| /Linux-v5.4/drivers/scsi/ |
| D | 53c700.scr | 181 CLEAR ACK
195 CLEAR ACK
199 CLEAR ACK
208 CLEAR ACK
212 CLEAR ACK
216 CLEAR ACK
220 CLEAR ACK
224 CLEAR ACK
232 CLEAR ACK
240 CLEAR ACK
[all …]
|
| D | 53c700_d.h_shipped | 238 CLEAR ACK
267 CLEAR ACK
280 CLEAR ACK
313 CLEAR ACK
326 CLEAR ACK
339 CLEAR ACK
352 CLEAR ACK
365 CLEAR ACK
382 CLEAR ACK
399 CLEAR ACK
[all …]
|
| /Linux-v5.4/Documentation/translations/zh_CN/process/ |
| D | stable-kernel-rules.rst | 42 - 如果补丁被接受到队列里，发送者会收到一个ACK回复，如果没有被接受，收
53 - 审查委员会有48小时的时间，用来决定给该补丁回复ACK还是NAK。
57 - 在审查周期结束的时候，那些得到ACK回应的补丁将会被加入到最新的稳定版
|
| /Linux-v5.4/Documentation/networking/ |
| D | snmp_counter.rst | 275 it excludes the retransmitted packets. But it includes the SYN, ACK
296 It means the TCP layer receives a SYN, replies a SYN+ACK, come into
329 TCPSynRetrans: number of SYN and SYN/ACK retransmits to break down
359 half open queue, TCP stack will send SYN+ACK on an exponential backoff
360 timer, after client replies ACK, TCP stack checks whether the accept
363 time client replies ACK, this socket will get another chance to move
450 If a packet set ACK flag and has no data, it is a pure ACK packet, if
457 If a TCP packet has data (which means it is not a pure ACK packet),
537 approached. The two pieces of information are ACK train length and
539 `Hybrid Slow Start paper`_. Either ACK train length or packet delay
[all …]
|
| D | rxrpc.txt | 146 (*) Calls use ACK packets to handle reliability. Data packets are also
150 A hard-ACK indicates to the far side that all the data received to a point
151 has been received and processed; a soft-ACK indicates that the data has
153 not discard any transmittable packets until they've been hard-ACK'd.
155 (*) Reception of a reply data packet implicitly hard-ACK's all the data
159 received and the final hard-ACK on the last packet of the reply has
197 (*) ACK'ing is handled by the protocol driver automatically, including ping
236 the reply is transmitted with one or more sendmsgs, and then the final ACK
334 RXRPC_ACK -rt n/a Final ACK received
364 This is delivered to a server application to indicate that the final ACK
[all …]
|
| D | PLIP.txt | 141 D3->ACK 5 - 10 10 - 5
176 INIT -> ACK 16 - 10
204 That raises the ACK line, triggering an interrupt in the receiving
205 machine. The receiving machine disables interrupts and raises its own ACK
|
| D | proc_net_tcp.txt | 34 | | | | | | (delayed ACK control data)
|
| D | mac80211-injection.txt | 29 an ACK even if it is a unicast frame
|
| /Linux-v5.4/Documentation/translations/ja_JP/ |
| D | stable_kernel_rules.txt | 55 - 送信者はパッチがキューに受け付けられた際には ACK を、却下された場合
70 - レビュー委員会は 48時間の間に ACK か NAK を出す。
74 - レビューサイクルの最後に、ACK を受けたパッチは最新の -stable リリー
|
| /Linux-v5.4/Documentation/input/devices/ |
| D | walkera0701.rst | 31 / O 4 3 O \ pin 3 (GND) LED ________________ 10 ACK
55 Driver use interrupt from parport ACK input bit to measure pulse length
98 (Warning, pulses on ACK are inverted by transistor, irq is raised up on sync
|
| /Linux-v5.4/Documentation/security/ |
| D | SCTP.rst | 127 Called when a COOKIE ACK is received::
130 @skb - pointer to skbuff of the COOKIE ACK packet.
