| /Linux-v5.10/drivers/staging/rtl8188eu/hal/ |
| D | rtl8188eu_led.c | 15 u8 led_cfg; in sw_led_on() local
19 led_cfg = usb_read8(padapter, REG_LEDCFG2); in sw_led_on()
20 usb_write8(padapter, REG_LEDCFG2, (led_cfg & 0xf0) | BIT(5) | BIT(6)); in sw_led_on()
26 u8 led_cfg; in sw_led_off() local
31 led_cfg = usb_read8(padapter, REG_LEDCFG2);/* 0x4E */ in sw_led_off()
34 led_cfg &= 0x90; /* Set to software control. */ in sw_led_off()
35 usb_write8(padapter, REG_LEDCFG2, (led_cfg | BIT(3))); in sw_led_off()
36 led_cfg = usb_read8(padapter, REG_MAC_PINMUX_CFG); in sw_led_off()
37 led_cfg &= 0xFE; in sw_led_off()
38 usb_write8(padapter, REG_MAC_PINMUX_CFG, led_cfg); in sw_led_off()
|
| /Linux-v5.10/drivers/leds/ |
| D | leds-max77693.c | 391 struct max77693_led_config_data *led_cfg) in max77693_setup() argument
406 max_flash_curr[FLED1] = led_cfg->iout_flash_max[FLED1] + in max77693_setup()
407 led_cfg->iout_flash_max[FLED2]; in max77693_setup()
411 max_flash_curr[FLED1] = led_cfg->iout_flash_max[FLED1]; in max77693_setup()
412 max_flash_curr[FLED2] = led_cfg->iout_flash_max[FLED2]; in max77693_setup()
427 if (led_cfg->low_vsys > 0) in max77693_setup()
428 v = max77693_led_vsys_to_reg(led_cfg->low_vsys) | in max77693_setup()
440 if (led_cfg->boost_mode == MAX77693_LED_BOOST_FIXED) in max77693_setup()
443 v = led_cfg->boost_mode | led_cfg->boost_mode << 1; in max77693_setup()
452 v = max77693_led_vout_to_reg(led_cfg->boost_vout); in max77693_setup()
[all …]
|
| D | leds-aat1290.c | 422 struct aat1290_led_config_data *led_cfg, in aat1290_init_v4l2_flash_config() argument
433 s->max = led_cfg->max_mm_current; in aat1290_init_v4l2_flash_config()
437 v4l2_sd_cfg->has_external_strobe = led_cfg->has_external_strobe; in aat1290_init_v4l2_flash_config()
447 struct aat1290_led_config_data *led_cfg, in aat1290_init_v4l2_flash_config() argument
467 struct aat1290_led_config_data led_cfg = {}; in aat1290_led_probe() local
482 ret = aat1290_led_get_configuration(led, &led_cfg, &sub_node); in aat1290_led_probe()
490 led_cdev->max_brightness = led_cfg.max_brightness; in aat1290_led_probe()
493 aat1290_init_flash_timeout(led, &led_cfg); in aat1290_led_probe()
504 aat1290_init_v4l2_flash_config(led, &led_cfg, &v4l2_sd_cfg); in aat1290_led_probe()
|
| D | leds-ktd2692.c | 338 struct ktd2692_led_config_data led_cfg; in ktd2692_probe() local
348 ret = ktd2692_parse_dt(led, &pdev->dev, &led_cfg); in ktd2692_probe()
352 ktd2692_init_flash_timeout(fled_cdev, &led_cfg); in ktd2692_probe()
353 ktd2692_init_movie_current_max(&led_cfg); in ktd2692_probe()
357 led_cdev->max_brightness = led_cfg.max_brightness; in ktd2692_probe()
|
| /Linux-v5.10/drivers/scsi/qla2xxx/ |
| D | qla_sup.c | 1780 uint16_t led_cfg[6]; in qla83xx_beacon_blink() local
