| /Linux-v5.10/drivers/hwmon/ |
| D | sht15.c | 150 struct gpio_desc *sck; member
211 gpiod_set_value(data->sck, 0); in sht15_connection_reset()
214 gpiod_set_value(data->sck, 1); in sht15_connection_reset()
216 gpiod_set_value(data->sck, 0); in sht15_connection_reset()
231 gpiod_set_value(data->sck, 1); in sht15_send_bit()
233 gpiod_set_value(data->sck, 0); in sht15_send_bit()
254 gpiod_set_value(data->sck, 0); in sht15_transmission_start()
256 gpiod_set_value(data->sck, 1); in sht15_transmission_start()
260 gpiod_set_value(data->sck, 0); in sht15_transmission_start()
262 gpiod_set_value(data->sck, 1); in sht15_transmission_start()
[all …]
|
| /Linux-v5.10/drivers/clk/at91/ |
| D | at91sam9260.c | 10 struct sck { struct
27 const struct sck *sck; member
73 static const struct sck at91sam9260_systemck[] = {
114 .sck = at91sam9260_systemck,
172 .sck = at91sam9260_systemck,
214 static const struct sck at91sam9261_systemck[] = {
253 .sck = at91sam9261_systemck,
278 static const struct sck at91sam9263_systemck[] = {
320 .sck = at91sam9263_systemck,
356 ndck(data->sck, data->num_sck), in at91sam926x_pmc_setup()
[all …]
|
| D | at91rm9200.c | 10 struct sck { struct
40 static const struct sck at91rm9200_systemck[] = {
|
| /Linux-v5.10/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,armada-39x-pinctrl.txt | 20 mpp2 2 gpio, i2c0(sck)
33 mpp15 15 gpio, pcie0(rstout), spi0(mosi), i2c1(sck)
35 mpp17 17 gpio, ua1(rxd), spi0(sck), sata1(prsnt) [1], sata0(prsnt) [1], smi(mdio)
36 mpp18 18 gpio, ua1(txd), spi0(cs0), i2c2(sck)
42 mpp23 23 gpio, spi0(sck), dev(ad2)
45 mpp26 26 gpio, spi0(cs2), i2c1(sck), sd0(d6), dev(cs1)
58 mpp39 39 gpio, i2c1(sck), ua0(cts), sd0(d1), dev(a2), ge(rxd2)
74 mpp52 52 gpio, pcie0(rstout), tdm(int) [2], audio(sdi) [2], sd0(d6), i2c3(sck)
79 mpp57 57 gpio, spi1(sck), sd0(clk), ua1(txd)
80 mpp58 58 gpio, i2c1(sck), pcie2(clkreq), spi1(miso), sd0(d1), ua1(rxd)
|
| D | marvell,kirkwood-pinctrl.txt | 26 mpp2 2 gpo, nand(io4), spi(sck)
34 mpp9 9 gpio, twsi(sck), uart0(cts), uart1(cts), ptp(evreq),
36 mpp10 10 gpo, spi(sck), uart0(txd), ptp(trig)
64 mpp2 2 gpo, nand(io4), spi(sck)
72 mpp9 9 gpio, twsi(sck), uart0(cts), uart1(cts), ptp(evreq),
74 mpp10 10 gpo, spi(sck), uart0(txd), ptp(trig)
108 mpp2 2 gpo, nand(io4), spi(sck)
116 mpp9 9 gpio, twsi(sck), uart0(cts), uart1(cts), ptp(evreq),
118 mpp10 10 gpo, spi(sck), uart0(txd), ptp(trig), sata1(act)
139 mpp25 25 gpio, ge1(rxd1), ts(mp5), tdm(spi-sck), audio(lrclk)
[all …]
|
| D | marvell,armada-370-pinctrl.txt | 18 mpp2 2 gpio, i2c0(sck), uart0(txd)
21 mpp5 5 gpo, ge0(txclkout), uart1(txd), spi1(sck), audio(mclk)
31 mpp13 13 gpio, ge0(rxd2), i2c1(sck), sd0(d1), tdm(pclk),
51 mpp30 30 gpio, ge0(rxd7), ge1(rxclk), i2c1(sck)
56 mpp35 35 gpo, dev(oe), spi0(sck)
76 mpp52 52 gpio, dev(ad13), i2c1(sck), sd0(d3), spi1(sck)
94 mpp63 63 gpio, spi0(sck), tclk
|
| D | marvell,armada-375-pinctrl.txt | 25 mpp9 9 gpio, spi0(sck), spi1(sck), nand(we)
31 mpp15 15 gpio, i2c0(sck), uart1(rxd)
48 mpp32 32 gpio, ge1(txd2), spi1(sck), ptp(trig)
50 mpp34 34 gpio, ge1(txclkout), spi1(sck)
78 mpp62 62 gpio, i2c1(sck), led(p1)
|
| D | marvell,armada-38x-pinctrl.txt | 20 mpp2 2 gpio, i2c0(sck)
35 mpp17 17 gpio, ge0(rxclk), ptp(clk), ua1(rxd), spi0(sck), sata1(prsnt), sata0(prsnt)
41 mpp23 23 gpio, spi0(sck), dev(ad2)
44 mpp26 26 gpio, spi0(cs2), i2c1(sck), sd0(d6), dev(cs1)
57 mpp39 39 gpio, i2c1(sck), ge1(rxd2), ua0(cts), sd0(d1), dev(a2)
75 mpp57 57 gpio, spi1(sck), sd0(clk), ua1(txd)
76 mpp58 58 gpio, pcie1(clkreq) [1], i2c1(sck), pcie2(clkreq), spi1(miso), sd0(d1), ua1(…
|
| D | marvell,dove-pinctrl.txt | 27 mpp7 7 gpio, pmu, uart3(rxd), sdio1(ledctrl), spi1(sck), pmu*
43 mpp19 19 gpio, uart3(rxd), sdio0(ledctrl), twsi(sck)
50 mpp23 23 gpio, sdio0(ledctrl), sdio1(ledctrl), spi1(sck),
51 lcd-spi(sck), ssp(sclk)
|
| D | marvell,armada-98dx3236-pinctrl.txt | 16 mpp2 2 gpo, spi0(sck), dev(ad10)
28 mpp14 14 gpio, i2c0(sck)
|
| D | marvell,armada-xp-pinctrl.txt | 35 mpp14 14 gpio, ge0(txd6), ge1(txd1), spi1(sck), lcd(d15)
59 mpp38 38 gpio, spi0(sck)
|
| /Linux-v5.10/Documentation/userspace-api/media/drivers/ |
| D | max2175.rst | 41 sample clock (sck), sampling rate etc. These multiple settings are
53 samples/sec with a 10.24 MHz sck.
