Home
last modified time | relevance | path

Searched refs:RW (Results 1 – 25 of 76) sorted by relevance

1234

/Linux-v4.19/drivers/scsi/aic7xxx/
Daic79xx.reg101 access_mode RW
116 access_mode RW
133 access_mode RW
263 access_mode RW
281 access_mode RW
292 access_mode RW
302 access_mode RW
340 access_mode RW
350 access_mode RW
362 access_mode RW
[all …]
Daic7xxx.reg70 access_mode RW
87 access_mode RW
103 access_mode RW
182 access_mode RW
198 access_mode RW
221 access_mode RW
227 access_mode RW
240 access_mode RW
247 access_mode RW
256 access_mode RW
[all …]
/Linux-v4.19/Documentation/ABI/testing/
Dsysfs-devices-platform-trackpoint6 (RW) Trackpoint sensitivity.
13 (RW) Negative inertia factor. High values cause the cursor to
21 (RW) Backup range for z-axis press.
28 (RW) The drag hysteresis controls how hard it is to drag with
36 (RW) Minimum amount of force needed to trigger dragging.
43 (RW) Speed of the trackpoint cursor.
50 (RW) Minimum value for z-axis force required to trigger a press
58 (RW) The offset from the running average required to generate a
66 (RW) This attribute determines how sharp a press has to be in
74 (RW) Minimum curvature in degrees required to generate a double
[all …]
Dsysfs-bus-coresight-devices-etm3x5 Description: (RW) Enable/disable tracing on this specific trace entiry.
22 Description: (RW) Used in conjunction with @addr_idx. Specifies
33 Description: (RW) Used in conjunction with @addr_idx. Specifies the range of
41 Description: (RW) Used in conjunction with @addr_idx. Specifies the single
49 Description: (RW) Used in conjunction with @addr_idx. Specifies the single
57 Description: (RW) Used in conjunction with @addr_idx. Specifies the single
65 Description: (RW) Specifies the counter to work on.
71 Description: (RW) Used in conjunction with cntr_idx, give access to the
78 Description: (RW) Used in conjunction with cntr_idx, give access to the
85 Description: (RW) Used in conjunction with cntr_idx, give access to the
[all …]
Dsysfs-bus-coresight-devices-etm4x5 Description: (RW) Enable/disable tracing on this specific trace entiry.
90 Description: (RW) Controls various modes supported by this ETM, for example
98 Description: (RW) Controls which PE to trace.
104 Description: (RW) Controls the tracing of arbitrary events from bank 0 to 3.
110 Description: (RW) Controls the behavior of the events in bank 0 to 3.
116 Description: (RW) Controls the insertion of global timestamps in the trace
123 Description: (RW) Controls how often trace synchronization requests occur.
129 Description: (RW) Sets the threshold value for cycle counting.
135 Description: (RW) Controls which regions in the memory map are enabled to
142 Description: (RW) Controls instruction trace filtering.
[all …]
Dsysfs-driver-hid-ntrig6 (RW) Number of contact frames ignored before acknowledging the
15 (RW) Number of empty (no contact) frames ignored before
32 activation_width: (RW) Width threshold to immediately
35 activation_height: (RW) Height threshold to immediately
47 min_width: (RW) Minimum touch contact width to decide
50 min_height: (RW) Minimum touch contact height to decide
Dsysfs-bus-coresight-devices-stm5 Description: (RW) Enable/disable tracing on this specific trace macrocell.
15 Description: (RW) Provides access to the HW event enable register, used in
22 Description: (RW) Gives access to the HW event block select register
30 Description: (RW) Provides access to the stimulus port enable register
38 Description: (RW) Used to determine which bank of stimulus port bit in
52 Description: (RW) Holds the trace ID that will appear in the trace stream
Dsysfs-bus-intel_th-devices-gth5 Description: (RW) Configure output ports for STP masters. Writing -1
22 Description: (RW) Data retention policy setting: keep (0) or drop (1)
29 Description: (RW) STP NULL packet generation: enabled (1) or disabled (0).
35 Description: (RW) Force flush data from byte packing buffer for the output
48 Description: (RW) STP sync packet frequency for the port. Specifies the
Dsysfs-bus-intel_th-devices-pti5 Description: (RW) Configure PTI output width. Currently supported values
12 Description: (RW) 0: PTI trace clock acts as a strobe which only toggles
20 Description: (RW) Configure PTI port clock divider:
Dsysfs-bus-intel_th-devices-msc5 Description: (RW) Configure MSC buffer wrapping. 1 == wrapping enabled.
11 Description: (RW) Configure MSC operating mode:
24 Description: (RW) Configure MSC buffer size for "single" or "multi" modes.
Dsysfs-bus-coresight-devices-funnel5 Description: (RW) Enables the slave ports and defines the hold time of the
12 Description: (RW) Defines input port priority order.
Dsysfs-devices-platform-ACPI-TAD26 (RW) The AC alarm timer value.
43 (RW) The AC alarm expired timer wake policy (see ACPI 6.2,
59 (RW) The AC alarm status.
85 (RW,optional) The DC alarm timer value.
96 (RW,optional) The DC alarm expired timer wake policy.
108 (RW,optional) The DC alarm status.
Dsysfs-class-backlight-adp886024 (RW) Read or write the specific level at which the backlight
