Lines Matching +full:vbus +full:- +full:divider
4 * This file is dual-licensed: you can use it either under the terms
22 * MA 02110-1301 USA
48 #include <dt-bindings/gpio/gpio.h>
49 #include <dt-bindings/input/linux-event-codes.h>
50 #include <dt-bindings/interrupt-controller/irq.h>
63 stdout-path = &uart2;
67 compatible = "pwm-backlight";
69 brightness-levels = <0 4 8 16 32 64 128 255>;
70 default-brightness-level = <7>;
73 gpio-keys {
74 compatible = "gpio-keys";
75 #address-cells = <1>;
76 #size-cells = <0>;
78 user-pb {
84 user-pb1x {
87 interrupt-parent = <&gsc>;
91 key-erased {
92 label = "key-erased";
94 interrupt-parent = <&gsc>;
98 eeprom-wp {
101 interrupt-parent = <&gsc>;
108 interrupt-parent = <&gsc>;
112 switch-hold {
115 interrupt-parent = <&gsc>;
121 compatible = "gpio-leds";
122 pinctrl-names = "default";
123 pinctrl-0 = <&pinctrl_gpio_leds>;
128 default-state = "on";
129 linux,default-trigger = "heartbeat";
135 default-state = "off";
141 default-state = "off";
151 compatible = "pps-gpio";
152 pinctrl-names = "default";
153 pinctrl-0 = <&pinctrl_pps>;
157 reg_1p0v: regulator-1p0v {
158 compatible = "regulator-fixed";
159 regulator-name = "1P0V";
160 regulator-min-microvolt = <1000000>;
161 regulator-max-microvolt = <1000000>;
162 regulator-always-on;
165 reg_3p3v: regulator-3p3v {
166 compatible = "regulator-fixed";
167 regulator-name = "3P3V";
168 regulator-min-microvolt = <3300000>;
169 regulator-max-microvolt = <3300000>;
170 regulator-always-on;
173 reg_usb_h1_vbus: regulator-usb-h1-vbus {
174 compatible = "regulator-fixed";
175 regulator-name = "usb_h1_vbus";
176 regulator-min-microvolt = <5000000>;
177 regulator-max-microvolt = <5000000>;
178 regulator-always-on;
181 reg_usb_otg_vbus: regulator-usb-otg-vbus {
182 compatible = "regulator-fixed";
183 regulator-name = "usb_otg_vbus";
184 regulator-min-microvolt = <5000000>;
185 regulator-max-microvolt = <5000000>;
187 enable-active-high;
192 assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>,
194 assigned-clock-parents = <&clks IMX6QDL_CLK_PLL3_USB_OTG>,
199 pinctrl-names = "default";
200 pinctrl-0 = <&pinctrl_enet>;
201 phy-mode = "rgmii-id";
204 fixed-link {
206 full-duplex;
210 #address-cells = <1>;
211 #size-cells = <0>;
218 #address-cells = <1>;
219 #size-cells = <0>;
252 clock-frequency = <100000>;
253 pinctrl-names = "default";
254 pinctrl-0 = <&pinctrl_i2c1>;
260 interrupt-parent = <&gpio1>;
262 interrupt-controller;
263 #interrupt-cells = <1>;
264 #size-cells = <0>;
267 compatible = "gw,gsc-adc";
268 #address-cells = <1>;
269 #size-cells = <0>;
348 gpio-controller;
349 #gpio-cells = <2>;
350 interrupt-parent = <&gsc>;
385 clock-frequency = <100000>;
386 pinctrl-names = "default";
387 pinctrl-0 = <&pinctrl_i2c2>;
391 compatible = "st,lsm9ds1-magn";
393 pinctrl-names = "default";
394 pinctrl-0 = <&pinctrl_mag>;
395 interrupt-parent = <&gpio5>;
402 interrupt-parent = <&gpio1>;
408 regulator-name = "vddsoc";
409 regulator-min-microvolt = <674400>;
410 regulator-max-microvolt = <1308000>;
411 lltc,fb-voltage-divider = <127000 200000>;
412 regulator-ramp-delay = <7000>;
413 regulator-boot-on;
