Searched full:latching (Results 1 – 25 of 35) sorted by relevance
12
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | tlv320adcx140.yaml | 75 PDMIN1 - PDMCLK latching edge used for channel 1 and 2 data
76 PDMIN2 - PDMCLK latching edge used for channel 3 and 4 data
77 PDMIN3 - PDMCLK latching edge used for channel 5 and 6 data
78 PDMIN4 - PDMCLK latching edge used for channel 7 and 8 data
|
| /Linux-v6.1/Documentation/devicetree/bindings/soc/imx/ |
| D | fsl,imx93-src.yaml | 14 all the system reset signals and boot argument latching.
|
| /Linux-v6.1/Documentation/devicetree/bindings/reset/ |
| D | renesas,rst.yaml | 16 - Latching of the levels on mode pins when PRESET# is negated,
|
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | pincfg-node.yaml | 149 and the delay before latching a value to an output
|
| /Linux-v6.1/drivers/staging/fbtft/ |
| D | fbtft.h | 172 * @gpio.rd: Read latching signal
173 * @gpio.wr: Write latching signal
|
| /Linux-v6.1/drivers/clocksource/ |
| D | i8253.c | 52 * before latching the timer count to guarantee that although in i8253_read()
|
| /Linux-v6.1/arch/mips/loongson2ef/common/cs5536/ |
| D | cs5536_mfgpt.c | 157 * before latching the timer count to guarantee that although in mfgpt_read()
|
| /Linux-v6.1/arch/mips/loongson32/common/ |
| D | time.c | 78 * before latching the timer count to guarantee that although in ls1x_clocksource_read()
|
| /Linux-v6.1/drivers/hwmon/ |
| D | sbtsi_temp.c | 85 * reading integer part triggers latching of the decimal part, in sbtsi_read()
|
| /Linux-v6.1/drivers/gpu/drm/i915/display/ |
| D | intel_vrr.c | 157 * earliest/latest points for register latching regardless in intel_vrr_compute_config()
|
| /Linux-v6.1/drivers/net/ethernet/chelsio/cxgb3/ |
| D | aq100x.c | 114 /* Read (and reset) the latching version of the status */ in aq100x_intr_handler()
|
| D | ael1002.c | 695 * The GPIO Interrupt register on the AEL2020 is a "Latching High" in ael2020_intr_clear()
|
| /Linux-v6.1/drivers/net/ethernet/sfc/falcon/ |
| D | io.h | 57 * doorbell register pair, which has its own latching, and
|
| /Linux-v6.1/drivers/cpufreq/ |
| D | sa1110-cpufreq.c | 156 * half speed or use delayed read latching (errata 13). in sdram_calculate_timing()
|
| /Linux-v6.1/drivers/net/ethernet/sfc/siena/ |
| D | io.h | 57 * doorbell register pair, which has its own latching, and
|
| /Linux-v6.1/drivers/net/ethernet/sfc/ |
| D | io.h | 57 * doorbell register pair, which has its own latching, and
|
| /Linux-v6.1/drivers/iio/imu/bmi160/ |
| D | bmi160_core.c | 599 /* Set the pin to input mode with no latching. */ in bmi160_config_pin()
|
| /Linux-v6.1/sound/soc/codecs/ |
| D | tas5720.c | 256 * Periodically toggle SDZ (shutdown bit) H->L->H to clear any latching in tas5720_fault_check_work()
|
| /Linux-v6.1/drivers/mmc/host/ |
| D | meson-mx-sdhc-mmc.c | 293 * according to Amlogic the following latching points are in meson_mx_sdhc_set_clk()
|
| /Linux-v6.1/drivers/net/ethernet/cavium/thunder/ |
| D | thunder_bgx.c | 890 /* Clear rcvflt bit (latching high) and read it back */ in bgx_xaui_check_link()
1005 /* Receive link is latching low. Force it high and verify it */ in bgx_poll_for_link()
|
| /Linux-v6.1/drivers/staging/media/deprecated/vpfe_capture/ |
| D | dm355_ccdc.c | 526 * disable latching function on VSYNC - shadowed registers in ccdc_config_raw()
|
| D | dm644x_ccdc.c | 385 /* Disable latching function registers on VSYNC */ in ccdc_config_raw()
|
| /Linux-v6.1/drivers/net/ethernet/faraday/ |
| D | ftgmac100.c | 1247 * the HW has been latching RX/TX packet interrupts while in ftgmac100_poll()
|
| /Linux-v6.1/drivers/tty/serial/ |
| D | sc16is7xx.c | 238 #define SC16IS7XX_IOCONTROL_LATCH_BIT (1 << 0) /* Enable input latching */
|
| /Linux-v6.1/drivers/platform/x86/intel/pmc/ |
| D | core.c | 1719 * For LPM mode latching we set the latch enable bit and selected mode in pmc_core_lpm_latch_mode_write()
|
12
