| /Linux-v5.4/Documentation/sound/designs/ |
| D | powersave.rst | 5 AC97 and HD-audio drivers have the automatic power-saving mode.
9 With the automatic power-saving, the driver turns off the codec power
15 The time-out for automatic power-off can be specified via ``power_save``
17 the time-out value in seconds. 0 means to disable the automatic
27 automatic power-save mode with 10 seconds, write to
|
| /Linux-v5.4/drivers/net/wireless/intersil/orinoco/ |
| D | hw.h | 30 int orinoco_get_bitratemode(int bitrate, int automatic);
31 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic);
|
| D | hw.c | 30 int automatic; member
430 int orinoco_get_bitratemode(int bitrate, int automatic) in orinoco_get_bitratemode() argument
441 (bitrate_table[i].automatic == automatic)) { in orinoco_get_bitratemode()
449 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic) in orinoco_get_ratemode_cfg() argument
454 *automatic = bitrate_table[ratemode].automatic; in orinoco_get_ratemode_cfg()
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | ext-ctrls-rf-tuner.rst | 47 automatic mode bandwidth configuration is performed by the driver.
57 Enables/disables LNA automatic gain control (AGC)
60 Enables/disables mixer automatic gain control (AGC)
63 Enables/disables IF automatic gain control (AGC)
|
| D | ext-ctrls-camera.rst | 36 Enables automatic adjustments of the exposure time and/or iris
48 - Automatic exposure time, automatic iris aperture.
71 Determines the automatic exposure compensation, it is effective only
159 Enables continuous automatic focus adjustments. The effect of manual
169 Aborts automatic focusing started with ``V4L2_CID_AUTO_FOCUS_START``
177 The automatic focus status. This is a read-only control.
218 - Normal distance range, limited for best automatic focus
278 Sets white balance to automatic, manual or a preset. The presets
358 Enables or disables automatic ISO sensitivity adjustments.
379 This control allows to select scene programs as the camera automatic
[all …]
|
| /Linux-v5.4/net/8021q/ |
| D | Kconfig | 28 automatic propagation of registered VLANs to switches.
38 automatic propagation of registered VLANs to switches; it
|
| /Linux-v5.4/Documentation/hwmon/ |
| D | adt7470.rst | 40 automatic fan pwm control to set the fan speed. The driver will not read the
51 determining an optimal configuration for the automatic PWM control.
93 order for the automatic pwm algorithm to run. This was the case for earlier
|
| D | vt1211.rst | 55 This chip also provides manual and automatic control of fan speeds (according
56 to the datasheet). The driver only supports automatic control since the manual
58 get manual mode to work at all! Be aware that automatic mode hasn't been
177 PWM controller in automatic mode. There is only a single controller that
|
| D | asc7621.rst | 91 Using temperature information from these four zones, an automatic fan speed
204 to the point where the automatic thermal control circuit starts
211 2 Fan on automatic control and will run at the minimum pwm
213 3 Fan on automatic control but will be off if the
|
| D | lm63.rst | 81 PWM modes: manual and automatic. Automatic mode is not fully implemented yet
87 but will return 'old' values. Values in the automatic fan control lookup table
|
| D | dme1737.rst | 175 1-3 can be configured to operate either in manual or automatic mode by setting
179 appropriate PWM attribute. In automatic mode, the PWM attribute returns the
183 In automatic mode, the chip supports the setting of the PWM ramp rate which
312 - 2: automatic mode
321 when the PWM is in automatic mode.
|
| D | emc6w201.rst | 22 "The EMC6W201 is an environmental monitoring device with automatic fan
|
| /Linux-v5.4/drivers/staging/unisys/Documentation/ABI/ |
| D | sysfs-platform-visorchipset | 8 s-Par's automatic installation progress screen when an error
17 Description: used to set the value of the progress bar on the s-Par automatic
27 s-Par's automatic installation progress screen. Setting this
|
| /Linux-v5.4/drivers/net/ethernet/qualcomm/emac/ |
| D | emac-ethtool.c | 174 pause->autoneg = adpt->automatic ? AUTONEG_ENABLE : AUTONEG_DISABLE; in emac_get_pauseparam()
184 adpt->automatic = pause->autoneg == AUTONEG_ENABLE; in emac_set_pauseparam()
|
| /Linux-v5.4/Documentation/devicetree/bindings/serial/ |
| D | uniphier-uart.txt | 10 -auto-flow-control: enable automatic flow control support.
|
| /Linux-v5.4/sound/ac97/ |
| D | Kconfig | 11 drivers which benefit from the AC97 automatic probing should "select"
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/supply/ab8500/ |
| D | charger.txt | 18 Boolean value depicting the presence of 'automatic poweron after powerloss'
|
| /Linux-v5.4/drivers/staging/pi433/ |
| D | rf69_enum.h | 60 automatic, enumerator
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | cs35l33.txt | 76 automatic updating is enabled.
84 allowed to increase to a higher voltage when using VPhg automatic
89 - cirrus,vp-hg-va : VA calculation reference for automatic VPhg tracking
|
| /Linux-v5.4/drivers/net/wireless/ti/ |
| D | Kconfig | 18 # keep last for automatic dependencies
|
| /Linux-v5.4/drivers/w1/ |
| D | Kconfig | 25 either due to automatic or requested search.
|
| /Linux-v5.4/sound/ppc/ |
| D | Kconfig | 29 Say Y here to enable the automatic toggle of DRC (dynamic
|
| /Linux-v5.4/Documentation/media/uapi/dvb/ |
| D | fe-set-frontend-tune-mode.rst | 42 there will be no automatic monitoring of the lock status, and
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-block-loop | 38 (RO) Shows if automatic partition scanning is enabled for the
|
| /Linux-v5.4/Documentation/devicetree/bindings/mmc/ |
| D | nvidia,tegra20-sdhci.txt | 63 strength used as a fallback in case the automatic calibration times
67 strength used as a fallback in case the automatic calibration times
|
