Searched refs:compensate (Results 1 – 25 of 39) sorted by relevance
12
24 compensate the DC offset for each L and R channel, and they are different38 should compensate different DC offset to avoid the pop sound, and it is
34 to compensate for long antenna cables.
296 - With this setting the camera will compensate for fluorescent H305 - With this setting the camera will compensate for the flash light.405 compensate, this mode automatically slightly overexposes the406 frames. The white balance may also be adjusted to compensate for543 captured to memory to compensate for the camera sensor mounting rotation.574 The camera is typically mounted upside-down to compensate the lens optical579 If the camera sensor is not mounted upside-down it is required to compensate620 aligned to the device longer side, upside-down mounted to compensate for
12 by 1000) to compensate, e.g. 1300=1.3x and 750=0.75x.
26 board, or to compensate for external influences.
72 And it's commonly used to compensate the illuminance for the camera
7 signals - can compensate the drift between the two ws signal.
25 | Set the sign according to SE. Subtract 16 to compensate127 | 4. Subtract 16 to compensate for interpreting the mant as all integer digits.
51 # we compensate with load offsets of 4
33 will also use IRQ stacks to compensate for the reduced stackspace.
111 IBM Trackpoints have a feature to compensate for drift by
131 controller. This term allows the PID controller to compensate
44 - st,tx-impedance-comp : to compensate tx impedance avoiding out of range values.
129 compensate and report the real temperature.
130 Both have special circuitry to compensate for PWM interactions with the278 the temperatures to compensate for systemic errors in the
154 internally, you will have to compensate in sensors.conf. Others (in0 to in6)
979 bool compensate, enum bfqq_expiration reason);
4135 bool compensate, enum bfqq_expiration reason, in bfq_bfqq_is_slow() argument4145 if (compensate) in bfq_bfqq_is_slow()4322 bool compensate, in bfq_bfqq_expire() argument4332 slow = bfq_bfqq_is_slow(bfqd, bfqq, compensate, reason, &delta); in bfq_bfqq_expire()
190 compensate by performing a -30 degrees rotation around the X axis:
256 * 5.3V instead of 5.0V to compensate
519 where host load or guest lag is too much to compensate for, and thus another521 ticks and compensate for them internally. Although promising in theory, the626 compensate for slower I/O to and from devices. The first issue is not solvable
86 ;* is shifted shifted backup immediately. This is to compensate
166 allows the PID controller to compensate for long term drift and for
182 /* Use low frequency to compensate for the high pull-up values. */
77 seconds, the code handling the clock source will have to compensate for this.
