1#
2# Copyright 2017-2022 NXP
3#
4# SPDX-License-Identifier: Apache-2.0
5#
6
7if (CONFIG_DISPLAY)
8message(WARNING "
9CONFIG_DISPLAY: Running this firmware on a board without a display may damage the board
10")
11endif()
12
13if(CONFIG_NXP_IMXRT_BOOT_HEADER)
14  zephyr_library()
15  if(CONFIG_DT_HAS_NXP_IMX_FLEXSPI_HYPERFLASH_ENABLED)
16    set(FLASH_CONF evkbimxrt1050_flexspi_nor_config.c)
17  elseif(CONFIG_DT_HAS_NXP_IMX_FLEXSPI_NOR_ENABLED)
18    set(FLASH_CONF evkbimxrt1050_flexspi_nor_qspi_config.c)
19  else()
20    message(WARNING "It appears you are using the board definition for "
21     "the MIMXRT1050-EVK, but targeting a custom board. You may need to "
22     "update your flash configuration or device configuration data blocks")
23    # Default EVK configuration uses hyperflash, so use that file
24    set(FLASH_CONF evkbimxrt1050_flexspi_nor_config.c)
25  endif()
26  set(RT1050_BOARD_DIR
27    "${ZEPHYR_HAL_NXP_MODULE_DIR}/mcux/mcux-sdk/boards/evkbimxrt1050")
28  if(CONFIG_BOOT_FLEXSPI_NOR)
29    # Include flash configuration block for RT1050 EVK from NXP's HAL.
30    # This configuration block may need modification if another flash chip is
31    # used on your custom board. See NXP AN12238 for more information.
32    zephyr_compile_definitions(XIP_BOOT_HEADER_ENABLE=1)
33    zephyr_compile_definitions(BOARD_FLASH_SIZE=CONFIG_FLASH_SIZE*1024)
34    zephyr_library_sources(${RT1050_BOARD_DIR}/xip/${FLASH_CONF})
35    zephyr_library_include_directories(${RT1050_BOARD_DIR}/xip)
36  endif()
37  if(CONFIG_DEVICE_CONFIGURATION_DATA)
38    # Include device configuration data block for RT1050 EVK from NXP's HAL.
39    # This configuration block may need modification if another SDRAM chip
40    # is used on your custom board.
41    zephyr_compile_definitions(XIP_BOOT_HEADER_DCD_ENABLE=1)
42    zephyr_library_sources(${RT1050_BOARD_DIR}/dcd.c)
43  else()
44    if(CONFIG_SRAM_BASE_ADDRESS EQUAL 0x80000000)
45      message(WARNING "You are using SDRAM as RAM but no device "
46        "configuration data (DCD) is included. This configuration may not boot")
47    endif()
48  endif()
49endif()
50
51if(CONFIG_MCUX_GPT_TIMER)
52  message(WARNING "You appear to be using the GPT hardware timer. "
53    "This timer will enable lower power modes, but at the cost of reduced "
54    "hardware timer resolution")
55endif()
56