Searched refs:SSI (Results 1 – 25 of 59) sorted by relevance
123
28 tristate "SSI protocol"31 If you say Y here, you will enable the SSI protocol aka McSAAB.36 tristate "HSI/SSI character driver"39 If you say Y here, you will enable the HSI/SSI character driver.41 serial communication with the cellular modem over HSI/SSI bus.
3 The SSI is a serial device that communicates with audio codecs. It can13 - cell-index: The SSI, <0> = SSI1, <1> = SSI2, and so on.23 - clocks: "ipg" - Required clock for the SSI unit24 "baud" - Required clock for SSI master mode. Otherwise this33 codec connected to this SSI. This node is typically37 where an incompatible codec is connected to this SSI, e.g.44 "ac97-slave" - AC97 mode, SSI is clock slave45 "ac97-master" - AC97 mode, SSI is clock master47 If specified, the SSI is to be programmed in asynchronous74 On SOCs that have an SSI, specific DMA channels are hard-wired for playback
17 SSI : Serial Sound Interface25 Multi channel is supported by Multi-SSI, or TDM-SSI.27 Multi-SSI : 6ch case, you can use stereo x 3 SSI28 TDM-SSI : 6ch case, you can use TDM185 But you can't use it if SSI was PIO mode.186 In DMA mode, you can select not to use SSIU by using "no-busif" via SSI.192 and these sounds will be merged SSIU/SSI.211 * SSI (Serial Sound Interface)217 Note: The system will drop non-SSI modules in PIO mode235 Each SSI can share WS pin. It is based on platform.[all …]
9 - ssi-controller : The phandle of the SSI controller.
9 - ssi-controller : The phandle of the i.MX SSI controller
6 - ssi-controller : The phandle of the i.MX SSI controller
6 Ends Audio controller such as ESAI, SSI and SAI. It has three pairs to support
82 Optional unless SSI is selected as a CPU DAI:
8 tristate "OMAP SSI hardware driver"12 SSI is a legacy version of HSI. It is usually used to connect14 If you say Y here, you will enable the OMAP SSI hardware driver.
4 Between PMIC Hi655x and Hi6220, the physical signal channel is SSI.9 | Hi6220 | SSI bus | Hi655x |
14 - adc-port: Contain PMIC SSI port number used for ADC.15 - dac-port: Contain PMIC SSI port number used for DAC.
39 tristate "R-Car series SRU/SCU/SSIU/SSI support"45 This option enables R-Car SRU/SCU/SSIU/SSI sound support
32 0 MCU domain SSI33 1 Shared SSI54 22 SSI Dual FIFO (needs firmware ver >= 2)
307 SCIF1, SIOF, HSPI, MMCIF, TMU3, TMU4, TMU5, SSI, FLCTL, GPIO, enumerator343 INTC_VECT(SSI, 0xe80),358 SSI, MMCIF, HSPI, SIOF, PCIC5, PCIINTD, PCIINTC, PCIINTB,373 { 0xffd40018, 0, 32, 8, /* INT2PRI6 */ { SIOF, HSPI, MMCIF, SSI } },
363 SSI, enumerator439 INTC_GROUP(SSI, SSI0, SSI1, SSI2, SSI3),487 SSI, /* SSI 0-3 */505 { HUDI, SHDMAC, USB, SSI } },
1 OMAP SSI controller bindings3 OMAP3's Synchronous Serial Interface (SSI) controller implements a
46 tristate "Synchronous Serial Interface module (SSI) support"51 Say Y if you want to add Synchronous Serial Interface (SSI)271 to the SSI interface283 via SSI/I2S over either SPI or I2C.326 ESAI/SAI/SSI and connect with external CODECs such as WM8962, CS42888,
22 "ti,omap3-ssi-interface-clock" - interface clock with SSI specific HW handling
200 DMA driver, such as the SSI sound drivers for the MPC8610. Therefore, any DMA202 "fsl,elo-dma-channel" or "fsl,eloplus-dma-channel". For the SSI drivers, for
689 MFP_XWAY(GPIO34, GPIO, SIN, SSI, NONE),690 MFP_XWAY(GPIO35, GPIO, SIN, SSI, NONE),691 MFP_XWAY(GPIO36, GPIO, SIN, SSI, NONE),902 MFP_XWAY(GPIO34, GPIO, SIN, SSI, NONE),903 MFP_XWAY(GPIO35, GPIO, SIN, SSI, NONE),904 MFP_XWAY(GPIO36, GPIO, SIN, SSI, EXIN),1158 MFP_XWAY(GPIO34, GPIO, NONE, SSI, NONE),1159 MFP_XWAY(GPIO35, GPIO, NONE, SSI, NONE),1160 MFP_XWAY(GPIO36, GPIO, NONE, SSI, NONE),
10 * SSI-AK461313 * SSI-HDMI
10 * SSI-PCM3168A
9 * SSI-SGTL5000
