Home
last modified time | relevance | path

Searched +full:input +full:- +full:justification (Results 1 – 13 of 13) sorted by relevance

/Linux-v6.1/Documentation/devicetree/bindings/display/bridge/
Dadi,adv7511.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Laurent Pinchart <laurent.pinchart@ideasonboard.com>
15 space conversion, S/PDIF, CEC and HDCP. The transmitter input is
21 - adi,adv7511
22 - adi,adv7511w
23 - adi,adv7513
37 reg-names:
40 needing a non-default address.
[all …]
/Linux-v6.1/include/sound/
Dcs8427.h1 /* SPDX-License-Identifier: GPL-2.0-or-later */
14 #define CS8427_REG_AUTOINC 0x80 /* flag - autoincrement */
34 #define CS8427_REG_QSUBCODE 0x14 /* 0x14-0x1d (10 bytes) */
48 #define CS8427_TCBLDIR (1<<0) /* 0 = TCBL is an input, 1 = TCBL is an output */
63 #define CS8427_AESBP (1<<5) /* AES3 hardware bypass mode, 0 = normal, 1 = bypass (RX->TX) */
65 #define CS8427_TXDSERIAL (1<<3) /* TXD - serial audio input port */
66 #define CS8427_TXAES3DRECEIVER (2<<3) /* TXD - AES3 receiver */
68 #define CS8427_SPDSERIAL (1<<1) /* SPD - serial audio input port */
69 #define CS8427_SPDAES3RECEIVER (2<<1) /* SPD - AES3 receiver */
77 #define CS8427_OUTC (1<<3) /* Output Time Base, 0 = OMCK, 1 = recovered input clock */
[all …]
/Linux-v6.1/Documentation/devicetree/bindings/i2c/
Di2c-demux-pinctrl.txt1 Pinctrl-based I2C Bus DeMux
10 +-------------------------------+
12 | | +-----+ +-----+
13 | +------------+ | | dev | | dev |
14 | |I2C IP Core1|--\ | +-----+ +-----+
15 | +------------+ \-------+ | | |
16 | |Pinctrl|--|------+--------+
17 | +------------+ +-------+ |
18 | |I2C IP Core2|--/ |
19 | +------------+ |
[all …]
/Linux-v6.1/arch/arm/boot/dts/
Dzynq-zc706.dts1 // SPDX-License-Identifier: GPL-2.0
3 * Copyright (C) 2011 - 2014 Xilinx
6 /dts-v1/;
7 #include "zynq-7000.dtsi"
11 compatible = "xlnx,zynq-zc706", "xlnx,zynq-7000";
27 stdout-path = "serial0:115200n8";
31 compatible = "usb-nop-xceiv";
32 #phy-cells = <0>;
37 ps-clk-frequency = <33333333>;
42 phy-mode = "rgmii-id";
[all …]
Dzynq-zc702.dts1 // SPDX-License-Identifier: GPL-2.0
3 * Copyright (C) 2011 - 2014 Xilinx
6 /dts-v1/;
7 #include "zynq-7000.dtsi"
11 compatible = "xlnx,zynq-zc702", "xlnx,zynq-7000";
27 stdout-path = "serial0:115200n8";
30 gpio-keys {
31 compatible = "gpio-keys";
33 switch-14 {
37 wakeup-source;
[all …]
/Linux-v6.1/drivers/gpu/drm/omapdrm/dss/
Dhdmi4_core.c1 // SPDX-License-Identifier: GPL-2.0-only
5 * Copyright (C) 2010-2011 Texas Instruments Incorporated - https://www.ti.com/
32 return core->base + HDMI_CORE_AV; in hdmi_av_base()
37 void __iomem *base = core->base; in hdmi4_core_ddc_init()
50 return -ETIMEDOUT; in hdmi4_core_ddc_init()
61 return -ETIMEDOUT; in hdmi4_core_ddc_init()
71 return -ETIMEDOUT; in hdmi4_core_ddc_init()
80 void __iomem *base = core->base; in hdmi4_core_ddc_read()
87 return -ETIMEDOUT; in hdmi4_core_ddc_read()
112 return -EIO; in hdmi4_core_ddc_read()
[all …]
/Linux-v6.1/drivers/video/fbdev/omap2/omapfb/dss/
Dhdmi4_core.c1 // SPDX-License-Identifier: GPL-2.0-only
6 * Copyright (C) 2010-2011 Texas Instruments Incorporated - https://www.ti.com/
33 return core->base + HDMI_CORE_AV; in hdmi_av_base()
38 void __iomem *base = core->base; in hdmi_core_ddc_init()
51 return -ETIMEDOUT; in hdmi_core_ddc_init()
62 return -ETIMEDOUT; in hdmi_core_ddc_init()
72 return -ETIMEDOUT; in hdmi_core_ddc_init()
81 void __iomem *base = core->base; in hdmi_core_ddc_edid()
90 return -ETIMEDOUT; in hdmi_core_ddc_edid()
118 return -EIO; in hdmi_core_ddc_edid()
[all …]
/Linux-v6.1/drivers/gpu/drm/bridge/adv7511/
Dadv7511.h1 /* SPDX-License-Identifier: GPL-2.0-only */
62 #define ADV7511_REG_GC(x) (0x4b + (x)) /* 0x4b - 0x51 */
66 #define ADV7511_REG_AVI_INFOFRAME(x) (0x55 + (x)) /* 0x55 - 0x6f */
