Lines Matching full:-
6 of the MAX32690 microcontroller, which is an advanced system-on-chip (SoC).
7 It features an Arm® Cortex®-M4F CPU for efficient computation of complex functions and
25 - MAX32690 MCU:
27 - Ultra-Efficient Microcontroller for Battery-Powered Applications
29 - 120MHz Arm Cortex-M4 Processor with FPU
30 - 7.3728MHz and 60MHz Low-Power Oscillators
31 - External Crystal Support (32MHz required for BLE)
32 - 32.768kHz RTC Clock (Requires External Crystal)
33 - 8kHz Always-On Ultra-Low Power Oscillator
34 - 3MB Internal Flash, 1MB Internal SRAM (832kB ECC ON)
35 - TBDμW/MHz Executing from Cache at 1.1V
36 - 1.8V and 3.3V I/O with No Level Translators
37 - External Flash & SRAM Expansion Interfaces
39 - Bluetooth 5.2 LE Radio
41 …- Dedicated, Ultra-Low-Power, 32-Bit RISC-V Coprocessor to Offload Timing-Critical Bluetooth Proce…
42 - Fully Open-Source Bluetooth 5.2 Stack Available
43 - Supports AoA, AoD, LE Audio, and Mesh
44 - High-Throughput (2Mbps) Mode
45 - Long-Range (125kbps and 500kbps) Modes
46 - Rx Sensitivity: -97.5dBm; Tx Power: +4.5dBm
47 - Single-Ended Antenna Connection (50Ω)
49 - Multiple Peripherals for System Control
51 - 16-Channel DMA
52 - Up To Five Quad SPI Master (60MHz)/Slave (48MHz)
53 - Up To Four 1Mbaud UARTs with Flow Control
54 - Up To Two 1MHz I2C Master/Slave
55 - I2S Master/Slave
56 - Eight External Channel, 12-bit 1MSPS SAR ADC w/ on-die temperature sensor
57 - USB 2.0 Hi-Speed Device
58 - 16 Pulse Train Engines
59 - Up To Six 32-Bit Timers with 8mA High Drive
60 - Up To Two CAN 2.0 Controllers
61 - Up To Four Micro-Power Comparators
62 - 1-Wire Master
64 - Security and Integrity
66 - ChipDNA Physically Un-clonable Function (PUF)
67 - Modular Arithmetic Accelerator (MAA), True Random Number Generator (TRNG)
68 - Secure Nonvolatile Key Storage, SHA-256, AES-128/192/256
69 - Secure Boot ROM
71 - External devices connected to the MAX32690EVKIT:
73 - Bluetooth SMA Connector with a Hinged 2.4GHz Whip Antenna
74 - 3-Pin Terminal Block for CAN Bus 2.0
75 - Selectable On-Board High-Precision Voltage Reference
76 - On-Board HyperRAM
77 - Stereo Audio Codec with Line-In and Line-Out 3.5mm Jacks
78 - 128 x 128 (1.45in) Color TFT Display
79 - USB 2.0 Micro-B Interface to the MAX32690
80 - USB 2.0 Micro-B to Serial UART
81 - Board Power Provided by either USB Port
82 - Jumpers to Enable Optional Pull-Up Resistors on I2C port
83 - All GPIOs Signals Accessed through 0.1in Headers
84 - Three Analog Inputs Accessed through 0.1in Headers with Optional Filtering
85 - SWD 10-Pin Header
86 - On-Board 3.3V, 1.8V, and 1.1V LDO Regulators
87 - Individual Power Measurement on All IC Rails through Jumpers
88 - Two General-Purpose LEDs and One GeneralPurpose Push Button Switch
96 +-----------+------------+-------------------------------------+
99 | NVIC | on-chip | nested vector interrupt controller |
100 +-----------+------------+-------------------------------------+
101 | SYSTICK | on-chip | systick |
102 +-----------+------------+-------------------------------------+
103 | CLOCK | on-chip | clock and reset control |
104 +-----------+------------+-------------------------------------+
105 | GPIO | on-chip | gpio |
106 +-----------+------------+-------------------------------------+
107 | UART | on-chip | serial |
108 +-----------+------------+-------------------------------------+
109 | SPI | on-chip | spi |
110 +-----------+------------+-------------------------------------+
111 | I2C | on-chip | i2c |
112 +-----------+------------+-------------------------------------+
113 | TRNG | on-chip | entropy |
114 +-----------+------------+-------------------------------------+
115 | DMA | on-chip | dma controller |
116 +-----------+------------+-------------------------------------+
117 | Watchdog | on-chip | watchdog |
118 +-----------+------------+-------------------------------------+
119 | ADC | on-chip | adc |
120 +-----------+------------+-------------------------------------+
121 | Timer | on-chip | counter |
122 +-----------+------------+-------------------------------------+
123 | PWM | on-chip | pwm |
124 +-----------+------------+-------------------------------------+
125 | W1 | on-chip | one wire master |
126 +-----------+------------+-------------------------------------+
127 | Flash | on-chip | flash |
128 +-----------+------------+-------------------------------------+
134 +-----------+---------------+---------------+------------------------------------------------------…
138 … | | +-----------+ | +-----------------------------------------------------…
