocd pack --install stm32h5
287 ----------------------------------------
291 :zephyr:code-sample:`hello_world` application.
295 .. code-block:: console
297 $ minicom -D /dev/ttyACM0
301 .. zephyr-app-commands::
302 :zephyr-app: samples/hello_world
308 .. code-block:: console
316 :zephyr:code-sample:`blinky` application.
318 .. zephyr-app-commands::
319 :zephyr-app: samples/basic/blinky
324 https://www.st.com/en/evaluation-tools/nucleo-h533re
326 .. _STM32H5 Nucleo-64 board User Manual:
327 …https://www.st.com/resource/en/user_manual/um3121-stm32h5-nucleo64-board-mb1814-stmicroelectronics…
330 https://www.st.com/en/microcontrollers-microprocessors/stm32h533re
333 …w.st.com/resource/en/reference_manual/rm0481-stm32h533-stm32h563-stm32h573-and-stm32h562-armbased-
336 https://www.st.com/en/development-tools/stm32cubeprog.html
339 https://github.com/openocd-org/openocd/
342 https://github.com/STMicroelectronics/OpenOCD/tree/openocd-cubeide-r6