Searched full:advertises (Results 1 – 25 of 86) sorted by relevance
1234
182 # Test that when one device advertises a subset of speeds and another183 # advertises a specific speed (but all modes of this speed), the links221 # Test that when one device advertises a subset of speeds, the other
113 * Micron MTFC4GACAJCN-1M advertises TRIM but it does not seems to120 * Kingston EMMC04G-M627 advertises TRIM but it does not seems to
87 * if the other end also advertises Pause.
17 * IS25LP256 supports 4B opcodes, but the BFPT advertises in is25lp256_post_bfpt_fixups()
22 * seems that the F version advertises support for Fast Read 4-4-4 in in mx25l25635_post_bfpt_fixups()
472 * The BFPT table advertises a 512B or 256B page size depending on part but the705 * The xSPI Profile 1.0 table advertises the number of additional in s28hx_t_post_sfdp_fixup()
9 * System firmware advertises the address of the RCI2 Table via
74 /* Device advertises UAS but it is broken */ \
85 * @getmaxphase: Advertises maximum offset that can be provided
7 Switchtec device advertises a special management endpoint which
62 * if device advertises RX_MIN_ACTIVATETIME_CAPABILITY less than 1ms.
60 If the IB HW supports IPoIB stateless offloads, IPoIB advertises
24 * PSU advertises that all features are supported, in dps920ab_read_word_data()
129 than it advertises. The bLength field of each (sub) descriptor
63 which only advertises NETIF_F_IP[V6]_CSUM must still obey the csum_start and
16 * platform firmware advertises at least one persistent memory capable
128 * Check if firmware advertises firmware first mode. We need FF bit to be set
271 * but advertises itself as v5 as it does not support the v6 ISA. For
36 * can support it (based on the protocol version it advertises).
16 Realtek advertises these chips as fast/gigabit switches or unmanaged
33 * have an interrupt. QEMU advertises this by using a GSI of zero, in arm_pmu_acpi_register_irq()
45 * advertises it via xenstore as 0 (disabled) or 1 (enabled).125 * it may set "request-multicast-control". If the backend only advertises129 * value will have no effect. However, if the backend also advertises
25 /* Actually, it advertises itself as a Logitech */
371 netdev_warn(netdev, "Device advertises both TSO2 and TXVLAN. Refusing to enable TXVLAN.\n"); in nfp_repr_init()
584 * registration as IN6ADDR_ANY. The former advertises an RPC586 * advertises the service on all IPv4 and IPv6 addresses.
