Searched refs:hooked (Results 1 – 25 of 51) sorted by relevance
123
22 Say Y here if you have ADE7854/58/68/78 hooked to an I2C bus.32 Say Y here if you have ADE7854/58/68/78 hooked to a SPI bus.
4 is hooked up to a pull-up GPIO line and - optionally - the HPD line is5 hooked up to another GPIO line.
13 - no-hpd: If HPD isn't hooked up; add this property.
9 - If the regulator hooked up to a pin like SDMMC0_VDD is 3.3V then10 bit 7 of GRF_IO_VSEL needs to be 0. If the regulator hooked up to15 hooked up to the pins.
17 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
4 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
71 has address 0.0.0.0. Every device that is hooked up to an input of the72 TV has address a.0.0.0 (where 'a' is ≥ 1), devices hooked up to those in
34 * Builtin CD line is hooked to ground to prevent JTAG at boot
166 * NOTE: vcc_sd isn't hooked up on v1.0 boards where power comes from229 disable-wp; /* wp not hooked up */
64 /* The lcd panel i2c interface is hooked up via gpios */
62 /* The lcd panel i2c interface is hooked up via gpios */
150 disable-wp; /* wp not hooked up */
6 various security checks to be hooked by new kernel extensions. The name
61 Say Y here if you have AD7142/AD7147 hooked to an I2C bus.71 Say Y here if you have AD7142/AD7147 hooked to a SPI bus.106 acceleration sensor hooked to an I2C bus.277 hooked to an I2C bus.732 Say Y here if you have ADXL345/6 hooked to an I2C bus.742 Say Y here if you have ADXL345/6 hooked to a SPI bus.
69 These are all hooked together by the machine driver depending on the
232 dr_mode = "host"; /* Force to host until we have Type-C hooked up */
276 dr_mode = "host"; /* Force to host until we have Type-C hooked up */
13 device LEDs should be exposed as LED class devices and hooked up to the
33 we'd assume that the write protect is hooked up directly to the
88 are hooked to this driver through platform_data structure.
512 * hooked to ground. Because we specified "cd-gpios" below dw_mmc758 * In our case the official card detect is hooked to ground
61 wired such that the EHCI debug controller is hooked up to the
73 Those types of devices require different approach to be hooked into Linux kernel.
180 - RESET: Used by I2C-HID, not hooked up in HID core.181 - SET_POWER: Used by I2C-HID, not hooked up in HID core.
27 hooked up to e.g. HDMI connectors. Even though the subdevice will
