1# 2# Copyright 2023 NXP 3# 4# SPDX-License-Identifier: Apache-2.0 5# 6 7if (CONFIG_DISPLAY) 8message(WARNING " 9CONFIG_DISPLAY: Running this firmware on a board without a display may damage the board 10") 11endif() 12 13if(CONFIG_NXP_IMXRT_BOOT_HEADER) 14 zephyr_library() 15 if(NOT DEFINED CONFIG_BOARD_MIMXRT1040_EVK) 16 message(WARNING "It appears you are using the board definition for " 17 "the MIMXRT1040-EVK, but targeting a custom board. You may need to " 18 "update your flash configuration or device configuration data blocks") 19 endif() 20 set(RT1040_BOARD_DIR 21 "${ZEPHYR_HAL_NXP_MODULE_DIR}/mcux/mcux-sdk/boards/evkmimxrt1040") 22 if(CONFIG_BOOT_FLEXSPI_NOR) 23 # Include flash configuration block for RT1040 EVK from NXP's HAL. 24 # This configuration block may need modification if another flash chip is 25 # used on your custom board. See NXP AN12238 for more information. 26 zephyr_compile_definitions(XIP_BOOT_HEADER_ENABLE=1) 27 zephyr_compile_definitions(BOARD_FLASH_SIZE=CONFIG_FLASH_SIZE*1024) 28 zephyr_library_sources(${RT1040_BOARD_DIR}/xip/evkmimxrt1040_flexspi_nor_config.c) 29 zephyr_library_include_directories(${RT1040_BOARD_DIR}/xip) 30 endif() 31 if(CONFIG_DEVICE_CONFIGURATION_DATA) 32 # Include device configuration data block for RT1040 EVK from NXP's HAL. 33 # This configuration block may need modification if another SDRAM chip 34 # is used on your custom board. 35 zephyr_compile_definitions(XIP_BOOT_HEADER_DCD_ENABLE=1) 36 zephyr_library_sources(${RT1040_BOARD_DIR}/dcd.c) 37 else() 38 if(CONFIG_SRAM_BASE_ADDRESS EQUAL 0x80000000) 39 message(WARNING "You are using SDRAM as RAM but no device " 40 "configuration data (DCD) is included. This configuration may not boot") 41 endif() 42 endif() 43endif() 44 45if(CONFIG_MCUX_GPT_TIMER) 46 message(WARNING "You appear to be using the GPT hardware timer. " 47 "This timer will enable lower power modes, but at the cost of reduced " 48 "hardware timer resolution") 49endif() 50