1#
2# Controller Area Network (CAN) network layer core configuration
3#
4
5menuconfig CAN
6	depends on NET
7	tristate "CAN bus subsystem support"
8	---help---
9	  Controller Area Network (CAN) is a slow (up to 1Mbit/s) serial
10	  communications protocol which was developed by Bosch in
11	  1991, mainly for automotive, but now widely used in marine
12	  (NMEA2000), industrial, and medical applications.
13	  More information on the CAN network protocol family PF_CAN
14	  is contained in <Documentation/networking/can.rst>.
15
16	  If you want CAN support you should say Y here and also to the
17	  specific driver for your controller(s) below.
18
19if CAN
20
21config CAN_RAW
22	tristate "Raw CAN Protocol (raw access with CAN-ID filtering)"
23	default y
24	---help---
25	  The raw CAN protocol option offers access to the CAN bus via
26	  the BSD socket API. You probably want to use the raw socket in
27	  most cases where no higher level protocol is being used. The raw
28	  socket has several filter options e.g. ID masking / error frames.
29	  To receive/send raw CAN messages, use AF_CAN with protocol CAN_RAW.
30
31config CAN_BCM
32	tristate "Broadcast Manager CAN Protocol (with content filtering)"
33	default y
34	---help---
35	  The Broadcast Manager offers content filtering, timeout monitoring,
36	  sending of RTR frames, and cyclic CAN messages without permanent user
37	  interaction. The BCM can be 'programmed' via the BSD socket API and
38	  informs you on demand e.g. only on content updates / timeouts.
39	  You probably want to use the bcm socket in most cases where cyclic
40	  CAN messages are used on the bus (e.g. in automotive environments).
41	  To use the Broadcast Manager, use AF_CAN with protocol CAN_BCM.
42
43config CAN_GW
44	tristate "CAN Gateway/Router (with netlink configuration)"
45	default y
46	---help---
47	  The CAN Gateway/Router is used to route (and modify) CAN frames.
48	  It is based on the PF_CAN core infrastructure for msg filtering and
49	  msg sending and can optionally modify routed CAN frames on the fly.
50	  CAN frames can be routed between CAN network interfaces (one hop).
51	  They can be modified with AND/OR/XOR/SET operations as configured
52	  by the netlink configuration interface known e.g. from iptables.
53
54source "drivers/net/can/Kconfig"
55
56endif
57