70 #define ADV7511_REG_AUDIO_INFOFRAME(x) (0x73 + (x)) /* 0x73 - 0x7c */
77 #define ADV7511_REG_AN(x) (0xb0 + (x)) /* 0xb0 - 0xb7 */
80 #define ADV7511_REG_BKSV(x) (0xc0 + (x)) /* 0xc0 - 0xc3 */
84 #define ADV7511_REG_BSTATUS(x) (0xca + (x)) /* 0xca - 0xcb */
89 #define ADV7511_REG_SYNC_ADJUSTMENT(x) (0xd7 + (x)) /* 0xd7 - 0xdc */
251 * enum adv7511_sync_polarity - Polarity for the input sync signals
272 * struct adv7511_link_config - Describes adv7511 hardware configuration
[all …]
Dadv7511_drv.c1 // SPDX-License-Identifier: GPL-2.0-only
38 /* -----------------------------------------------------------------------------
131 /* -----------------------------------------------------------------------------
141 regmap_update_bits(adv7511->regmap, ADV7511_REG_CSC_UPPER(1), in adv7511_set_colormap()
146 regmap_update_bits(adv7511->regmap, in adv7511_set_colormap()
149 regmap_write(adv7511->regmap, in adv7511_set_colormap()
156 regmap_update_bits(adv7511->regmap, ADV7511_REG_CSC_UPPER(0), in adv7511_set_colormap()
159 regmap_update_bits(adv7511->regmap, ADV7511_REG_CSC_UPPER(0), in adv7511_set_colormap()
162 regmap_update_bits(adv7511->regmap, ADV7511_REG_CSC_UPPER(1), in adv7511_set_colormap()
169 regmap_update_bits(adv7511->regmap, ADV7511_REG_PACKET_ENABLE0, in adv7511_packet_enable()
[all …]
/Linux-v6.1/Documentation/virt/kvm/x86/
Dtimekeeping.rst1 .. SPDX-License-Identifier: GPL-2.0
4 Timekeeping Virtualization for X86-Based Architectures
32 information relevant to KVM and hardware-based virtualization.
41 2.1. i8254 - PIT
42 ----------------
46 channels which can be programmed to deliver periodic or one-shot interrupts.
53 The PIT uses I/O ports 0x40 - 0x43. Access to the 16-bit counters is done
56 has a connected gate input, required for modes 1 and 5. The gate line is
59 -------------- ----------------
61 | 1.1932 MHz|---------->| CLOCK OUT | ---------> IRQ 0
[all …]
/Linux-v6.1/drivers/gpu/drm/amd/amdgpu/
Damdgpu_ras.c94 if (ras_block->block >= AMDGPU_RAS_BLOCK_COUNT) in get_ras_block_str()
97 if (ras_block->block == AMDGPU_RAS_BLOCK__MCA) in get_ras_block_str()
98 return ras_mca_block_string[ras_block->sub_block_index]; in get_ras_block_str()
100 return ras_block_string[ras_block->block]; in get_ras_block_str()
140 amdgpu_ras_get_context(adev)->error_query_ready = ready; in amdgpu_ras_set_error_query_ready()
146 return amdgpu_ras_get_context(adev)->error_query_ready; in amdgpu_ras_get_error_query_ready()
156 if ((address >= adev->gmc.mc_vram_size) || in amdgpu_reserve_page_direct()
158 dev_warn(adev->dev, in amdgpu_reserve_page_direct()
159 "RAS WARN: input address 0x%llx is invalid.\n", in amdgpu_reserve_page_direct()
161 return -EINVAL; in amdgpu_reserve_page_direct()
[all …]
/Linux-v6.1/fs/
Dlocks.c1 // SPDX-License-Identifier: GPL-2.0-only
19 * - the root of a tree may be an applied or waiting lock.
20 * - every other node in the tree is a waiting lock that
72 #define IS_POSIX(fl) (fl->fl_flags & FL_POSIX)
73 #define IS_FLOCK(fl) (fl->fl_flags & FL_FLOCK)
74 #define IS_LEASE(fl) (fl->fl_flags & (FL_LEASE|FL_DELEG|FL_LAYOUT))
75 #define IS_OFDLCK(fl) (fl->fl_flags & FL_OFDLCK)
76 #define IS_REMOTELCK(fl) (fl->fl_pid <= 0)
80 return fl->fl_flags & (FL_UNLOCK_PENDING | FL_DOWNGRADE_PENDING); in lease_breaking()
85 if (fl->fl_flags & FL_UNLOCK_PENDING) in target_leasetype()
[all …]
/Linux-v6.1/tools/lib/bpf/
Dbtf.c1 // SPDX-License-Identifier: (LGPL-2.1 OR BSD-2-Clause)
34 /* raw BTF data in non-native endianness */
46 * +--------------------------------+
48 * +--------------------------------+
52 * types_data-+ |
53 * strs_data------------+
64 * +----------+ +---------+ +-----------+
66 * +----------+ +---------+ +-----------+
70 * types_data----+ |
71 * strset__data(strs_set)-----+
[all …]