Searched refs:absent (Results 1 – 25 of 65) sorted by relevance
123
/Linux-v4.19/Documentation/devicetree/bindings/sound/ |
D | alc5623.txt | 11 Register. If absent or has the value of 0, the 15 Control Register. If absent or has value 0, the
|
D | wm8903.txt | 20 - micdet-cfg : Default register value for R6 (Mic Bias). If absent, the 24 absent, the default is 100. 27 be 5 entries long. If absent, no configuration of these registers is
|
D | wm8962.txt | 17 If absent, the default should be the register default. 20 be 6 entries long. If absent, no configuration of these registers is
|
D | wm8741.txt | 16 DIFF in register R8 (MODE_CONTROL_2). If absent, the default is 0, shall be:
|
D | wm8994.txt | 38 - wlf,gpio-cfg : A list of GPIO configuration register values. If absent, 44 WM8958. If absent the register defaults will be used.
|
D | fsl-sai.txt | 32 first for the fifo data. If this property is absent, 59 - If both fsl,sai-asynchronous and fsl,sai-synchronous-rx are absent, the
|
D | tdm-slot.txt | 18 to specify a explicit mapping of the channels and the slots. If it's absent
|
D | pcm512x.txt | 20 is absent the device will be configured to clock from BCLK. If pll-in
|
D | fsl,spdif.txt | 38 - big-endian : If this property is absent, the native endian mode
|
/Linux-v4.19/Documentation/devicetree/bindings/net/ |
D | ibm,emac.txt | 65 - phy-address : 1 cell, optional, MDIO address of the PHY. If absent, 68 for, used if phy-address is absent. bit 0x00000001 is 70 For Axon it can be absent, though my current driver 77 operations (if absent the value is the same as 78 rx-fifo-size). For Axon, either absent or 2048. 80 operations (if absent the value is the same as 81 tx-fifo-size). For Axon, either absent or 2048.
|
D | lpc-eth.txt | 10 absent, "rmii" is assumed.
|
D | ftgmac100.txt | 18 absent, "rgmii" is assumed. Supported values are "rgmii*" and "rmii" for
|
D | davinci_emac.txt | 22 If absent, davinci_emac driver defaults to 100/FULL.
|
D | fixed-link.txt | 15 used. When absent, half duplex is assumed.
|
/Linux-v4.19/Documentation/devicetree/bindings/powerpc/opal/ |
D | power-mgt.txt | 69 property. If the property is absent, the target residency for 76 This property is required on POWER9 and absent on POWER8. 82 required on POWER9 and absent on POWER8. 111 is an optional property on POWER8 and is absent on 118 property on POWER8 and is absent on POWER9.
|
/Linux-v4.19/Documentation/devicetree/bindings/arm/ |
D | l2c2x0.txt | 83 (forcibly enable), property absent (retain settings set by firmware) 85 <1> (forcibly enable), property absent (retain settings set by 88 disable), <1> (forcibly enable), property absent (OS specific behavior, 91 <1> (forcibly enable), property absent (OS specific behavior,
|
/Linux-v4.19/Documentation/devicetree/bindings/spi/ |
D | spi-bcm63xx.txt | 14 if absent.
|
D | spi-bcm63xx-hsspi.txt | 14 if absent.
|
/Linux-v4.19/Documentation/devicetree/bindings/display/ |
D | multi-inno,mi0283qt.txt | 13 - absent: IM=x101 3-wire 9-bit data serial interface
|
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-class-mtd | 107 absent, ram, rom, nor, nand, mlc-nand, dataflash, ubi, unknown 145 or exceeds this value, -EUCLEAN is returned. Otherwise, absent 170 returned, absent a hard error. 233 This attribute is absent on flash devices, so it can be used
|
/Linux-v4.19/Documentation/devicetree/bindings/gpio/ |
D | gpio_atmel.txt | 17 - #gpio-lines: Number of gpio if absent 32.
|
/Linux-v4.19/Documentation/extcon/ |
D | intel-int3496.txt | 19 be absent or invalid)
|
/Linux-v4.19/Documentation/devicetree/bindings/net/dsa/ |
D | qca8k.txt | 32 used. When absent, half duplex is assumed.
|
/Linux-v4.19/Documentation/devicetree/bindings/thermal/ |
D | qoriq-thermal.txt | 24 - little-endian : If present, the TMU registers are little endian. If absent,
|
/Linux-v4.19/Documentation/driver-api/ |
D | slimbus.rst | 84 Similarly, SLIMbus devices 'report absent' when they go down. A 'device_down' 85 callback notifies the driver when the device reports absent and its logical
|
123