Searched refs:pads (Results 1 – 24 of 24) sorted by relevance
19 #define QSPI_LUT_OP(inst, pads, op) \ argument21 | (Qspi_Ip_InstrOpType)(pads) \
48 - Breakout pads for Wireless SoC I/O60 - Breakout pads for Wireless SoC I/O
52 The bcm958401m2 board includes pads for soldering a JTAG connector.
48 The ``bcm958402m2/bcm58402/a72`` board includes pads for soldering a JTAG connector.
48 The ``bcm958402m2/bcm58402/m7`` board includes pads for soldering a JTAG connector.
63 # Checksums the binary, pads it, and generates an assembly file
28 uint32_t pads; member109 ctrla.reg |= cfg->pads; in spi_sam0_configure()727 .pads = SPI_SAM0_SERCOM_PADS(n), \737 .pads = SPI_SAM0_SERCOM_PADS(n), \
40 #. While the blue LED is blinking (for 5 seconds), touch the touch-pads with your finger.
108 entered by shorting the RST and GND pads twice.145 #. Short the RST and GND pads twice quickly to enter bootloader mode
55 Adafruit does provide solder pads for your own power supply on the
36 uint32_t pads; member470 CTRLB_temp.bit.COLDEN = cfg->pads; in uart_sam0_configure()535 cfg->pads in uart_sam0_init()1283 .pads = UART_SAM0_SERCOM_PADS(n), \1296 .pads = UART_SAM0_SERCOM_PADS(n), \
118 The Pro Micro board does make the SWD pins available on pads on the
81 pads on the PCB (see image):
24 - Breakout pads for GPIO access and connection to external hardware
21 - IC pads for external flash chip
69 The SoC's pads are grouped into ports and pins for consistency with GPIO driver71 the mapping between pads and ports/pins. This must be taken into account when
26 - Breakout pads for GPIO access and connection to external hardware
31 - Breakout pads for GPIO access and connection to external hardware
50 - SWD solder pads on bottom of PCB (Sense only)
81 - pads for soldering of JTAG 14-pin connector316 The UDOO Neo Full board includes pads for soldering the 14-pin JTAG
158 to on-board SWD test pads.
84 - Five unpopulated through-hole solder pads to provide access to selected140 - This header provides six unpopulated through-hole solder pads connected
34 /* Change default functional pads to GPIOs
702 * Added support for PSL pads in NPCX driver.1266 * Added pinctrl support for PSL (Power Switch Logic) pads.
