| /Linux-v5.4/drivers/staging/iio/cdc/ |
| D | ad7150.c | 179 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_params() local
190 value = chip->threshold[rising][chan]; in ad7150_write_event_params()
195 sens = chip->mag_sensitivity[rising][chan]; in ad7150_write_event_params()
196 timeout = chip->mag_timeout[rising][chan]; in ad7150_write_event_params()
199 sens = chip->thresh_sensitivity[rising][chan]; in ad7150_write_event_params()
200 timeout = chip->thresh_timeout[rising][chan]; in ad7150_write_event_params()
223 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_config() local
243 if (rising) in ad7150_write_event_config()
250 if (rising) in ad7150_write_event_config()
257 if (rising) in ad7150_write_event_config()
[all …]
|
| /Linux-v5.4/drivers/staging/comedi/drivers/ |
| D | ni_6527.c | 273 unsigned int rising, in ni6527_set_edge_detection() argument
278 rising &= mask; in ni6527_set_edge_detection()
284 rising |= readb(dev->mmio + in ni6527_set_edge_detection()
293 writeb(rising & 0xff, in ni6527_set_edge_detection()
299 rising >>= 8; in ni6527_set_edge_detection()
311 unsigned int rising, falling, shift; in ni6527_intr_insn_config() local
318 rising = data[1]; in ni6527_intr_insn_config()
320 ni6527_set_edge_detection(dev, mask, rising, falling); in ni6527_intr_insn_config()
329 rising = 0; in ni6527_intr_insn_config()
337 rising = 0; in ni6527_intr_insn_config()
[all …]
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-timer-stm32 | 23 OC4REF rising or falling edges generate pulses.
25 OC6REF rising or falling edges generate pulses.
27 OC4REF or OC6REF rising edges generate pulses.
29 OC4REF rising or OC6REF falling edges generate pulses.
31 OC5REF or OC6REF rising edges generate pulses.
33 OC5REF rising or OC6REF falling edges generate pulses.
115 Counting is enabled on rising edge of the connected
132 rising edges.
|
| D | sysfs-bus-iio-adc-hi8435 | 25 If falling threshold results hysteresis to odd value then rising
34 this value then the threshold rising event is pushed.
42 If rising threshold results hysteresis to odd value then falling
|
| D | sysfs-bus-iio-light-lm3533-als | 7 in each direction (rising|falling) and a zone change occurs.
42 in_illuminance0_threshY_{falling,rising} thresholds.
|
| D | sysfs-bus-iio-adc-stm32 | 8 - "rising-edge"
|
| /Linux-v5.4/Documentation/devicetree/bindings/input/ |
| D | st,stpmic1-onkey.txt | 7 - interrupt-names = "onkey-falling", "onkey-rising"
9 onkey-rising: happens when onkey is released; IT_PONKEY_R of pmic
26 interrupt-names = "onkey-falling", "onkey-rising";
|
| /Linux-v5.4/drivers/iio/proximity/ |
| D | srf04.c | 63 struct completion rising; member
84 complete(&data->rising); in srf04_handle_irq()
106 reinit_completion(&data->rising); in srf04_read()
114 ret = wait_for_completion_killable_timeout(&data->rising, HZ/50); in srf04_read()
254 init_completion(&data->rising); in srf04_probe()
|
| /Linux-v5.4/drivers/gpio/ |
| D | gpio-mt7621.c | 37 u32 rising; member
122 mtk_gpio_w32(rg, GPIO_REG_REDGE, rise | (BIT(pin) & rg->rising)); in mediatek_gpio_irq_unmask()
159 if ((rg->rising | rg->falling | in mediatek_gpio_irq_type()
166 rg->rising &= ~mask; in mediatek_gpio_irq_type()
173 rg->rising |= mask; in mediatek_gpio_irq_type()
177 rg->rising |= mask; in mediatek_gpio_irq_type()
|
| D | gpio-hlwd.c | 76 u32 level, rising, falling; in hlwd_gpio_irqhandler() local
79 rising = level & emulated_pending; in hlwd_gpio_irqhandler()
90 rising &= hlwd->rising_edge; in hlwd_gpio_irqhandler()
94 pending |= rising | falling; in hlwd_gpio_irqhandler()
|
| D | gpio-pl061.c | 175 bool rising = trigger & IRQ_TYPE_EDGE_RISING; in pl061_irq_type() local
182 if (rising) in pl061_irq_type()
189 rising ? "RISING" : "FALLING"); in pl061_irq_type()
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/panel/ |
| D | display-timing.txt | 30 - active high = drive pixel data on rising edge/
33 sample data on rising edge
36 - active high = drive sync on rising edge/
40 sample sync on rising edge of pixel
|
| /Linux-v5.4/Documentation/devicetree/bindings/net/nfc/ |
| D | nfcmrvl.txt | 22 - i2c-int-rising: Specifies that the chip read event shall be trigged on
23 rising edge.