139 | | | | 1-2 | | | Connects external voltage reference to VREF pin, m…
140 … | | +-----------+ | +-----------------------------------------------------…
142 … | | +-----------+ | +-----------------------------------------------------…
144 +-----------+---------------+---------------+------------------------------------------------------…
145 …P2 | I2C0 PU | +-----------+ | +-----------------------------------------------------…
146 | | | | 2-1 | | | Connects VDDIO (1V8) to I2C0 pull-up resistors. …
147 … | | +-----------+ | +-----------------------------------------------------…
148 | | | | 2-3 | | | Connects VDDIOH (3V3) to I2C0 pull-up resistors. …
149 … | | +-----------+ | +-----------------------------------------------------…
150 | | | | Open | | | Disconnects power from I2C0 pull-up resistors. …
151 … | | +-----------+ | +-----------------------------------------------------…
153 +-----------+---------------+---------------+------------------------------------------------------…
154 …P3 | I2C0_SDA_PU | +-----------+ | +-----------------------------------------------------…
155 | | | | 1-2 | | | Connects pull-up to I2C0A_SDA (P2.7) sourced by I2…
156 … | | +-----------+ | +-----------------------------------------------------…
157 | | | | Open | | | Disconnects pull-up from I2C0A_SDA (P2.7) sourced …
158 … | | +-----------+ | +-----------------------------------------------------…
160 +-----------+---------------+---------------+------------------------------------------------------…
161 …P4 | I2C0_SCL_PU | +-----------+ | +-----------------------------------------------------…
162 | | | | 1-2 | | | Connects pull-up to I2C0A_SCL (P2.8) sourced by I2…
163 … | | +-----------+ | +-----------------------------------------------------…
164 | | | | Open | | | Disconnects pull-up from I2C0A_SCL (P2.8) sourced …
165 … | | +-----------+ | +-----------------------------------------------------…
167 +-----------+---------------+---------------+------------------------------------------------------…
168 …P5 | LED0 EN | +-----------+ | +-----------------------------------------------------…
169 | | | | 1-2 | | | Connects red LED D1 to P0.14. …
170 … | | +-----------+ | +-----------------------------------------------------…
172 … | | +-----------+ | +-----------------------------------------------------…
174 +-----------+---------------+---------------+------------------------------------------------------…
175 …P6 | LED1 EN | +-----------+ | +-----------------------------------------------------…
176 | | | | 1-2 | | | Connects green LED D2 to P2.12. …
177 … | | +-----------+ | +-----------------------------------------------------…
179 … | | +-----------+ | +-----------------------------------------------------…
181 +-----------+---------------+---------------+------------------------------------------------------…
182 …P7 | RX EN | +-----------+ | +-----------------------------------------------------…
183 | | | | 1-2 | | | Connects the USB - serial bridge to UART2A_RX (P1…
184 … | | +-----------+ | +-----------------------------------------------------…
185 | | | | Open | | | Disconnects the USB - serial bridge from UART2A_R…
186 … | | +-----------+ | +-----------------------------------------------------…
188 +-----------+---------------+---------------+------------------------------------------------------…
189 …P8 | TX EN | +-----------+ | +-----------------------------------------------------…
190 | | | | 1-2 | | | Connects the USB - serial bridge to UART2A_TX (P1…
191 … | | +-----------+ | +-----------------------------------------------------…
192 | | | | Open | | | Disconnects the USB - serial bridge from UART2A_T…
193 … | | +-----------+ | +-----------------------------------------------------…
195 +-----------+---------------+---------------+------------------------------------------------------…
196 …P9 | P1_7 SEL | +-----------+ | +-----------------------------------------------------…
197 | | | | 2-1 | | | Connects the USB - serial bridge to UART2A_CTS (P…
198 … | | +-----------+ | +-----------------------------------------------------…
199 | | | | 2-3 | | | Connects I2C2C_SDA (P1.7) to the codec. …
200 … | | +-----------+ | +-----------------------------------------------------…
202 +-----------+---------------+---------------+------------------------------------------------------…
203 …P10 | P1_8 SEL | +-----------+ | +-----------------------------------------------------…
204 | | | | 2-1 | | | Connects the USB - serial bridge to UART2A_RTS (P…
205 … | | +-----------+ | +-----------------------------------------------------…