161 <----------------------------------------------- INIT ACK
169 <------------------------------------------- COOKIE ACK
273 Called when a COOKIE ACK is received where it sets the connection's peer sid
277 @skb - pointer to skbuff of the COOKIE ACK packet.
|
| /Linux-v5.4/Documentation/i2c/ |
| D | slave-interface.rst | 162 About ACK/NACK
165 It is good behaviour to always ACK the address phase, so the master knows if a
167 state being busy is troublesome. SMBus demands to always ACK the address phase,
169 automatically ACK when detecting their slave addresses, so there is no option
173 Currently, there is no slave event to report if the master did ACK or NACK a
|
| D | gpio-fault-injection.rst | 60 it will stop at the ACK phase after the address of the client has been
61 transmitted. Because the device will ACK its presence, this results in SDA
73 The injector will again stop at one ACK phase, so the device will keep SDA low
78 b) after the address byte, a 0x00 byte will be transferred. Then, stop at ACK.
|
| /Linux-v5.4/Documentation/devicetree/bindings/misc/ |
| D | olpc,xo1.75-ec.txt | 9 strobing the ACK pin with the ready signal. See the "ready-gpios" property of the
|
| /Linux-v5.4/drivers/usb/gadget/udc/ |
| D | goku_udc.c | 1525 #define ACK(irqbit) { \ macro
1576 ACK(INT_SUSPEND); in goku_irq()
1613 ACK(INT_USBRESET); in goku_irq()
1624 ACK(INT_SETUP); in goku_irq()
1629 ACK(INT_STATUSNAK|INT_ENDPOINT0); in goku_irq()
1639 ACK(INT_ENDPOINT0); in goku_irq()
1647 ACK(INT_MSTRDEND); in goku_irq()
1653 ACK(INT_MSTWREND); in goku_irq()
1659 ACK(INT_MSTWRTMOUT); in goku_irq()
1693 #undef ACK
|
| /Linux-v5.4/include/rdma/ |
| D | tid_rdma_defs.h | 94 IB_OPCODE(TID_RDMA, ACK),
|
| /Linux-v5.4/Documentation/ |
| D | mailbox.txt | 66 /* An ACK to our last sample sent */
72 /* Remote f/w sends only ACK packets on this channel */
|
| /Linux-v5.4/Documentation/scsi/ |
| D | qlogicfas.txt | 71 that it gets a false ACK causing an extra byte to be inserted into the
73 termination (the ACK can be reflected), or by noise when the chips
|
| /Linux-v5.4/drivers/net/wireless/ath/ath9k/ |
| D | Kconfig | 120 bool "Atheros ath9k ACK timeout estimation algorithm"
124 This option enables ath9k dynamic ACK timeout estimation algorithm
125 based on ACK frame RX timestamp, TX frame timestamp and frame
|
| /Linux-v5.4/drivers/media/pci/bt8xx/ |
| D | dst_common.h | 83 #define ACK 0xff macro
|
| /Linux-v5.4/drivers/usb/serial/ |
| D | garmin_gps.c | 98 #define ACK 0x06 macro
344 *ptr++ = ACK; in gsp_send_ack()
345 cksum += ACK; in gsp_send_ack()
511 if (data == ACK) { in gsp_receive()
512 ack_or_nak_seen = ACK; in gsp_receive()
|
| /Linux-v5.4/Documentation/translations/it_IT/process/ |
| D | stable-kernel-rules.rst | 154 - Il mittente riceverà un ACK quando la patch è stata accettata e messa in
170 - La commissione per la revisione ha 48 ore per dare il proprio ACK o NACK
176 - Alla fine del ciclo di revisione tutte le patch che hanno ricevuto l'ACK
|
| /Linux-v5.4/Documentation/i2c/busses/ |
| D | i2c-mlxcpld.rst | 50 Bit 4 - ACK/NACK.
|
| /Linux-v5.4/Documentation/devicetree/bindings/mailbox/ |
| D | fsl,mu.txt | 39 2 - TX doorbell channel. Without own register and no ACK support.
|
| /Linux-v5.4/Documentation/devicetree/bindings/remoteproc/ |
| D | stm32-rproc.txt | 35 - from local to remote, where ACK from the remote means
|
