Home
last modified time | relevance | path

Searched refs:VP (Results 1 – 25 of 25) sorted by relevance

/Linux-v6.6/Documentation/devicetree/bindings/media/i2c/
Dtda1997x.txt24 pairs which map a chip-specific VP output register to a 4-bit pin group. If
36 - nxp,vidout-portcfg : array of pairs mapping VP output pins to pin groups.
57 - VP[15:0] connected to IMX6 CSI_DATA[19:4] for 16bit YUV422
80 /* Y[11:8]<->VP[15:12]<->CSI_DATA[19:16] */
82 /* Y[7:4]<->VP[11:08]<->CSI_DATA[15:12] */
84 /* CbCc[11:8]<->VP[07:04]<->CSI_DATA[11:8] */
86 /* CbCr[7:4]<->VP[03:00]<->CSI_DATA[7:4] */
99 - VP[15:8] connected to IMX6 CSI_DATA[19:12] for 8bit BT656
122 /* Y[11:8]<->VP[15:12]<->CSI_DATA[19:16] */
124 /* Y[7:4]<->VP[11:08]<->CSI_DATA[15:12] */
[all …]
/Linux-v6.6/Documentation/devicetree/bindings/sound/
Dcs35l32.txt10 - VA-supply, VP-supply : power supplies for the device,
23 if LEDs are OFF (VBST = VP).
24 2 = (Default) Boost voltage fixed in Bypass Mode (VBST = VP).
39 - cirrus,battery-recovery : Low battery nominal recovery threshold, rising VP.
45 - cirrus,battery-threshold : Low battery nominal threshold, falling VP.
Dcs35l36.txt9 - VA-supply, VP-supply : power supplies for the device,
16 (Default) VP
110 - cirrus,vpbr-thld : Initial VPBR threshold. Configures the VP brownout
115 condition is present and the VP brownout condition is in an attacking state.
117 - cirrus,vpbr-atk-vol : VP brownout prevention step size. Configures the VP
121 - cirrus,vpbr-max-attn : Maximum attenuation that the VP brownout prevention
125 no longer being present and the VP brownout prevention entering an attenuation
130 is not longer present and the VP brownout is in an attenuation release state.
142 VP-supply = <&dummy_vreg>;
Dcs53l30.txt9 - VA-supply, VP-supply : power supplies for the device,
43 VP-supply = <&cs53l30_vp>;
Dcs43130.txt10 - VA-supply, VP-supply, VL-supply, VCP-supply, VD-supply:
56 VP-supply = <&dummy_vreg>;
Dcs35l33.txt9 - VA-supply, VP-supply : power supplies for the device,
22 0, then VBST = VP. If greater than 0, the boost voltage will be 3300mV with
79 reference to the VP voltage for when to start generating a boosted VBST.
101 VP-supply = <&ldo5_reg>;
Dcs35l34.txt9 - VA-supply, VP-supply : power supplies for the device,
14 converter's output voltage in mV. The range is from VP to 8V with
Dcs35l35.txt9 - VA-supply, VP-supply : power supplies for the device,
58 (Default) VP
100 Section 7.34 Class H VP Control
146 VP-supply = <&dummy_vreg>;
/Linux-v6.6/arch/arm/boot/dts/nxp/imx/
Dimx6q-gw54xx.dts68 * which we map to VP[15:08]<->CSI_DATA[19:12]
71 /*G_Y_11_8<->VP[15:12]<->CSI_DATA[19:16]*/
73 /*G_Y_7_4<->VP[11:08]<->CSI_DATA[15:12]*/
75 /*R_CR_CBCR_11_8<->VP[07:04]<->CSI_DATA[11:08]*/
77 /*R_CR_CBCR_7_4<->VP[03:00]<->CSI_DATA[07:04]*/
Dimx6qdl-gw551x.dtsi459 * which we map to VP[15:08]<->CSI_DATA[19:12]
462 /*G_Y_11_8<->VP[15:12]<->CSI_DATA[19:16]*/
464 /*G_Y_7_4<->VP[11:08]<->CSI_DATA[15:12]*/
466 /*R_CR_CBCR_11_8<->VP[07:04]<->CSI_DATA[11:08]*/
468 /*R_CR_CBCR_7_4<->VP[03:00]<->CSI_DATA[07:04]*/
/Linux-v6.6/drivers/media/pci/cx88/
DKconfig76 bool "VP-3054 Secondary I2C Bus Support"
82 which also require support for the VP-3054
/Linux-v6.6/Documentation/hwmon/
Dltc2947.rst41 in0_input VP-VM voltage (mV).