1818 led_cfg[0] = 0x4000; in qla83xx_beacon_blink()
1819 led_cfg[1] = 0x2000; in qla83xx_beacon_blink()
1820 led_cfg[2] = 0; in qla83xx_beacon_blink()
1821 led_cfg[3] = 0; in qla83xx_beacon_blink()
1822 led_cfg[4] = 0; in qla83xx_beacon_blink()
1823 led_cfg[5] = 0; in qla83xx_beacon_blink()
1825 led_cfg[0] = 0x4000; in qla83xx_beacon_blink()
1826 led_cfg[1] = 0x4000; in qla83xx_beacon_blink()
1827 led_cfg[2] = 0x4000; in qla83xx_beacon_blink()
[all …]
|
| D | qla_mbx.c | 5955 qla81xx_set_led_config(scsi_qla_host_t *vha, uint16_t *led_cfg) in qla81xx_set_led_config() argument
5970 mcp->mb[1] = led_cfg[0]; in qla81xx_set_led_config()
5971 mcp->mb[2] = led_cfg[1]; in qla81xx_set_led_config()
5973 mcp->mb[3] = led_cfg[2]; in qla81xx_set_led_config()
5974 mcp->mb[4] = led_cfg[3]; in qla81xx_set_led_config()
5975 mcp->mb[5] = led_cfg[4]; in qla81xx_set_led_config()
5976 mcp->mb[6] = led_cfg[5]; in qla81xx_set_led_config()
5999 qla81xx_get_led_config(scsi_qla_host_t *vha, uint16_t *led_cfg) in qla81xx_get_led_config() argument
6027 led_cfg[0] = mcp->mb[1]; in qla81xx_get_led_config()
6028 led_cfg[1] = mcp->mb[2]; in qla81xx_get_led_config()
[all …]
|
| /Linux-v5.10/drivers/media/dvb-frontends/ |
| D | au8522_common.c | 131 struct au8522_led_config *led_config = state->config.led_cfg; in au8522_led_gpio_enable()
161 struct au8522_led_config *led_config = state->config.led_cfg; in au8522_led_ctrl()
|
| D | au8522.h | 45 struct au8522_led_config *led_cfg; member
|
| D | au8522_dig.c | 694 struct au8522_led_config *led_config = state->config.led_cfg; in au8522_led_status()
748 if (state->config.led_cfg) in au8522_read_snr()
|
| /Linux-v5.10/drivers/net/ethernet/broadcom/bnxt/ |
| D | bnxt_ethtool.c | 3034 struct bnxt_led_cfg *led_cfg; in bnxt_set_phys_id() local
3054 led_cfg = (struct bnxt_led_cfg *)&req.led0_id; in bnxt_set_phys_id()
3055 for (i = 0; i < bp->num_leds; i++, led_cfg++) { in bnxt_set_phys_id()
3057 led_cfg->led_id = bp->leds[i].led_id; in bnxt_set_phys_id()
3058 led_cfg->led_state = led_state; in bnxt_set_phys_id()
3059 led_cfg->led_blink_on = duration; in bnxt_set_phys_id()
3060 led_cfg->led_blink_off = duration; in bnxt_set_phys_id()
3061 led_cfg->led_group_id = bp->leds[i].led_group_id; in bnxt_set_phys_id()
|
| /Linux-v5.10/drivers/media/usb/au0828/ |
| D | au0828-dvb.c | 56 .led_cfg = &hauppauge_hvr950q_led_cfg,
|
| /Linux-v5.10/drivers/net/ethernet/broadcom/ |
| D | tg3.c | 15181 u32 nic_cfg, led_cfg; in tg3_get_eeprom_hw_cfg() local
15229 led_cfg = cfg2 & (NIC_SRAM_DATA_CFG_LED_MODE_MASK | in tg3_get_eeprom_hw_cfg()
15232 led_cfg = nic_cfg & NIC_SRAM_DATA_CFG_LED_MODE_MASK; in tg3_get_eeprom_hw_cfg()
15234 switch (led_cfg) { in tg3_get_eeprom_hw_cfg()
|
