Searched full:sideband (Results 1 – 25 of 77) sorted by relevance
1234
| /Linux-v5.15/Documentation/devicetree/bindings/pci/ |
| D | pci-msi.txt | 16 MSIs may be distinguished in part through the use of sideband data accompanying
17 writes. In the case of PCI devices, this sideband data may be derived from the
19 controllers it can address, and the sideband data that will be associated with
53 the root complex and MSI controller do not pass sideband data with MSI
79 * The sideband data provided to the MSI controller is
107 * The sideband data provided to the MSI controller is
136 * The sideband data provided to the MSI controller is
166 * The sideband data provided to the MSI controller is
210 * The sideband data provided to MSI controller a is the
212 * The sideband data provided to MSI controller b is the
|
| D | pci-iommu.txt | 16 IOMMUs may distinguish PCI devices through sideband data derived from the
22 and a mechanism is required to map from a PCI device to its IOMMU and sideband
67 * The sideband data provided to the IOMMU is the RID,
94 * The sideband data provided to the IOMMU is the RID with the
122 * The sideband data provided to the IOMMU is the RID,
163 * a, with sideband data being RID[14:0].
165 * IOMMU b, with sideband data being RID[14:0].
|
| D | brcm,iproc-pcie.txt | 53 sideband data
56 sideband data is passed between the iProc PCIe controller and the MSI
|
| D | xilinx-versal-cpm.yaml | 34 Maps a Requester ID to an MSI controller and associated MSI sideband data.
|
| /Linux-v5.15/drivers/net/ethernet/intel/ice/ |
| D | ice_sbq_cmd.h | 7 /* This header file defines the Sideband Queue commands, error codes and
11 /* Sideband Queue command structure and opcodes */
13 /* Sideband Queue commands */
18 /* Sideband Queue descriptor. Indirect command
|
| D | ice_controlq.c | 55 * ice_sb_init_regs - Initialize Sideband registers
666 * ice_is_sbq_supported - is the sideband queue supported
669 * Returns true if the sideband control queue interface is
674 /* The device sideband queue is only supported on devices with the in ice_is_sbq_supported()
681 * ice_get_sbq - returns the right control queue to use for sideband
734 /* Shutdown PHY Sideband */ in ice_shutdown_all_ctrlq()
776 /* sideband control queue (SBQ) interface is not supported on some in ice_init_all_ctrlq()
|
| /Linux-v5.15/drivers/net/wireless/broadcom/brcm80211/include/ |
| D | brcmu_d11.h | 14 * bandwidth and control sideband
31 * bit 8~9 sideband
52 * bit 8~10 sideband
128 * @sb: control sideband (location of control channel against the center one)
|
| /Linux-v5.15/Documentation/devicetree/bindings/interrupt-controller/ |
| D | msi.txt | 24 - Sideband information accompanying the write.
47 Typically this will encode information related to sideband data, and will
58 generate, the doorbell and payload may be configured, though sideband
89 /* No sideband data, so #msi-cells omitted */
|
| /Linux-v5.15/sound/soc/sof/intel/ |
| D | hda-ipc.h | 16 * - DIPCTDR (HIPCIDR) in sideband IPC (cAVS 1.8+)
20 * - DIPCTDD (HIPCIDD) in sideband IPC (cAVS 1.8+)
|
| /Linux-v5.15/drivers/gpu/drm/i915/ |
| D | intel_sideband.c | 31 * IOSF sideband, see VLV2_SidebandMsg_HAS.docx and
53 * Prevent the cpu from sleeping while we use this sideband, otherwise in __vlv_punit_get()
60 * to the Valleyview P-unit and not all sideband communications. in __vlv_punit_get()
109 drm_dbg(&i915->drm, "IOSF sideband idle wait (%s) timed out\n", in vlv_sideband_rw()
133 drm_dbg(&i915->drm, "IOSF sideband finish wait (%s) timed out\n", in vlv_sideband_rw()
|
| /Linux-v5.15/drivers/net/ethernet/apm/xgene/ |
| D | xgene_enet_cle.c | 653 /* Sideband: IPV4/TCP packets */ in xgene_cle_set_rss_sband()
658 /* Sideband: IPv4/UDP packets */ in xgene_cle_set_rss_sband()
667 /* Sideband: IPv4/RAW packets */ in xgene_cle_set_rss_sband()
673 /* Sideband: Ethernet II/RAW packets */ in xgene_cle_set_rss_sband()
748 /* setup sideband data */ in xgene_cle_setup_rss()
|
| D | xgene_enet_cle.h | 175 /* RSS sideband signal info */
|
| /Linux-v5.15/net/ncsi/ |
| D | Kconfig | 10 This module provides NCSI (Network Controller Sideband Interface)
|
| /Linux-v5.15/Documentation/devicetree/bindings/misc/ |
| D | fsl,qoriq-mc.txt | 31 The MSI writes are accompanied by sideband data which is derived from the ICID.
