Searched full:b00 (Results 1 – 25 of 139) sorted by relevance
123456
| /Linux-v6.1/drivers/misc/eeprom/ |
| D | digsy_mtc_eeprom.c | 65 GPIO_LOOKUP("gpio@b00", GPIO_EEPROM_CLK,
67 GPIO_LOOKUP("gpio@b00", GPIO_EEPROM_DI,
69 GPIO_LOOKUP("gpio@b00", GPIO_EEPROM_DO,
71 GPIO_LOOKUP("gpio@b00", GPIO_EEPROM_CS,
|
| /Linux-v6.1/drivers/pwm/ |
| D | pwm-imx-tpm.c | 160 * Assume reserved values (2b00 and 2b11) to yield in pwm_imx_tpm_get_state()
205 * if the PWM is disabled (CMOD[1:0] = 2b00), then MOD register in pwm_imx_tpm_apply_hw()
208 * if the PWM is enabled (CMOD[1:0] ≠ 2b00), the period length in pwm_imx_tpm_apply_hw()
225 * if the PWM is disabled (CMOD[1:0] = 2b00), then CnV register in pwm_imx_tpm_apply_hw()
228 * if the PWM is enabled (CMOD[1:0] ≠ 2b00), the duty length in pwm_imx_tpm_apply_hw()
|
| /Linux-v6.1/arch/powerpc/include/asm/ |
| D | pnv-ocxl.h | 20 * 0b00 Just invalidate TLB.
29 * 0b00 Invalidate just the target VA.
|
| /Linux-v6.1/drivers/zorro/ |
| D | zorro.ids | 107 0b00 2400zi [Modem]
319 0b00 Picasso II/II+ RAM [Graphics Card]
360 0b00 Piccolo SD64 [Graphics Card]
419 0b00 Blizzard 1230-II/Fastlane Z3/CyberSCSI/CyberStorm060 [Accelerator and/or SCSI Host Adapter]
474 2b00 SRAM [RAM Expansion]
|
| /Linux-v6.1/Documentation/devicetree/bindings/soc/fsl/cpm_qe/cpm/ |
| D | usb.txt | 11 reg = <11b60 18 8b00 100>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/arm/omap/ |
| D | prm-inst.txt | 26 prm_dsp2: prm@1b00 {
|
| /Linux-v6.1/Documentation/devicetree/bindings/spi/ |
| D | ralink,mt7621-spi.yaml | 48 spi@b00 {
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | qcom,spmi-clkdiv.txt | 45 pm8998_clk_divs: clock-controller@5b00 {
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | omap3430es1-clocks.dtsi | 33 gfx_cg1_ck: gfx_cg1_ck@b00 {
41 gfx_cg2_ck: gfx_cg2_ck@b00 {
|
| /Linux-v6.1/arch/powerpc/sysdev/ |
| D | rtc_cmos_setup.c | 30 np = of_find_compatible_node(NULL, NULL, "pnpPNP,b00"); in add_rtc()
|
| /Linux-v6.1/arch/arm64/tools/ |
| D | sysreg | 753 0b00 NONE
759 0b00 NONE
922 0b00 VPIPT
|
| /Linux-v6.1/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | pmc.txt | 59 power@b00 {
|
| /Linux-v6.1/include/uapi/linux/ |
| D | cciss_defs.h | 61 BYTE Mode:2; /* b00 */
|
| /Linux-v6.1/arch/mips/ralink/ |
| D | rt3883.c | 57 ralink_clk_add("10000b00.spi", sys_rate); in ralink_clk_init()
|
| D | rt305x.c | 124 ralink_clk_add("10000b00.spi", sys_rate); in ralink_clk_init()
|
| /Linux-v6.1/drivers/net/phy/ |
| D | motorcomm.c | 20 /* 2b00 25m from pll
|
| /Linux-v6.1/drivers/usb/host/ |
| D | octeon-hcd.h | 593 * - 2'b00: IN/OUT token
807 * * 2'b00: DATA0
1002 * * 2'b00: Reserved. This field yields undefined results.
1014 * * 2'b00: Control
1070 * * 2'b00: PHY clock is running at 30/60 MHz
1074 * * 2'b00: PHY clock is running at 30/60 MHz. When the
1211 * * 2'b00: Mid. This is the middle payload of this transaction
1249 * * 2'b00: DATA0
1364 * * 2'b00: High speed
1530 * - 2'b00: IN/OUT
|
| /Linux-v6.1/arch/powerpc/boot/dts/ |
| D | pdm360ng.dts | 191 psc@11b00 {
|
| D | amigaone.dts | 120 compatible = "pnpPNP,b00";
|
| D | tqm5200.dts | 81 gpio_simple: gpio@b00 {
|
| /Linux-v6.1/arch/powerpc/platforms/chrp/ |
| D | time.c | 47 rtcs = of_find_compatible_node(NULL, "rtc", "pnpPNP,b00"); in chrp_time_init()
|
| /Linux-v6.1/arch/powerpc/platforms/maple/ |
| D | time.c | 139 rtcs = of_find_compatible_node(NULL, "rtc", "pnpPNP,b00"); in maple_get_boot_time()
|
| /Linux-v6.1/drivers/net/mdio/ |
| D | mdio-aspeed.c | 25 #define MDIO_C45_OP_ADDR 0b00
|
| /Linux-v6.1/arch/powerpc/boot/dts/fsl/ |
| D | mpc8544ds.dtsi | 197 compatible = "pnpPNP,b00";
|
| /Linux-v6.1/arch/mips/boot/dts/ralink/ |
| D | mt7628a.dtsi | 186 spi: spi@b00 {
|
123456
