| /Linux-v5.4/net/tls/ |
| D | tls_main.c | 72 sk->sk_prot = &tls_prots[ip_ver][ctx->tx_conf][ctx->rx_conf]; in update_sk_prot()
294 if (ctx->rx_conf == TLS_SW) in tls_sk_proto_cleanup()
296 else if (ctx->rx_conf == TLS_HW) in tls_sk_proto_cleanup()
311 free_ctx = ctx->tx_conf != TLS_HW && ctx->rx_conf != TLS_HW; in tls_sk_proto_close()
313 if (ctx->tx_conf != TLS_BASE || ctx->rx_conf != TLS_BASE) in tls_sk_proto_close()
326 if (ctx->rx_conf == TLS_SW || ctx->rx_conf == TLS_HW) in tls_sk_proto_close()
328 if (ctx->rx_conf == TLS_SW) in tls_sk_proto_close()
559 ctx->rx_conf = conf; in do_tls_setsockopt_conf()
676 ctx->rx_conf = TLS_HW_RECORD; in tls_hw_prot()
803 ctx->rx_conf = TLS_BASE; in tls_init()
|
| D | tls_device.c | 61 if (ctx->rx_conf == TLS_HW) in tls_device_free_ctx()
669 if (tls_ctx->rx_conf != TLS_HW) in tls_device_rx_resync_new_rec()
1175 if (ctx->rx_conf == TLS_HW) in tls_device_down()
|
| D | tls_sw.c | 1494 if (tls_ctx->rx_conf == TLS_HW) { in decrypt_skb_update()
|
| /Linux-v5.4/drivers/spi/ |
| D | spi-pl022.c | 919 struct dma_slave_config rx_conf = { in configure_dma() local
949 rx_conf.src_maxburst = 1; in configure_dma()
952 rx_conf.src_maxburst = 4; in configure_dma()
955 rx_conf.src_maxburst = 8; in configure_dma()
958 rx_conf.src_maxburst = 16; in configure_dma()
961 rx_conf.src_maxburst = 32; in configure_dma()
964 rx_conf.src_maxburst = pl022->vendor->fifodepth >> 1; in configure_dma()
992 rx_conf.src_addr_width = DMA_SLAVE_BUSWIDTH_UNDEFINED; in configure_dma()
995 rx_conf.src_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE; in configure_dma()
998 rx_conf.src_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES; in configure_dma()
[all …]
|
| D | spi-qup.c | 150 struct dma_slave_config rx_conf; member
929 struct dma_slave_config *rx_conf = &spi->rx_conf, in spi_qup_init_dma() local
946 rx_conf->direction = DMA_DEV_TO_MEM; in spi_qup_init_dma()
947 rx_conf->device_fc = 1; in spi_qup_init_dma()
948 rx_conf->src_addr = base + QUP_INPUT_FIFO; in spi_qup_init_dma()
949 rx_conf->src_maxburst = spi->in_blk_sz; in spi_qup_init_dma()
956 ret = dmaengine_slave_config(master->dma_rx, rx_conf); in spi_qup_init_dma()
|
| /Linux-v5.4/drivers/net/wireless/ti/wlcore/ |
| D | acx.c | 1030 struct wl1271_acx_rx_config_opt *rx_conf; in wl1271_acx_init_rx_interrupt() local
1035 rx_conf = kzalloc(sizeof(*rx_conf), GFP_KERNEL); in wl1271_acx_init_rx_interrupt()
1036 if (!rx_conf) { in wl1271_acx_init_rx_interrupt()
1041 rx_conf->threshold = cpu_to_le16(wl->conf.rx.irq_pkt_threshold); in wl1271_acx_init_rx_interrupt()
1042 rx_conf->timeout = cpu_to_le16(wl->conf.rx.irq_timeout); in wl1271_acx_init_rx_interrupt()
1043 rx_conf->mblk_threshold = cpu_to_le16(wl->conf.rx.irq_blk_threshold); in wl1271_acx_init_rx_interrupt()
1044 rx_conf->queue_type = wl->conf.rx.queue_type; in wl1271_acx_init_rx_interrupt()
1046 ret = wl1271_cmd_configure(wl, ACX_RX_CONFIG_OPT, rx_conf, in wl1271_acx_init_rx_interrupt()
1047 sizeof(*rx_conf)); in wl1271_acx_init_rx_interrupt()
1054 kfree(rx_conf); in wl1271_acx_init_rx_interrupt()
|
| /Linux-v5.4/drivers/net/wireless/realtek/rtl818x/rtl8180/ |
| D | dev.c | 1177 priv->rx_conf = reg; in rtl8180_start()
1576 priv->rx_conf ^= RTL818X_RX_CONF_FCS; in rtl8180_configure_filter()
1578 priv->rx_conf ^= RTL818X_RX_CONF_CTRL; in rtl8180_configure_filter()
1580 priv->rx_conf ^= RTL818X_RX_CONF_MONITOR; in rtl8180_configure_filter()
