Searched refs:between (Results 1 – 25 of 1332) sorted by relevance
12345678910>>...54
| /Linux-v4.19/Documentation/ABI/testing/ |
| D | sysfs-class-backlight-driver-adp8870 | 12 on this <backlight>. Values are between 0 and 127. This file
26 on this <backlight>. Values are between 0 and 127, typically
38 is enabled). Returns integer between 0 (dark) and
47 integer between 1..5 (1 = daylight, 2 = bright, ..., 5 = dark).
48 Writing a value between 1..5 forces the backlight controller
|
| D | sysfs-class-backlight-adp5520 | 17 is an input code between 0 and 127, which is transformed to a
18 value between 0 mA and 30 mA using linear or non-linear
30 input code between 0 and 127, which is transformed to a value
31 between 0 mA and 30 mA using linear or non-linear algorithms.
|
| D | sysfs-bus-iio-adc-hi8435 | 22 The low voltage threshold range is between 2..21V.
23 Hysteresis between low and high thresholds can not be lower then 2 and
39 The high voltage threshold range is between 3..22V.
40 Hysteresis between low and high thresholds can not be lower then 2 and
|
| D | sysfs-class-backlight-adp8860 | 39 is an input code between 0 and 127, which is transformed to a
40 value between 0 mA and 30 mA using linear or non-linear
53 input code between 0 and 127, which is transformed to a value
54 between 0 mA and 30 mA using linear or non-linear algorithms.
|
| D | sysfs-bus-iio-adc-max9611 | 13 between RS+ and RS- voltage sense inputs. In Ohms.
17 current flowing between RS+ and RS- inputs.
|
| D | sysfs-firmware-opal-psr | 7 to shift/throttle power between different entities in
16 Power-Shift-Ratio between CPU and GPU for a given chip
|
| /Linux-v4.19/drivers/mailbox/ |
| D | Kconfig | 4 Mailbox is a framework to control hardware communication between
40 send short messages between Highbank's A9 cores and the EnergyCore
67 between CPU cores and MCU processor on Some Rockchip SOCs.
77 between the OS and a platform such as the BMC. This medium
88 to send message between processors. Say Y here if you want to use the
113 architecture SoCs. These may be used for communication between
124 between application processors and other processors/MCU/DSP. Select
134 between application processors and MCU. Say Y here if you want to
158 between different remote processors and host processors on Tegra186
167 Mailbox (IPCM) between the ARM 64-bit cores and SLIMpro controller.
[all …]
|
| /Linux-v4.19/Documentation/media/uapi/dvb/ |
| D | fe-enable-high-lnb-voltage.rst | 12 FE_ENABLE_HIGH_LNB_VOLTAGE - Select output DC level between normal LNBf voltages or higher LNBf - v…
40 Select output DC level between normal LNBf voltages or higher LNBf
41 voltages between 0 (normal) or a value grater than 0 for higher
|
| /Linux-v4.19/Documentation/driver-api/ |
| D | device_connection.rst | 15 Device connections are generic descriptions of any type of connection between
18 Device connections alone do not create a dependency between the two devices.
20 A dependency between the two devices exists only if one of the two endpoint
34 is needed if there are multiple connections between the two devices.
|
| /Linux-v4.19/Documentation/devicetree/bindings/net/ |
| D | xilinx_gmii2rgmii.txt | 5 Independent Interface (RGMII) core provides the RGMII between RGMII-compliant
9 Speed of operation. This core can switch dynamically between the three
12 This converter sits between the ethernet MAC and the external phy.
|
| /Linux-v4.19/Documentation/devicetree/bindings/dma/ |
| D | stm32-dma.txt | 52 0x0: no address increment between transfers
53 0x1: increment address between transfers
55 0x0: no address increment between transfers
56 0x1: increment address between transfers
|
| /Linux-v4.19/Documentation/devicetree/bindings/mtd/ |
| D | cadence-quadspi.txt | 28 mode chip select outputs are de-asserted between
30 - cdns,tsd2d-ns : Delay in nanoseconds between one chip select being
32 - cdns,tchsh-ns : Delay in nanoseconds between last bit of current
35 - cdns,tslch-ns : Delay in nanoseconds between setting qspi_n_ss_out low
|
| /Linux-v4.19/Documentation/devicetree/bindings/input/touchscreen/ |
| D | fsl-mx25-tcq.txt | 16 between 1 and 4096. It is the ratio between the internal reference voltage
17 and the measured voltage after the plate was precharged. Resistance between
|
| /Linux-v4.19/Documentation/extcon/ |
| D | intel-int3496.txt | 11 between an USB host and an USB peripheral controller.