33 controller and the sideband data which accompanies the writes.
|
| /Linux-v5.15/drivers/thunderbolt/ |
| D | sb_regs.h | 3 * USB4 port sideband registers found on routers and retimers
|
| D | usb4.c | 1398 * usb4_port_retimer_set_inbound_sbtx() - Enable sideband channel transactions
1402 * Enables sideband channel transations on SBTX. Can be used when USB4
1425 * usb4_port_retimer_read() - Read from retimer sideband registers
1428 * @reg: Sideband register to read
1432 * Function reads retimer sideband registers starting from @reg. The
1446 * usb4_port_retimer_write() - Write to retimer sideband registers
1449 * @reg: Sideband register to write
1453 * Writes retimer sideband registers starting from @reg. The retimer is
|
| D | retimer.c | 447 * Brings the sideband into a state where retimers can be accessed.
466 * Enable sideband channel for each retimer. We can do this in tb_retimer_scan()
|
| /Linux-v5.15/Documentation/networking/device_drivers/ethernet/intel/ |
| D | i40e.rst | 172 Director rule is added from ethtool (Sideband filter), ATR is turned off by the
173 driver. To re-enable ATR, the sideband can be disabled with the ethtool -K
178 If sideband is re-enabled after ATR is re-enabled, ATR remains enabled until a
179 TCP-IP flow is added. When all TCP-IP sideband rules are deleted, ATR is
185 Sideband Perfect Filters
187 Sideband Perfect Filters are used to direct traffic that matches specified
709 Center Bridging (DCB), Multiple Functions per Port (MFP), or Sideband
|
| /Linux-v5.15/Documentation/devicetree/bindings/hwmon/ |
| D | amd,sbrmi.yaml | 8 Sideband Remote Management Interface (SB-RMI) compliant
|
| D | amd,sbtsi.yaml | 8 Sideband interface Temperature Sensor Interface (SB-TSI) compliant
|
| /Linux-v5.15/Documentation/hwmon/ |
| D | sbtsi_temp.rst | 8 * Sideband interface (SBI) Temperature Sensor Interface (SB-TSI)
|
| D | sbrmi.rst | 8 * Sideband Remote Management Interface (SB-RMI) compliant AMD SoC
|
| /Linux-v5.15/include/drm/ |
| D | drm_dp_mst_helper.h | 167 /* sideband msg header - not bit struct */
514 /* sideband msg handler */
714 * @tx_work: Sideband transmit worker. This can nest within the main
758 * topology. Needed to avoid blocking hotplug handling and sideband
|
| /Linux-v5.15/arch/powerpc/platforms/ |
| D | fsl_uli1575.c | 263 /* Enable sideband interrupt */ in hpcd_quirk_uli1575()
291 * IRQ14 is a sideband interrupt from IDE device to CPU and we use this
|
| /Linux-v5.15/Documentation/userspace-api/media/v4l/ |
| D | vidioc-enum-freq-bands.rst | 122 - Vestigial Sideband modulation, used for analog TV.
|
1234
