| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | qcom,tcsr.yaml | 4 $id: http://devicetree.org/schemas/mfd/qcom,tcsr.yaml#
20 - qcom,msm8998-tcsr
21 - qcom,qcs404-tcsr
22 - qcom,sc7180-tcsr
23 - qcom,sc7280-tcsr
24 - qcom,sdm630-tcsr
25 - qcom,sdm845-tcsr
26 - qcom,sm8150-tcsr
27 - qcom,tcsr-apq8064
28 - qcom,tcsr-apq8084
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/hwlock/ |
| D | qcom-hwspinlock.yaml | 21 - qcom,tcsr-mutex
24 - qcom,apq8084-tcsr-mutex
25 - qcom,ipq6018-tcsr-mutex
26 - qcom,msm8226-tcsr-mutex
27 - qcom,msm8994-tcsr-mutex
28 - const: qcom,tcsr-mutex
31 - qcom,msm8974-tcsr-mutex
32 - const: qcom,tcsr-mutex
51 compatible = "qcom,tcsr-mutex";
|
| /Linux-v6.1/drivers/soc/qcom/ |
| D | qcom_gsbi.c | 114 struct regmap *tcsr; member
118 { .compatible = "qcom,tcsr-ipq8064", .data = &config_ipq8064},
119 { .compatible = "qcom,tcsr-apq8064", .data = &config_apq8064},
120 { .compatible = "qcom,tcsr-msm8960", .data = &config_msm8960},
121 { .compatible = "qcom,tcsr-msm8660", .data = &config_msm8660},
145 /* get the tcsr node and setup the config and regmap */ in gsbi_probe()
146 gsbi->tcsr = syscon_regmap_lookup_by_phandle(node, "syscon-tcsr"); in gsbi_probe()
148 if (!IS_ERR(gsbi->tcsr)) { in gsbi_probe()
149 tcsr_node = of_parse_phandle(node, "syscon-tcsr", 0); in gsbi_probe()
155 dev_warn(&pdev->dev, "no matching TCSR\n"); in gsbi_probe()
[all …]
|
| D | cpr.c | 237 struct regmap *tcsr; member
393 static void cpr_set_acc(struct regmap *tcsr, struct fuse_corner *f, in cpr_set_acc() argument
401 regmap_multi_reg_write(tcsr, f->accs, f->num_accs); in cpr_set_acc()
404 regmap_multi_reg_write(tcsr, f->accs, f->num_accs); in cpr_set_acc()
414 if (drv->tcsr && dir == DOWN) in cpr_pre_voltage()
415 cpr_set_acc(drv->tcsr, prev_fuse_corner, fuse_corner); in cpr_pre_voltage()
426 if (drv->tcsr && dir == UP) in cpr_post_voltage()
427 cpr_set_acc(drv->tcsr, prev_fuse_corner, fuse_corner); in cpr_post_voltage()
1539 regmap_multi_reg_write(drv->tcsr, acc_desc->config, in cpr_pd_attach_dev()
1544 regmap_update_bits(drv->tcsr, acc_desc->enable_reg, in cpr_pd_attach_dev()
[all …]
|
| /Linux-v6.1/include/clocksource/ |
| D | timer-xilinx.h | 51 * @tcsr: The value of the TCSR register for this counter
59 u32 xilinx_timer_tlr_cycles(struct xilinx_timer_priv *priv, u32 tcsr,
66 * @tcsr: The value of TCSR for this counter
71 u32 tlr, u32 tcsr);
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | qcom-msm8660.dtsi | 149 syscon-tcsr = <&tcsr>;
175 syscon-tcsr = <&tcsr>;
201 syscon-tcsr = <&tcsr>;
236 syscon-tcsr = <&tcsr>;
270 syscon-tcsr = <&tcsr>;
295 syscon-tcsr = <&tcsr>;
624 tcsr: syscon@1a400000 { label
625 compatible = "qcom,tcsr-msm8660", "syscon";
|
| D | qcom-ipq8064.dtsi | 776 syscon-tcsr = <&tcsr>;
815 syscon-tcsr = <&tcsr>;
852 syscon-tcsr = <&tcsr>;
888 syscon-tcsr = <&tcsr>;
931 syscon-tcsr = <&tcsr>;
990 syscon-tcsr = <&tcsr>;
1029 tcsr: syscon@1a400000 { label
1030 compatible = "qcom,tcsr-ipq8064", "syscon";
|
| D | qcom-mdm9615.dtsi | 228 syscon-tcsr = <&tcsr>;
252 syscon-tcsr = <&tcsr>;
401 tcsr: syscon@1a400000 { label
402 compatible = "qcom,tcsr-mdm9615", "syscon";
|
| D | qcom-msm8960.dtsi | 237 syscon-tcsr = <&tcsr>;
340 tcsr: syscon@1a400000 { label
341 compatible = "qcom,tcsr-msm8960", "syscon";
|
| D | qcom-apq8064.dtsi | 449 syscon-tcsr = <&tcsr>;
488 syscon-tcsr = <&tcsr>;
637 syscon-tcsr = <&tcsr>;
1182 tcsr: syscon@1a400000 { label
1183 compatible = "qcom,tcsr-apq8064", "syscon";
|
| /Linux-v6.1/drivers/hwspinlock/ |
| D | qcom_hwspinlock.c | 107 { .compatible = "qcom,tcsr-mutex", .data = &of_tcsr_mutex },
108 { .compatible = "qcom,apq8084-tcsr-mutex", .data = &of_msm8226_tcsr_mutex },
109 { .compatible = "qcom,ipq6018-tcsr-mutex", .data = &of_msm8226_tcsr_mutex },
110 { .compatible = "qcom,msm8226-tcsr-mutex", .data = &of_msm8226_tcsr_mutex },
111 { .compatible = "qcom,msm8974-tcsr-mutex", .data = &of_msm8226_tcsr_mutex },
112 { .compatible = "qcom,msm8994-tcsr-mutex", .data = &of_msm8226_tcsr_mutex },
|
| /Linux-v6.1/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,gsbi.yaml | 57 syscon-tcsr:
60 Phandle of TCSR syscon node.Required if child uses dma.
106 syscon-tcsr = <&tcsr>;
|
| /Linux-v6.1/drivers/phy/qualcomm/ |
| D | phy-qcom-qusb2.c | 277 /* offset to PHY_CLK_SCHEME register in TCSR map */
419 * @tcsr: TCSR syscon register map
439 struct regmap *tcsr; member
797 * register in the TCSR so, if there's none, use the default in qusb2_phy_init()
808 if (qphy->tcsr) { in qusb2_phy_init()
809 ret = regmap_read(qphy->tcsr, qphy->cfg->clk_scheme_offset, in qusb2_phy_init()
1007 qphy->tcsr = syscon_regmap_lookup_by_phandle(dev->of_node, in qusb2_phy_probe()
1008 "qcom,tcsr-syscon"); in qusb2_phy_probe()
1009 if (IS_ERR(qphy->tcsr)) { in qusb2_phy_probe()
1010 dev_dbg(dev, "failed to lookup TCSR regmap\n"); in qusb2_phy_probe()
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/firmware/ |
| D | qcom,scm.yaml | 78 - description: phandle to TCSR hardware block
80 description: TCSR hardware block
|
| /Linux-v6.1/Documentation/mips/ |
| D | ingenic-tcu.rst | 19 different clocks (pclk, ext, rtc), gated, and reclocked, through their TCSR register.
21 - The watchdog and OST hardware blocks also feature a TCSR register with the same
|
| /Linux-v6.1/drivers/pwm/ |
| D | pwm-xilinx.c | 34 u32 xilinx_timer_tlr_cycles(struct xilinx_timer_priv *priv, u32 tcsr, in xilinx_timer_tlr_cycles() argument
39 if (tcsr & TCSR_UDT) in xilinx_timer_tlr_cycles()
45 u32 tlr, u32 tcsr) in xilinx_timer_get_period() argument
49 if (tcsr & TCSR_UDT) in xilinx_timer_get_period()
|
| /Linux-v6.1/Documentation/devicetree/bindings/remoteproc/ |
| D | qcom,qcs404-cdsp-pil.yaml | 83 Phandle reference to a syscon representing TCSR followed by the
154 qcom,halt-regs = <&tcsr 0x19004>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/pci/ |
| D | qcom,pcie-ep.yaml | 45 description: Reference to a syscon representing TCSR followed by the two
188 qcom,perst-regs = <&tcsr 0xb258 0xb270>;
|
| /Linux-v6.1/drivers/net/ethernet/marvell/mvpp2/ |
| D | mvpp2_tai.c | 242 u32 tcsr; in mvpp22_tai_gettimex64() local
260 tcsr = readl(base + MVPP22_TAI_TCSR); in mvpp22_tai_gettimex64()
261 if (tcsr & TCSR_CAPTURE_1_VALID) { in mvpp22_tai_gettimex64()
264 } else if (tcsr & TCSR_CAPTURE_0_VALID) { in mvpp22_tai_gettimex64()
|
| /Linux-v6.1/drivers/clk/ingenic/ |
| D | tcu.c | 130 WARN_ONCE(ret < 0, "Unable to read TCSR %d", tcu_clk->idx); in ingenic_tcu_get_parent()
146 WARN_ONCE(ret < 0, "Unable to update TCSR %d", tcu_clk->idx); in ingenic_tcu_set_parent()
163 WARN_ONCE(ret < 0, "Unable to read TCSR %d", tcu_clk->idx); in ingenic_tcu_recalc_rate()
209 WARN_ONCE(ret < 0, "Unable to update TCSR %d", tcu_clk->idx); in ingenic_tcu_set_rate()
|
| /Linux-v6.1/Documentation/devicetree/bindings/phy/ |
| D | qcom,qusb2-phy.yaml | 80 qcom,tcsr-syscon:
82 Phandle to TCSR syscon register region.
|
| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | ipq6018.dtsi | 250 compatible = "qcom,ipq6018-tcsr-mutex", "qcom,tcsr-mutex";
255 tcsr: syscon@1937000 { label
256 compatible = "qcom,tcsr-ipq6018", "syscon";
608 qcom,halt-regs = <&tcsr 0x18000 0x1b000 0xe000>;
|
| D | msm8953.dtsi | 423 qcom,tcsr-syscon = <&tcsr_phy_clk_scheme_sel>;
714 compatible = "qcom,tcsr-mutex";
719 tcsr: syscon@1937000 { label
720 compatible = "qcom,tcsr-msm8953", "syscon";
725 compatible = "qcom,tcsr-msm8953", "syscon";
|
| /Linux-v6.1/drivers/rtc/ |
| D | rtc-rs5c348.c | 101 udelay(62); /* Tcsr 62us */ in rs5c348_rtc_set_time()
133 udelay(62); /* Tcsr 62us */ in rs5c348_rtc_read_time()
|
| /Linux-v6.1/Documentation/translations/zh_CN/mips/ |
| D | ingenic-tcu.rst | 25 - 每个TCU通道都有自己的时钟源，可以通过 TCSR 寄存器设置通道的父级时钟
|