206 | | | | 2-3 | | | Connects I2C2C_SCL (P1.8) to the codec. …
207 … | | +-----------+ | +-----------------------------------------------------…
209 +-----------+---------------+---------------+------------------------------------------------------…
210 …P11 | V_AUX SEL | +-----------+ | +-----------------------------------------------------…
211 | | | | 2-1 | | | Connects V_AUX to 1V8. …
212 … | | +-----------+ | +-----------------------------------------------------…
213 | | | | 2-3 | | | Connects V_AUX to 3V3. …
214 … | | +-----------+ | +-----------------------------------------------------…
216 +-----------+---------------+---------------+------------------------------------------------------…
217 …P12 | VDD3A EN | +-----------+ | +-----------------------------------------------------…
218 | | | | 1-2 | | | Connects 3V3 to VDD3A. …
219 … | | +-----------+ | +-----------------------------------------------------…
221 … | | +-----------+ | +-----------------------------------------------------…
223 +-----------+---------------+---------------+------------------------------------------------------…
224 …P13 | VDDIOH EN | +-----------+ | +-----------------------------------------------------…
225 | | | | 1-2 | | | Connects 3V3 to VDDIOH. …
226 … | | +-----------+ | +-----------------------------------------------------…
228 … | | +-----------+ | +-----------------------------------------------------…
230 +-----------+---------------+---------------+------------------------------------------------------…
231 …P14 | VDDB EN | +-----------+ | +-----------------------------------------------------…
232 | | | | 1-2 | | | Connects a 3V3 LDO sourced by USB_VBUS (CN1) to VD…
233 … | | +-----------+ | +-----------------------------------------------------…
235 … | | +-----------+ | +-----------------------------------------------------…
237 +-----------+---------------+---------------+------------------------------------------------------…
238 …P15 | VDDA EN | +-----------+ | +-----------------------------------------------------…
239 | | | | 1-2 | | | Connects 1V8 to VDDA. …
240 … | | +-----------+ | +-----------------------------------------------------…
242 … | | +-----------+ | +-----------------------------------------------------…
244 +-----------+---------------+---------------+------------------------------------------------------…
245 …P16 | VDDIO EN | +-----------+ | +-----------------------------------------------------…
246 | | | | 1-2 | | | Connects 1V8 to VDDIO. …
247 … | | +-----------+ | +-----------------------------------------------------…
249 … | | +-----------+ | +-----------------------------------------------------…
251 +-----------+---------------+---------------+------------------------------------------------------…
252 …P17 | VCORE EN | +-----------+ | +-----------------------------------------------------…
253 | | | | 1-2 | | | Connects 1V1 to VCORE. …
254 … | | +-----------+ | +-----------------------------------------------------…
256 … | | +-----------+ | +-----------------------------------------------------…
258 +-----------+---------------+---------------+------------------------------------------------------…
259 …P18 | BLE LDO EN | +-----------+ | +-----------------------------------------------------…
260 | | | | 1-2 | | | Connects 1V4 to BLE_LDO. …
261 … | | +-----------+ | +-----------------------------------------------------…
263 … | | +-----------+ | +-----------------------------------------------------…
265 +-----------+---------------+---------------+------------------------------------------------------…
266 …H6 | ANALOG PORT3 | +-----------+ | +-----------------------------------------------------…
267 | | | | 1-2 | | | Connects LPUART0B_RX (P3.0) to the SWD connector. …
268 … | | +-----------+ | +-----------------------------------------------------…
269 | | | | 3-4 | | | Connects LPUART0B_TX (P3.1) to the SWD connector. …
270 … | | +-----------+ | +-----------------------------------------------------…
272 … | | +-----------+ | +-----------------------------------------------------…
274 +-----------+---------------+---------------+------------------------------------------------------…
283 SWD port. SWD debug can be accessed through the Cortex 10-pin connector, J3.
292 a Segger J-Link with Segger's native tooling by overriding the runner,
293 appending ``--runner jlink`` to your ``west`` command(s). The J-Link should
306 - `MAX32690EVKIT web page`_
309 …https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/MA…