| /Linux-v4.19/Documentation/spi/ |
| D | spi-lm70llp | 42 D7 9 --> SI/O 5
48 is connected to both pin D7 (as Master Out) and Select (as Master In)
61 transistor Q1 (and also a pullup, and a zener diode to D7); while the
65 and not grounded by the host via D7), the transistor conducts and switches
|
| D | butterfly | 35 MOSI = J403.PB2/MOSI = pin 9/D7
|
| /Linux-v4.19/Documentation/devicetree/bindings/leds/ |
| D | leds-lp55xx.txt | 23 1: D1~6 with VDD, D7~9 with VOUT
24 2: D1~6 with VOUT, D7~9 with VDD
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | socfpga_cyclone5_socrates.dts | 70 label = "led:green:D7";
|
| D | aspeed-bmc-opp-zaius.dts | 362 pins = "A8", "C7", "B7", "A7", "D7", "B6", "A6", "E7";
|
| D | omap3-beagle-xm.dts | 51 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */
|
| D | omap3-beagle.dts | 47 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */
|
| D | qcom-apq8060-dragonboard.dts | 128 /* SDC1 D0 to D7 */
|
| /Linux-v4.19/Documentation/networking/ |
| D | PLIP.txt | 143 D5,D6,D7 are 7*, 8*, 9*
175 D7->D7 9 - 9
|
| /Linux-v4.19/Documentation/i2c/busses/ |
| D | i2c-parport | 81 - Pins 4-9 (D2-D7) could be used as VDD is the driver drives them high.
82 The ADM1032 evaluation board uses D4-D7. Beware that the amount of
|
| /Linux-v4.19/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxl-s905x-khadas-vim.dts | 146 "eMMC D4", "eMMC D5", "eMMC D6", "eMMC D7",
|
| D | meson-gxl-s905x-libretech-cc.dts | 196 "eMMC D4", "eMMC D5", "eMMC D6", "eMMC D7",
|
| D | meson-gxbb-odroidc2.dts | 211 "eMMC D5", "eMMC D6", "eMMC D7", "eMMC Clk",
|
| D | meson-gxbb-nanopi-k2.dts | 216 "eMMC D5", "eMMC D6", "eMMC D7", "eMMC Clk",
|
| /Linux-v4.19/Documentation/driver-api/iio/ |
| D | buffers.rst | 60 |D11|D10|D9 |D8 |D7 |D6 |D5 |D4 | (HIGH byte, address 0x07)
|
| /Linux-v4.19/Documentation/xtensa/ |
| D | mmu.txt | 37 80..9F -> 80 -> 80 -> 80 D0..D7 -> 00 -> 00
|
| /Linux-v4.19/arch/m68k/fpsp040/ |
| D | binstr.S | 21 | A1. Init d7 to 1. D7 is the byte digit counter, and if 1, the
|
| D | bindec.S | 18 | Saves and Modifies: D2-D7,A2,FP2
|
| /Linux-v4.19/Documentation/ABI/stable/ |
| D | sysfs-class-tpm | 134 D7 0E 7D CA 41 BF 43 07 65 86 3C 8C 13 7A D0 8B
|
| /Linux-v4.19/drivers/pinctrl/aspeed/ |
| D | pinctrl-aspeed-g5.c | 1112 #define D7 157 macro
1116 MS_PIN_DECL_(D7, SIG_EXPR_LIST_PTR(GPIOT5), SIG_EXPR_LIST_PTR(RMII1DASH1),
1204 FUNC_GROUP_DECL(RGMII1, B4, A4, A3, D6, C5, C4, B5, E9, F9, A5, E7, D7);
1860 ASPEED_PINCTRL_PIN(D7),
2414 { PIN_CONFIG_BIAS_PULL_DOWN, { B5, D7 }, SCU90, 12 },
2415 { PIN_CONFIG_BIAS_DISABLE, { B5, D7 }, SCU90, 12 },
|
| D | pinctrl-aspeed-g4.c | 470 #define D7 60 macro
475 MS_PIN_DECL(D7, GPIOH4, ROMD12, NDTR6);
498 FUNC_GROUP_DECL(UART6, A8, C7, B7, A7, D7, B6, A6, E7);
1708 A8, C7, B7, A7, D7, B6, A6, E7, W21, Y22, U19, R22, P18, P19,
1850 ASPEED_PINCTRL_PIN(D7),
|
| /Linux-v4.19/Documentation/pps/ |
| D | pps.txt | 217 9 D7 * | *
|
| /Linux-v4.19/drivers/pinctrl/sh-pfc/ |
| D | pfc-r8a77970.c | 203 #define IP6_3_0 FM(VI1_DATA4) FM(CANFD_CLK_B) F_(0, 0) FM(D7) FM(MMC_D2) F_(0, 0) F_(0, 0) F_…
599 PINMUX_IPSR_GPSR(IP6_3_0, D7),
|
| D | pfc-r8a77990.c | 46 #define GPSR0_7 F_(D7, IP6_19_16)
236 #define IP6_19_16 FM(D7) FM(CANFD1_RX) FM(IRQ5) FM(CAN1_RX) FM(CTS3_N_A) F_(0, 0) F_(0, 0) FM…
849 PINMUX_IPSR_GPSR(IP6_19_16, D7),
|
| /Linux-v4.19/Documentation/input/devices/ |
| D | joystick-parport.rst | 598 2-9 D0-D7 Data Bit 0-7
|