1582 priv->rx_conf |= RTL818X_RX_CONF_MULTICAST; in rtl8180_configure_filter()
1584 priv->rx_conf &= ~RTL818X_RX_CONF_MULTICAST; in rtl8180_configure_filter()
1588 if (priv->rx_conf & RTL818X_RX_CONF_FCS) in rtl8180_configure_filter()
1590 if (priv->rx_conf & RTL818X_RX_CONF_CTRL) in rtl8180_configure_filter()
1592 if (priv->rx_conf & RTL818X_RX_CONF_MONITOR) in rtl8180_configure_filter()
1594 if (priv->rx_conf & RTL818X_RX_CONF_MULTICAST) in rtl8180_configure_filter()
[all …]
|
| D | rtl8180.h | 124 u32 rx_conf; member
|
| /Linux-v5.4/drivers/net/wireless/realtek/rtl818x/rtl8187/ |
| D | dev.c | 949 priv->rx_conf = reg; in rtl8187_start()
992 priv->rx_conf = reg; in rtl8187_start()
1317 priv->rx_conf ^= RTL818X_RX_CONF_FCS; in rtl8187_configure_filter()
1319 priv->rx_conf ^= RTL818X_RX_CONF_CTRL; in rtl8187_configure_filter()
1322 priv->rx_conf |= RTL818X_RX_CONF_MONITOR; in rtl8187_configure_filter()
1324 priv->rx_conf &= ~RTL818X_RX_CONF_MONITOR; in rtl8187_configure_filter()
1328 if (priv->rx_conf & RTL818X_RX_CONF_FCS) in rtl8187_configure_filter()
1330 if (priv->rx_conf & RTL818X_RX_CONF_CTRL) in rtl8187_configure_filter()
1332 if (priv->rx_conf & RTL818X_RX_CONF_MONITOR) { in rtl8187_configure_filter()
1337 rtl818x_iowrite32_async(priv, &priv->map->RX_CONF, priv->rx_conf); in rtl8187_configure_filter()
|
| D | rtl8187.h | 115 u32 rx_conf; member
|
| /Linux-v5.4/drivers/tty/serial/ |
| D | samsung.h | 47 struct dma_slave_config rx_conf; member
|
| D | samsung.c | 864 dma->rx_conf.direction = DMA_DEV_TO_MEM; in s3c24xx_serial_request_dma()
865 dma->rx_conf.src_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE; in s3c24xx_serial_request_dma()
866 dma->rx_conf.src_addr = p->port.mapbase + S3C2410_URXH; in s3c24xx_serial_request_dma()
867 dma->rx_conf.src_maxburst = 1; in s3c24xx_serial_request_dma()
890 dmaengine_slave_config(dma->rx_chan, &dma->rx_conf); in s3c24xx_serial_request_dma()
|
| D | amba-pl011.c | 461 struct dma_slave_config rx_conf = { in pl011_dma_probe() local
485 dmaengine_slave_config(chan, &rx_conf); in pl011_dma_probe()
|
| /Linux-v5.4/drivers/net/wireless/realtek/rtlwifi/ |
| D | core.c | 810 mac->rx_conf |= rtlpriv->cfg->maps[MAC_RCR_AM] | in rtl_op_configure_filter()
815 mac->rx_conf &= ~(rtlpriv->cfg->maps[MAC_RCR_AM] | in rtl_op_configure_filter()
825 mac->rx_conf |= rtlpriv->cfg->maps[MAC_RCR_ACRC32]; in rtl_op_configure_filter()
829 mac->rx_conf &= ~rtlpriv->cfg->maps[MAC_RCR_ACRC32]; in rtl_op_configure_filter()
856 mac->rx_conf |= rtlpriv->cfg->maps[MAC_RCR_ACF]; in rtl_op_configure_filter()
861 mac->rx_conf &= ~rtlpriv->cfg->maps[MAC_RCR_ACF]; in rtl_op_configure_filter()
871 mac->rx_conf |= rtlpriv->cfg->maps[MAC_RCR_AAP]; in rtl_op_configure_filter()
875 mac->rx_conf &= ~rtlpriv->cfg->maps[MAC_RCR_AAP]; in rtl_op_configure_filter()
885 (u8 *)(&mac->rx_conf)); in rtl_op_configure_filter()
|
| D | base.c | 590 rtlpriv->cfg->ops->get_hw_reg(hw, HW_VAR_RCR, (u8 *) (&mac->rx_conf)); in rtl_init_rx_config()
|
| D | wifi.h | 1503 u32 rx_conf; member
|
| /Linux-v5.4/include/net/ |
| D | tls.h | 254 u8 rx_conf:3; member
429 u16 config = tx ? ctx->tx_conf : ctx->rx_conf; in tls_user_config()
|
| /Linux-v5.4/drivers/net/wireless/realtek/rtlwifi/rtl8192cu/ |
| D | hw.c | 1479 *((u32 *)(val)) = mac->rx_conf; in rtl92cu_get_hw_reg()
1770 mac->rx_conf = ((u32 *) (val))[0]; in rtl92cu_set_hw_reg()
1772 "### Set RCR(0x%08x) ###\n", mac->rx_conf); in rtl92cu_set_hw_reg()
|