55 i2c-int-rising;
|
| /Linux-v5.4/Documentation/devicetree/bindings/gpio/ |
| D | gpio-stp-xway.txt | 26 - lantiq,rising : use rising instead of falling edge for the shift register
41 /* lantiq,rising; */
|
| D | cavium-octeon-gpio.txt | 21 1 - edge triggered on the rising edge.
37 * 2) Triggering (1 - edge rising
|
| /Linux-v5.4/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-sapphire-excavator.dts | 157 i2c-scl-rising-time-ns = <300>;
173 i2c-scl-rising-time-ns = <600>;
233 i2c-scl-rising-time-ns = <450>;
|
| D | rk3399-roc-pc.dts | 189 i2c-scl-rising-time-ns = <168>;
416 i2c-scl-rising-time-ns = <300>;
422 i2c-scl-rising-time-ns = <450>;
428 i2c-scl-rising-time-ns = <600>;
445 i2c-scl-rising-time-ns = <600>;
|
| /Linux-v5.4/Documentation/devicetree/bindings/mmc/ |
| D | mtk-sd.txt | 45 - mediatek,hs400-cmd-resp-sel-rising: HS400 command response sample selection
46 If present,HS400 command responses are sampled on rising edges.
71 mediatek,hs400-cmd-resp-sel-rising;
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/adc/ |
| D | st,stm32-dfsdm-adc.txt | 76 - "SPI_R": SPI with data on rising edge (default)
78 - "MANCH_R": manchester codec, rising edge = logic 0, falling edge = logic 1
79 - "MANCH_F": manchester codec, rising edge = logic 1, falling edge = logic 0
84 - "CLKOUT_R": internal SPI clock divided by 2 (rising edge).
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | stm32mp157a-avenger96.dts | 103 i2c-scl-rising-time-ns = <185>;
113 i2c-scl-rising-time-ns = <185>;
123 i2c-scl-rising-time-ns = <185>;
269 interrupt-names = "onkey-falling", "onkey-rising";
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | cs35l34.txt | 44 - cirrus,tdm-rising-edge: Boolean property. If set, data is on the rising edge of
|
| /Linux-v5.4/drivers/net/dsa/mv88e6xxx/ |
| D | ptp.c | 120 int rising) in mv88e6352_config_eventcap() argument
128 if (!rising) in mv88e6352_config_eventcap()
271 int rising = (rq->extts.flags & PTP_RISING_EDGE); in mv88e6352_ptp_enable_extts() local
306 err = mv88e6352_config_eventcap(chip, PTP_CLOCK_EXTTS, rising); in mv88e6352_ptp_enable_extts()
|
| /Linux-v5.4/Documentation/devicetree/bindings/i2c/ |
| D | i2c-rk3x.txt | 36 - i2c-scl-rising-time-ns : Number of nanoseconds the SCL signal takes to rise
66 i2c-scl-rising-time-ns = <800>;
|
| /Linux-v5.4/Documentation/devicetree/bindings/net/ |
| D | qca,qca7000.txt | 17 type as rising edge
50 interrupts = <25 0x1>; /* Index: 25, rising edge */
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/magnetometer/ |
| D | ak8974.txt | 16 The interrupts can be triggered on rising or falling
|
