Lines Matching +full:vbus +full:- +full:divider
4 * This file is dual-licensed: you can use it either under the terms
22 * MA 02110-1301 USA
48 #include <dt-bindings/gpio/gpio.h>
49 #include <dt-bindings/input/linux-event-codes.h>
50 #include <dt-bindings/interrupt-controller/irq.h>
54 stdout-path = &uart2;
58 compatible = "pwm-backlight";
60 brightness-levels = <
73 default-brightness-level = <100>;
76 gpio-keys {
77 compatible = "gpio-keys";
78 #address-cells = <1>;
79 #size-cells = <0>;
81 user-pb {
87 user-pb1x {
90 interrupt-parent = <&gsc>;
94 key-erased {
95 label = "key-erased";
97 interrupt-parent = <&gsc>;
101 eeprom-wp {
104 interrupt-parent = <&gsc>;
111 interrupt-parent = <&gsc>;
115 switch-hold {
118 interrupt-parent = <&gsc>;
124 compatible = "gpio-leds";
125 pinctrl-names = "default";
126 pinctrl-0 = <&pinctrl_gpio_leds>;
131 default-state = "off";
140 reg_5p0v: regulator-5p0v {
141 compatible = "regulator-fixed";
142 regulator-name = "5P0V";
143 regulator-min-microvolt = <5000000>;
144 regulator-max-microvolt = <5000000>;
145 regulator-always-on;
148 reg_3p3v: regulator-3p3v {
149 compatible = "regulator-fixed";
150 regulator-name = "3P3V";
151 regulator-min-microvolt = <3300000>;
152 regulator-max-microvolt = <3300000>;
153 regulator-always-on;
156 reg_2p5v: regulator-2p5v {
157 compatible = "regulator-fixed";
158 regulator-name = "2P5V";
159 regulator-min-microvolt = <2500000>;
160 regulator-max-microvolt = <2500000>;
161 regulator-always-on;
164 reg_usb_h1_vbus: regulator-usb-h1-vbus {
165 compatible = "regulator-fixed";
166 regulator-name = "usb_h1_vbus";
167 regulator-min-microvolt = <5000000>;
168 regulator-max-microvolt = <5000000>;
170 enable-active-high;
173 reg_usb_otg_vbus: regulator-usb-otg-vbus {
174 compatible = "regulator-fixed";
175 regulator-name = "usb_otg_vbus";
176 regulator-min-microvolt = <5000000>;
177 regulator-max-microvolt = <5000000>;
179 enable-active-high;
182 reg_12p0: regulator-12p0v {
183 compatible = "regulator-fixed";
184 regulator-name = "12P0V";
185 regulator-min-microvolt = <12000000>;
186 regulator-max-microvolt = <12000000>;
188 enable-active-high;
192 compatible = "fsl,imx-audio-tlv320";
193 model = "imx-tlv320";
194 ssi-controller = <&ssi1>;
195 audio-codec = <&tlv320aic3105>;
197 audio-routing =
198 /* TLV320 LINE1L pin <-> Mic Jack connector */
200 /* board Headphone Jack <-> HPOUT */
204 mux-int-port = <1>;
205 mux-ext-port = <6>;
210 pinctrl-names = "default";
211 pinctrl-0 = <&pinctrl_audmux>;
216 assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>,
218 assigned-clock-parents = <&clks IMX6QDL_CLK_PLL3_USB_OTG>,
223 pinctrl-names = "default";
224 pinctrl-0 = <&pinctrl_enet>;
225 phy-mode = "rgmii-id";
230 clock-frequency = <100000>;
231 pinctrl-names = "default";
232 pinctrl-0 = <&pinctrl_i2c1>;
238 interrupt-parent = <&gpio1>;
240 interrupt-controller;
241 #interrupt-cells = <1>;
242 #size-cells = <0>;
245 compatible = "gw,gsc-adc";
246 #address-cells = <1>;
247 #size-cells = <0>;
326 gpio-controller;
327 #gpio-cells = <2>;
328 interrupt-parent = <&gsc>;
363 clock-frequency = <400000>;
364 pinctrl-names = "default";
365 pinctrl-0 = <&pinctrl_i2c2>;
371 interrupt-parent = <&gpio1>;
377 regulator-name = "vdd1p8";
