Searched refs:Second (Results 1 – 25 of 113) sorted by relevance
12345
| /Linux-v5.4/Documentation/admin-guide/ |
| D | devices.txt | 22 1 = /dev/ram1 Second RAM disk
33 1 = /dev/ptyp1 Second PTY master
108 1 = /dev/ttyp1 Second PTY slave
122 2 = /dev/hd?2 Second partition
193 1 = /dev/loop1 Second loop device
202 16 = /dev/sdb Second SCSI disk whole disk
213 1 = /dev/st1 Second SCSI tape, mode 0
216 33 = /dev/st1l Second SCSI tape, mode 1
219 65 = /dev/st1m Second SCSI tape, mode 2
222 97 = /dev/st1a Second SCSI tape, mode 3
[all …]
|
| /Linux-v5.4/Documentation/devicetree/bindings/gpio/ |
| D | gpio-thunderx.txt | 8 - Second cell is a standard generic flag bitfield as described in gpio.txt.
16 - Second cell is triggering flags as defined in interrupts.txt.
|
| D | gpio-zynq.txt | 7 - Second cell is used to specify optional
|
| D | gpio-aspeed.txt | 10 - Second cell is used to specify optional
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/bridge/ |
| D | thine,thc63lvd1024.txt | 28 - port@1: Second LVDS input port
29 - port@3: Second digital CMOS/TTL parallel output
|
| /Linux-v5.4/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-st.txt | 26 Second type has a dedicated interrupt per gpio bank.
54 - Second cell: specifies whether the pin is logically inverted.
71 - Second Cell: flags to identify the type of the interrupt
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/ |
| D | sm501fb.txt | 10 - Second entry: IO space (Display Controller register)
|
| /Linux-v5.4/Documentation/devicetree/bindings/spi/ |
| D | spi-nxp-fspi.txt | 6 Second contains the memory mapping address and length
|
| /Linux-v5.4/tools/testing/selftests/powerpc/math/ |
| D | vsx_asm.S | 15 addi r3, r3, 16 * 12 #Second half of array
|
| /Linux-v5.4/fs/ext2/ |
| D | Kconfig | 3 tristate "Second extended fs support"
|
| /Linux-v5.4/Documentation/devicetree/bindings/mux/ |
| D | adi,adgs1408.txt | 14 - Second cell is used to specify active high (0)
|
| D | adi,adg792a.txt | 14 - Second cell is used to specify active high (0)
|
| /Linux-v5.4/Documentation/devicetree/bindings/pci/ |
| D | pci-thunder-pem.txt | 16 from the parent bus. Second, the register bank of
|
| /Linux-v5.4/Documentation/devicetree/bindings/mtd/ |
| D | ti,am654-hbmc.txt | 7 Second entry pointing to the memory map region dedicated for
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | vidioc-g-modulator.rst | 173 encoded as mono audio, the last channel as Second Audio Program.
178 right stereo audio, channel 3 as Second Audio Program. When the
182 encode a Second Audio Program only. This flag must combine with
|
| /Linux-v5.4/arch/powerpc/platforms/8xx/ |
| D | Kconfig | 60 bool "Second Ethernet channel"
68 prompt "Second Ethernet channel"
|
| /Linux-v5.4/drivers/pps/ |
| D | Kconfig | 9 PPS (Pulse Per Second) is a special pulse provided by some GPS
|
| /Linux-v5.4/Documentation/devicetree/bindings/dma/ |
| D | stm32-dmamux.txt | 8 Second is DMA channel configuration
|
| D | qcom_adm.txt | 7 - #dma-cells: must be <2>. First cell denotes the channel number. Second cell
|
| /Linux-v5.4/Documentation/fb/ |
| D | vt8623fb.rst | 34 packed pixels, high nibble first. Second mode (selected if nonstd == 1) is mode
|
| D | arkfb.rst | 37 packed pixels, high nibble first. Second mode (selected if nonstd == 1) is mode
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | armada-xp-axpwifiap.dts | 106 /* Second mini-PCIe port */
|
| /Linux-v5.4/Documentation/devicetree/bindings/interrupt-controller/ |
| D | samsung,exynos4210-combiner.txt | 25 * Second Cell: Interrupt number within the group.
|
| /Linux-v5.4/Documentation/devicetree/bindings/soc/ti/ |
| D | sci-pm-domain.txt | 25 Second entry should be one of the floowing:
|
| /Linux-v5.4/Documentation/devicetree/bindings/ata/ |
| D | apm-xgene.txt | 11 Second memory resource shall be the host controller
|
12345