56 samples/sec with a 32.768 MHz sck.
61 samples/sec with a 14.88375 MHz sck.
64 samples/sec with a 7.441875 MHz sck.
|
| /Linux-v5.10/drivers/spi/ |
| D | spi-gpio.c | 35 struct gpio_desc *sck; member
91 gpiod_set_value_cansleep(spi_gpio->sck, is_on); in setsck()
205 gpiod_set_value_cansleep(spi_gpio->sck, spi->mode & SPI_CPOL); in spi_gpio_chipselect()
259 gpiod_set_value_cansleep(spi_gpio->sck, in spi_gpio_set_direction()
261 gpiod_set_value_cansleep(spi_gpio->sck, in spi_gpio_set_direction()
292 spi_gpio->sck = devm_gpiod_get(dev, "sck", GPIOD_OUT_LOW); in spi_gpio_request()
293 return PTR_ERR_OR_ZERO(spi_gpio->sck); in spi_gpio_request()
|
| D | spi-mxs.c | 60 unsigned int sck; /* Rate requested (vs actual) */ member
75 if (hz != spi->sck) { in mxs_spi_setup_transfer()
82 spi->sck = hz; in mxs_spi_setup_transfer()
|
| /Linux-v5.10/Documentation/devicetree/bindings/spi/ |
| D | spi-fsl-dspi.txt | 29 - fsl,spi-cs-sck-delay: a delay in nanoseconds between activating chip
31 - fsl,spi-sck-cs-delay: a delay in nanoseconds between stopping the clock
60 fsl,spi-cs-sck-delay = <100>;
61 fsl,spi-sck-cs-delay = <50>;
|
| /Linux-v5.10/arch/arm64/boot/dts/freescale/ |
| D | fsl-ls1043a-rdb.dts | 103 fsl,spi-cs-sck-delay = <100>;
104 fsl,spi-sck-cs-delay = <50>;
111 fsl,spi-cs-sck-delay = <100>;
112 fsl,spi-sck-cs-delay = <50>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/arm/marvell/ |
| D | cp110-system-controller.txt | 92 mpp1 1 gpio, dev(ale0), au(i2sdo_spdifo), ge0(rxd2), tdm(drx), ptp(clk), mss_i2c(sck), uart0(txd), …
93 mpp2 2 gpio, dev(ad15), au(i2sextclk), ge0(rxd1), tdm(dtx), mss_uart(rxd), ptp(pclk_out), i2c1(sck)…
121 …), mss_gpio7, ge0(rxd0), spi0(csn7), pcie0(clkreq), ptp(pclk_out), mss_i2c(sck), sata1(present_act…
127 mpp36 36 gpio, synce2(clk), i2c1(sck), ptp(clk), synce1(clk), au(i2sbclk), sata0(present_act), xg(m…
128 mpp37 37 gpio, uart2(rxd), i2c0(sck), ptp(pclk_out), tdm(intn), mss_i2c(sck), sata1(present_act), g…
132 mpp41 41 gpio, sdio(pwr10), sdio(bus_pwr), mss_i2c(sck), au(i2slrclk), ptp(pulse), spi0(mosi), uart…
142 mpp51 51 gpio, ge1(rxd0), mss_i2c(sck), spi1(csn1), uart2(rxd), uart0(cts), sdio(pwr10)
149 mpp58 58 gpio, mss_i2c(sck), ptp(clk), tdm(rstn), au(i2sdi), spi0(miso), uart1(cts), led(clk), sdio…
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | at91-tse850-3.dts | 18 sck: oscillator { label
23 clock-output-names = "sck";
223 clocks = <&sck>;
|
| D | vf610-bk4.dts | 71 sck-gpios = <&gpio2 27 GPIO_ACTIVE_LOW>;
125 fsl,spi-cs-sck-delay = <200>;
126 fsl,spi-sck-cs-delay = <400>;
|
| D | ls1021a-tsn.dts | 50 fsl,spi-cs-sck-delay = <1000>;
51 fsl,spi-sck-cs-delay = <1000>;
|
| D | bcm947189acdbmr.dts | 63 gpio-sck = <&chipcommon 21 0>;
|
| D | bcm47081-buffalo-wzr-900dhp.dts | 31 gpio-sck = <&chipcommon 7 0>;
|
| D | imx28-cfa10056.dts | 96 gpio-sck = <&gpio2 16 0>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/net/dsa/ |
| D | sja1105.txt | 79 fsl,spi-cs-sck-delay = <1000>;
80 fsl,spi-sck-cs-delay = <1000>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | pcm512x.txt | 49 clocks = <&sck>;
|