378 regulator-min-microvolt = <1033310>;
379 regulator-max-microvolt = <2004000>;
380 lltc,fb-voltage-divider = <301000 200000>;
381 regulator-ramp-delay = <7000>;
382 regulator-boot-on;
383 regulator-always-on;
388 regulator-name = "vddddr";
389 regulator-min-microvolt = <868310>;
390 regulator-max-microvolt = <1684000>;
391 lltc,fb-voltage-divider = <221000 200000>;
392 regulator-ramp-delay = <7000>;
393 regulator-boot-on;
394 regulator-always-on;
399 regulator-name = "vddarm";
400 regulator-min-microvolt = <674400>;
401 regulator-max-microvolt = <1308000>;
402 lltc,fb-voltage-divider = <127000 200000>;
403 regulator-ramp-delay = <7000>;
404 regulator-boot-on;
405 regulator-always-on;
411 regulator-name = "vddsoc";
412 regulator-min-microvolt = <674400>;
413 regulator-max-microvolt = <1308000>;
414 lltc,fb-voltage-divider = <127000 200000>;
415 regulator-ramp-delay = <7000>;
416 regulator-boot-on;
417 regulator-always-on;
423 regulator-name = "vdd1p0";
424 regulator-min-microvolt = <1002777>;
425 regulator-max-microvolt = <1002777>;
426 lltc,fb-voltage-divider = <100000 261000>;
427 regulator-boot-on;
428 regulator-always-on;
433 regulator-name = "vdd3p0";
434 regulator-min-microvolt = <3023250>;
435 regulator-max-microvolt = <3023250>;
436 lltc,fb-voltage-divider = <634000 200000>;
437 regulator-boot-on;
438 regulator-always-on;
445 clock-frequency = <400000>;
446 pinctrl-names = "default";
447 pinctrl-0 = <&pinctrl_i2c3>;
453 reset-gpios = <&gpio5 17 GPIO_ACTIVE_LOW>;
455 ai3x-micbias-vg = <2>; /* MICBIAS_2_5V */
457 DRVDD-supply = <®_3p3v>;
458 AVDD-supply = <®_3p3v>;
459 IOVDD-supply = <®_3p3v>;
460 DVDD-supply = <®_1p8v>;
466 interrupt-parent = <&gpio7>;
468 interrupt-names = "INT2";
475 interrupt-parent = <&gpio5>;
484 lvds-channel@0 {
485 fsl,data-mapping = "spwg";
486 fsl,data-width = <18>;
489 display-timings {
490 native-mode = <&timing0>;
492 clock-frequency = <68930000>;
495 hback-porch = <220>;
496 hfront-porch = <40>;
497 vback-porch = <21>;
498 vfront-porch = <7>;
499 hsync-len = <60>;
500 vsync-len = <10>;
507 #pwm-cells = <2>;
508 pinctrl-names = "default";
509 pinctrl-0 = <&pinctrl_pwm1>;
518 pinctrl-names = "default";
519 pinctrl-0 = <&pinctrl_uart1>;
524 pinctrl-names = "default";
525 pinctrl-0 = <&pinctrl_uart2>;
530 vbus-supply = <®_usb_otg_vbus>;
531 pinctrl-names = "default";
532 pinctrl-0 = <&pinctrl_usbotg>;
533 disable-over-current;
538 vbus-supply = <®_usb_h1_vbus>;
543 pinctrl-names = "default";
544 pinctrl-0 = <&pinctrl_usdhc1_200mhz>;
545 vmmc-supply = <®_3p3v>;
546 non-removable;
547 bus-width = <4>;
552 pinctrl-names = "default", "state_100mhz", "state_200mhz";
553 pinctrl-0 = <&pinctrl_usdhc2>;
554 pinctrl-1 = <&pinctrl_usdhc2_100mhz>;
555 pinctrl-2 = <&pinctrl_usdhc2_200mhz>;
556 cd-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>;
557 vmmc-supply = <®_3p3v>;
558 max-frequency = <100000000>;
563 pinctrl-names = "default", "state_100mhz", "state_200mhz";
564 pinctrl-0 = <&pinctrl_usdhc3>;
565 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
566 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
567 non-removable;
568 vmmc-supply = <®_3p3v>;
569 keep-power-in-suspend;
574 pinctrl-names = "default";
575 pinctrl-0 = <&pinctrl_wdog>;
576 fsl,ext-reset-output;