414 regulator-always-on;
419 regulator-name = "vdd1p8";
420 regulator-min-microvolt = <1033310>;
421 regulator-max-microvolt = <2004000>;
422 lltc,fb-voltage-divider = <301000 200000>;
423 regulator-ramp-delay = <7000>;
424 regulator-boot-on;
425 regulator-always-on;
430 regulator-name = "vddarm";
431 regulator-min-microvolt = <674400>;
432 regulator-max-microvolt = <1308000>;
433 lltc,fb-voltage-divider = <127000 200000>;
434 regulator-ramp-delay = <7000>;
435 regulator-boot-on;
436 regulator-always-on;
441 regulator-name = "vddddr";
442 regulator-min-microvolt = <868310>;
443 regulator-max-microvolt = <1684000>;
444 lltc,fb-voltage-divider = <221000 200000>;
445 regulator-ramp-delay = <7000>;
446 regulator-boot-on;
447 regulator-always-on;
450 /* VDD_2P5 (1+R1/R2 = 3.435): PCIe/ENET-PHY */
452 regulator-name = "vdd2p5";
453 regulator-min-microvolt = <2490375>;
454 regulator-max-microvolt = <2490375>;
455 lltc,fb-voltage-divider = <487000 200000>;
456 regulator-boot-on;
457 regulator-always-on;
462 regulator-name = "vdd3p0";
463 regulator-min-microvolt = <3023250>;
464 regulator-max-microvolt = <3023250>;
465 lltc,fb-voltage-divider = <634000 200000>;
466 regulator-boot-on;
467 regulator-always-on;
473 compatible = "st,lsm9ds1-imu";
475 st,drdy-int-pin = <1>;
476 pinctrl-names = "default";
477 pinctrl-0 = <&pinctrl_imu>;
478 interrupt-parent = <&gpio4>;
484 clock-frequency = <100000>;
485 pinctrl-names = "default";
486 pinctrl-0 = <&pinctrl_i2c3>;
492 interrupt-parent = <&gpio1>;
494 wakeup-gpios = <&gpio1 11 GPIO_ACTIVE_LOW>;
501 lvds-channel@0 {
502 fsl,data-mapping = "spwg";
503 fsl,data-width = <18>;
506 display-timings {
507 native-mode = <&timing0>;
509 clock-frequency = <65000000>;
512 hback-porch = <220>;
513 hfront-porch = <40>;
514 vback-porch = <21>;
515 vfront-porch = <7>;
516 hsync-len = <60>;
517 vsync-len = <10>;
524 pinctrl-names = "default";
525 pinctrl-0 = <&pinctrl_pcie>;
526 reset-gpio = <&gpio1 0 GPIO_ACTIVE_LOW>;
531 pinctrl-names = "default";
532 pinctrl-0 = <&pinctrl_pwm2>; /* MX6_DIO1 */
537 pinctrl-names = "default";
538 pinctrl-0 = <&pinctrl_pwm3>; /* MX6_DIO2 */
543 #pwm-cells = <2>;
544 pinctrl-names = "default";
545 pinctrl-0 = <&pinctrl_pwm4>;
550 pinctrl-names = "default";
551 pinctrl-0 = <&pinctrl_uart1>;
556 pinctrl-names = "default";
557 pinctrl-0 = <&pinctrl_uart2>;
562 pinctrl-names = "default";
563 pinctrl-0 = <&pinctrl_uart3>;
564 uart-has-rtscts;
569 pinctrl-names = "default";
570 pinctrl-0 = <&pinctrl_uart4>;
571 uart-has-rtscts;
576 pinctrl-names = "default";
577 pinctrl-0 = <&pinctrl_uart5>;
582 vbus-supply = <®_usb_otg_vbus>;
583 pinctrl-names = "default";
584 pinctrl-0 = <&pinctrl_usbotg>;
585 disable-over-current;
590 vbus-supply = <®_usb_h1_vbus>;
595 pinctrl-names = "default", "state_100mhz", "state_200mhz";
596 pinctrl-0 = <&pinctrl_usdhc3>;
597 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
598 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
599 non-removable;
600 vmmc-supply = <®_3p3v>;
601 keep-power-in-suspend;
606 pinctrl-names = "default";
607 pinctrl-0 = <&pinctrl_wdog>;
608 fsl,ext-reset-output;