| /Linux-v5.10/Documentation/misc-devices/ |
| D | max6875.rst | 75 The configuration registers are at addresses 0x00 - 0x45.
84 To write a 1 to register 0x45::
86 i2c_smbus_write_byte_data(fd, 0x45, 1);
88 To read register 0x45::
90 value = i2c_smbus_read_byte_data(fd, 0x45);
|
| /Linux-v5.10/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-nitrogen.dts | 344 MX8MQ_IOMUXC_UART1_RXD_UART1_DCE_RX 0x45
345 MX8MQ_IOMUXC_UART1_TXD_UART1_DCE_TX 0x45
351 MX8MQ_IOMUXC_UART2_RXD_UART2_DCE_RX 0x45
352 MX8MQ_IOMUXC_UART2_TXD_UART2_DCE_TX 0x45
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | aspeed-bmc-facebook-tiogapass.dts | 224 reg = <0x45>;
284 reg = <0x45>;
344 reg = <0x45>;
414 reg = <0x45>;
|
| D | exynos5422-odroidxu3.dts | 47 reg = <0x45>;
|
| D | bcm53016-meraki-mr32.dts | 104 reg = <0x45>;
|
| D | ls1021a-tsn.dts | 164 reg = <0x45>;
|
| D | bcm7445.dtsi | 105 interrupts = <GIC_SPI 0x45 0x0>,
|
| D | aspeed-bmc-lenovo-hr855xg2.dts | 220 reg = <0x45>;
|
| D | am3874-iceboard.dts | 161 ina230@45 { compatible = "ti,ina230"; reg = <0x45>; shunt-resistor = <5000>; };
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/temperature/ |
| D | tmp007.txt | 17 1 1 0x45
|
| /Linux-v5.10/net/wireless/certs/ |
| D | sforshee.hex | 30 0x0c, 0xd1, 0x45, 0x19, 0xda, 0x10, 0x44, 0x8a,
37 0xd9, 0x1b, 0x73, 0x45, 0xeb, 0xba, 0x27, 0x85,
82 0x23, 0x99, 0x9f, 0x51, 0x03, 0x4c, 0x45, 0x7d,
|
| /Linux-v5.10/lib/crypto/ |
| D | curve25519-fiat32.c | 128 { u32 x44; u8/*bool*/ x45 = subborrow_u26(x42, x18, 0x3ffffff, &x44); in fe_freeze() local
129 { u32 x47; u8/*bool*/ x48 = subborrow_u25(x45, x17, 0x1ffffff, &x47); in fe_freeze()
339 …{ u64 x45 = (((((((u64)x27 * x11) + ((u64)x29 * x9)) + ((u64)x25 * x13)) + ((u64)x31 * x7)) + ((u6… in fe_mul_impl() local
362 { u64 x68 = (x45 + (x55 << 0x4)); in fe_mul_impl()
482 { u64 x45 = (x44 + (x35 << 0x1)); in fe_sqr_impl() local
483 { u64 x46 = (x45 + x35); in fe_sqr_impl()
662 …{ u64 x45 = (((((((u64)x27 * x11) + ((u64)x29 * x9)) + ((u64)x25 * x13)) + ((u64)x31 * x7)) + ((u6… in fe_mul_121666_impl() local
685 { u64 x68 = (x45 + (x55 << 0x4)); in fe_mul_121666_impl()
|
| /Linux-v5.10/Documentation/dev-tools/ |
| D | ubsan.rst | 27 [<ffffffff815e6cd6>] dump_stack+0x45/0x5f
|
| /Linux-v5.10/arch/arm64/boot/dts/xilinx/ |
| D | zynqmp-zcu111-revA.dts | 244 reg = <0x45>;
328 reg = <0x45>;
|
| D | zynqmp-zcu102-revA.dts | 292 reg = <0x45>;
368 reg = <0x45>;
|
| D | zynqmp-zcu106-revA.dts | 292 reg = <0x45>;
368 reg = <0x45>;
|
| /Linux-v5.10/Documentation/hwmon/ |
| D | sht3x.rst | 28 addresses 0x44 or 0x45, depending on the wiring. See
|
| /Linux-v5.10/Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| D | qe.txt | 169 fsl,firmware = [0x70 0xcd 0x00 0x00 0x01 0x46 0x45 ...];
|
| /Linux-v5.10/arch/powerpc/boot/dts/fsl/ |
| D | p3041ds.dts | 159 reg = <0x45>;
|
| D | p5020ds.dts | 159 reg = <0x45>;
|
| D | p5040ds.dts | 168 reg = <0x45>;
|
| D | t4240qds.dts | 435 reg = <0x45>;
|
| /Linux-v5.10/drivers/tty/vt/ |
| D | cp437.uni | 89 0x45 U+0045 U+00c8 U+00ca U+00cb
|
| /Linux-v5.10/drivers/scsi/aic7xxx/ |
| D | aic7xxx_seq.h_shipped | 655 0x00, 0x65, 0x36, 0x45,
696 0x00, 0x65, 0x62, 0x45,
725 0x00, 0x65, 0xa0, 0x45,
|
| /Linux-v5.10/Documentation/usb/ |
| D | gadget_hid.rst | 177 {.opt = "--f12", .val = 0x45},
|