49 in0_label Channel label (VP-VM)
/Linux-v6.6/Documentation/virt/kvm/devices/
Dxive.rst210 The XIVE IC maintains VP interrupt state in an internal structure
211 called the NVT. When a VP is not dispatched on a HW processor
212 thread, this structure can be updated by HW if the VP is the target
/Linux-v6.6/Documentation/devicetree/bindings/iio/adc/
Dxilinx-xadc.txt47 0: VP/VN
74 0: VP/VN
/Linux-v6.6/arch/arm64/boot/dts/ti/
Dk3-j721e-beagleboneai64.dts796 assigned-clocks = <&k3_clks 152 1>, /* VP 1 pixel clock */
797 <&k3_clks 152 4>, /* VP 2 pixel clock */
798 <&k3_clks 152 9>, /* VP 3 pixel clock */
799 <&k3_clks 152 13>; /* VP 4 pixel clock */
Dk3-j721e-sk.dts853 assigned-clocks = <&k3_clks 152 1>, /* VP 1 pixel clock */
854 <&k3_clks 152 4>, /* VP 2 pixel clock */
855 <&k3_clks 152 9>, /* VP 3 pixel clock */
856 <&k3_clks 152 13>; /* VP 4 pixel clock */
/Linux-v6.6/Documentation/admin-guide/media/
Dcx88-cardlist.rst358 - Twinhan VP-1027 DVB-S
Dbttv.rst709 - DTV3000 PV-DTV3000P+ DVB-S CI = Twinhan VP-1030
710 - DTV2000 DVB-S = Twinhan VP-1020
853 - Face to Face Capture (Bt848 capture only) (PCB "VP-2848")
854 - Face To Face TV MAX (Bt848) (PCB "VP-8482 Rev1.3")
855 - Genie TV (Bt878) (PCB "VP-8790 Rev 2.1")
1555 - DST Card/DST-IP (bt878, twinhan asic) VP-1020
1563 - DST-CI Card (DVB Satellite) VP-1030
1608 TV-Mate = Zoltrix VP-8482
1632 TV-Karte / Poso Power TV (?) = Zoltrix VP-8482 (?)
/Linux-v6.6/Documentation/process/
Dcontribution-maturity-model.rst79 (e.g., all people reporting up to a manager, director, or VP).
/Linux-v6.6/drivers/gpu/drm/nouveau/nvkm/engine/fifo/
Dbase.c202 CASE(VP ); in nvkm_fifo_info()
/Linux-v6.6/drivers/media/usb/dvb-usb/
DKconfig341 TwinhanDTV Alpha (stick) (VP-7045),
342 TwinhanDTV MagicBox II (VP-7046),
/Linux-v6.6/Documentation/arch/x86/
Dtdx.rst116 #VE handler before it reads the #VE info structure (TDG.VP.VEINFO.GET).
161 TDG.VP.VEINFO.GET TDCALL. This allows the guest to control when interrupts
/Linux-v6.6/Documentation/trace/
Dftrace.rst939 # latency: 259 us, #4/4, CPU#2 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
976 VP, KP, SP, and HP are always zero and are reserved for later use.
1430 # latency: 16 us, #4/4, CPU#0 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
1481 # latency: 71 us, #168/168, CPU#3 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
1559 # latency: 3751 us, #274/274, CPU#0 | (M:desktop VP:0, KP:0, SP:0 HP:0 #P:4)
1629 # latency: 46 us, #4/4, CPU#1 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
1667 # latency: 83 us, #241/241, CPU#1 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
1781 # latency: 100 us, #4/4, CPU#3 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
1834 # latency: 161 us, #339/339, CPU#3 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
1950 # latency: 15 us, #4/4, CPU#3 | (M:preempt VP:0, KP:0, SP:0 HP:0 #P:4)
[all …]
/Linux-v6.6/drivers/net/wireless/intel/ipw2x00/
Dipw2200.c45 #define VP "p" macro
47 #define VP macro
62 #define IPW2200_VERSION "1.2.2" VK VD VM VP VR VQ
/Linux-v6.6/drivers/eisa/
Deisa.ids688 ICU06C0 "Zoom VP V.32bis Modem"