37 (RW) Maximum current setting for the backlight when brightness
51 (RW) Dim current setting for the backlight when brightness is at
Dsysfs-block-device6 (RW) Used by drivers which support software controlled activity
26 (RW) Hard disk shock protection
56 (RW) Write to the file to turn on or off the SATA ncq (native
/Linux-v4.19/Documentation/hwmon/
Dmax663930 temp1_max RW Set THERM temperature for input 1
32 temp2_max RW Set THERM temperature for input 2
33 temp1_crit RW Set ALERT temperature for input 1
34 temp2_crit RW Set ALERT temperature for input 2
35 temp1_emergency RW Set OT temperature for input 1
37 temp2_emergency RW Set OT temperature for input 2
38 pwm1 RW Fan 1 target duty cycle (0..255)
39 pwm2 RW Fan 2 target duty cycle (0..255)
Dsysfs-interface74 RW read/write value
97 RW
108 RW
112 RW
119 RW
123 RW
179 RW
187 RW (but changing it should no more be necessary)
203 RW
208 RW
[all …]
Ddme1737218 vrm RW Voltage regulator module version
222 in[0-7]_min RW Low limit for voltage input.
223 in[0-7]_max RW High limit for voltage input.
230 temp[1-3]_min RW Low limit for temp input.
231 temp[1-3]_max RW High limit for temp input.
232 temp[1-3]_offset RW Offset for temp input. This value will
248 zone[1-3]_auto_point1_temp_hyst RW Auto PWM temp point1 hysteresis. The
253 zone[1-3]_auto_point[1-3]_temp RW Auto PWM temp points. Auto_point1 is
260 fan[1-6]_min RW Low limit for fan input.
264 fan[1-4]_type RW Type of attached fan. Expressed in
[all …]
Dmax3179035 fan[1-6]_target RW desired fan speed in RPM
36 pwm[1-6]_enable RW regulator mode, 0=disabled, 1=manual mode, 2=rpm mode
37 pwm[1-6] RW fan target duty cycle (0-255)
Djc4294 temp1_min Minimum temperature (RO or RW)
95 temp1_max Maximum temperature (RO or RW)
96 temp1_crit Critical high temperature (RO or RW)
98 temp1_crit_hyst Critical hysteresis temperature (RO or RW)
/Linux-v4.19/Documentation/misc-devices/
Dbh1770glc.txt51 RW - enable / disable chip. Uses counting logic
63 RW - measurement rate in Hz
69 RW - HI level threshold value. All results above the value
74 RW - LO level threshold value. All results below the value
78 RW - calibration value. Set to neutral value by default.
93 RW - enable / disable proximity - uses counting logic
98 RW - number of proximity interrupts needed before triggering the event
101 RW - Measurement rate (in Hz) when the level is above threshold
105 RW - Measurement rate (in Hz) when the level is below threshold
112 RW - threshold level which trigs proximity events.
[all …]
Dapds990x.txt52 RW - enable / disable chip. Uses counting logic
65 RW - measurement rate in Hz
71 RW - calibration value. Set to neutral value by default.
79 RW - HI level threshold value. All results above the value
84 RW - LO level threshold value. All results below the value
95 RW - enable / disable proximity - uses counting logic
100 RW - trigger / periodic. In "trigger" mode the driver tells two possible
111 RW - threshold level which trigs proximity events.
/Linux-v4.19/Documentation/cdrom/
Dpacket-writing.txt12 - Grab a new CD-RW disc and format it (assuming CD-RW is hdc, substitute
23 Packet writing for DVD-RW media
26 DVD-RW discs can be written to much like CD-RW discs if they are in
32 You can then use the disc the same way you would use a CD-RW disc:
38 Packet writing for DVD+RW media
41 According to the DVD+RW specification, a drive supporting DVD+RW discs
70 in the same way it does for DVD+RW media.
76 - CD-RW media can usually not be overwritten more than about 1000
131 See http://fy.chalmers.se/~appro/linux/DVD+RW/ for more information
/Linux-v4.19/Documentation/block/
Dqueue-sysfs.txt9 Files denoted with a RO postfix are readonly and the RW postfix means
12 add_random (RW)
38 discard_max_bytes (RW)
50 io_poll (RW)
56 io_poll_delay (RW)
70 iostats (RW)
88 max_sectors_kb (RW)
106 nomerges (RW)
114 nr_requests (RW)
136 read_ahead_kb (RW)
[all …]
/Linux-v4.19/Documentation/input/devices/
Dsentelic.rst731 0x8201 bit7~bit0 RW version ID
741 0x8204 bit3~bit0 0x01 RW revision ID
749 bit2 0 RW 1: rotate 180 degree
753 bit0 0 RW 1 to enable page 1 register files
756 0x8210 RW system control 1
757 bit0 1 RW Reserved, must be 1
758 bit1 0 RW Reserved, must be 0
759 bit4 0 RW Reserved, must be 0
760 bit5 1 RW register clock gating enable
775 0x8231 RW on-pad command detection
[all …]
/Linux-v4.19/arch/m68k/kernel/
Dtraps.c391 ssw & RW ? "read" : "write", in bus_error030()
403 if (mmu_emu_handle_fault (fp->un.fmtb.daddr, ssw & RW, 0)) in bus_error030()
412 if (mmu_emu_handle_fault (fp->un.fmtb.daddr, ssw & RW, 1)) in bus_error030()
427 ssw & RW ? "read" : "write", in bus_error030()
463 !(ssw & RW) ? "write" : "read", addr, in bus_error030()
471 if (!(ssw & RW) || ssw & RM) in bus_error030()
522 ssw & RW ? "read" : "write", in bus_error030()
549 if (!(ssw & RW) || (ssw & RM)) in bus_error030()
555 ssw & RW ? "read" : "write", in bus_error030()
571 !(ssw & RW) ? "write" : "read", addr, in bus_error030()
[all …]

1234