Searched full:amc (Results 1 – 10 of 10) sorted by relevance
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | armada-385-db-88f6820-amc.dts | 3 * Device Tree file for Marvell Armada 385 AMC board
4 * (DB-88F6820-AMC)
15 model = "Marvell Armada 385 AMC";
16 compatible = "marvell,a385-db-amc", "marvell,armada385", "marvell,armada380";
|
| D | Makefile | 1324 armada-385-db-88f6820-amc.dtb \
|
| /Linux-v5.10/Documentation/devicetree/bindings/interconnect/ |
| D | qcom,bcm-voter.yaml | 27 upon triggering. If not specified, then the AMC and WAKE sets wait for
30 The AMC TCS is triggered immediately when icc_set_bw() is called. The
34 In most cases, it's necessary to wait in both the AMC and WAKE sets to
|
| /Linux-v5.10/include/dt-bindings/interconnect/ |
| D | qcom,icc.h | 10 * The AMC bucket denotes constraints that are applied to hardware when
|
| /Linux-v5.10/include/soc/qcom/ |
| D | tcs.h | 19 * RPMH_ACTIVE_ONLY_STATE: Active or AMC mode requests. Resource state
|
| /Linux-v5.10/drivers/interconnect/qcom/ |
| D | bcm-voter.c | 244 * This function generates a set of AMC commands and flushes to the BCM device
290 pr_err("Error sending AMC RPMH requests (%d)\n", ret); in qcom_icc_bcm_voter_commit()
|
| /Linux-v5.10/drivers/soc/qcom/ |
| D | rpmh-rsc.c | 352 * While clearing ensure that the AMC mode trigger is cleared in __tcs_set_trigger()
362 /* Enable the AMC mode on the TCS and then trigger the TCS */ in __tcs_set_trigger()
437 * votes, clear AMC trigger & enable modes and in tcs_tx_done()
|
| /Linux-v5.10/fs/xfs/scrub/ |
| D | inode.c | 313 /* di_[amc]time.nsec */ in xchk_dinode()
|
| /Linux-v5.10/drivers/eisa/ |
| D | eisa.ids | 689 ICU06D0 "Zoom AMC 2400 Modem"
|
| /Linux-v5.10/drivers/usb/serial/ |
| D | ftdi_sio_ids.h | 549 /* AlphaMicro Components AMC-232USB01 device (FTDI_VID) */
|