20 Index 2: The output gpio for muxing of the data pins between the USB host and
24 There is a mapping between indices and GPIO connection IDs as follows
|
| /Linux-v4.19/Documentation/devicetree/bindings/ |
| D | graph.txt | 7 control flow to devices, but there can be more complex connections between
10 There already is a simple directed graph between devices tree nodes using
23 Here the ports describe data interfaces, and the links between them are
87 Links between endpoints
94 their 'remote-endpoint' phandles pointing at each other form a link between the
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | kirkwood-openrd.dtsi | 7 * This file contains the definitions that are common between the three
60 * SelRS232or485 selects between RS-232 or RS-485
78 * SelUARTorSD selects between the second UART
|
| /Linux-v4.19/Documentation/devicetree/bindings/memory-controllers/ |
| D | ti-aemif.txt | 96 Time between the end of one asynchronous memory
99 between a read followed by read or a write
103 Time between the beginning of a memory cycle
108 Time between the activation and deactivation of
113 Time between the deactivation of the read
120 Time between the beginning of a memory cycle
125 Time between the activation and deactivation of
130 Time between the deactivation of the write
|
| /Linux-v4.19/Documentation/media/uapi/v4l/ |
| D | field-order.rst | 9 We have to distinguish between progressive and interlaced video.
13 odd and even field are transmitted, and due to a small delay between
23 object on screen may well move between one field and the next. For
29 combine to frames. We distinguish between top (aka odd) and bottom (aka
43 determined by the video standard. Hence the distinction between temporal
83 also indicate this order when it cannot distinguish between
122 any dropped fields between them (fields can drop individually),
|
| D | pixfmt-meta-vsp1-hgt.rst | 25 between 1 and 16 depending on the Hue areas configuration. Finding the
52 Pixels with a hue value included in the centre of an area (between nL and nU
54 with a hue value included in the overlapping region between two areas (between
|
| /Linux-v4.19/Documentation/devicetree/bindings/leds/ |
| D | ams,as3645a.txt | 7 Ranges below noted as [a, b] are closed ranges between a and b, i.e. a
29 in the range between [200000, 500000] and
32 value must be in the range between [20000, 160000] and
|
| /Linux-v4.19/Documentation/devicetree/bindings/mips/cavium/ |
| D | ciu2.txt | 13 the CIU and may have a value between 0 and 63. The second cell is
14 the bit within the bank and may also have a value between 0 and 63.
|
| /Linux-v4.19/Documentation/devicetree/bindings/powerpc/4xx/ |
| D | hsta.txt | 6 between the plb4 and plb6 system buses to provide high speed data
7 transfer between memory and system peripherals as well as support for
|
| /Linux-v4.19/Documentation/devicetree/bindings/pwm/ |
| D | pwm-omap-dmtimer.txt | 11 - ti,prescaler: Should be a value between 0 and 7, see the timers datasheet
12 - ti,clock-source: Set dmtimer parent clock, values between 0 and 2:
|
| /Linux-v4.19/Documentation/devicetree/bindings/leds/backlight/ |
| D | pwm-backlight.txt | 13 - post-pwm-on-delay-ms: Delay in ms between setting an initial (non-zero) PWM
15 - pwm-off-delay-ms: Delay in ms between disabling the backlight using GPIO
25 - num-interpolated-steps: Number of interpolated steps between each value
|
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | da7219.txt | 59 - dlg,a-d-btn-thr : Impedance threshold between buttons A and D
61 - dlg,d-b-btn-thr : Impedance threshold between buttons D and B
63 - dlg,b-c-btn-thr : Impedance threshold between buttons B and C
65 - dlg,c-mic-btn-thr : Impedance threshold between button C and Mic
|
12345678910>>...54
