Searched refs:single (Results 101 – 125 of 575) sorted by relevance
12345678910>>...23
| /Zephyr-latest/drivers/ipm/ |
| D | Kconfig.imx | 42 There will be a single message type with id 0
|
| /Zephyr-latest/doc/connectivity/bluetooth/ |
| D | bluetooth-arch.rst | 62 * **Single-chip configuration**: In this configuration, a single microcontroller
67 single-chip configuration and so how HCI commands, events, and data flows between
70 possible power consumption, since everything runs on a single IC.
132 Controller, and it is used exclusively for single-chip (SoC) configurations.
144 The picture below shows the SoC or single-chip configuration when using a Zephyr
150 :alt: Bluetooth Combined build on a single chip
|
| /Zephyr-latest/doc/hardware/peripherals/ |
| D | w1.rst | 9 1-Wire is a low speed half-duplex serial bus using only a single wire plus
12 and is a single master multidrop bus. This means one master initiates all data
|
| /Zephyr-latest/soc/espressif/esp32s2/ |
| D | Kconfig.mac | 12 derived from a single base MAC address. If the number of universal MAC addresses is two,
|
| /Zephyr-latest/drivers/sensor/st/iis2dlpc/ |
| D | Kconfig | 64 Enable tap (single/double) detection
|
| /Zephyr-latest/cmake/bintools/armclang/ |
| D | elfconvert_command.cmake | 2 # Reason for that is because not a single command covers all use cases,
|
| /Zephyr-latest/drivers/ethernet/ |
| D | Kconfig.lan865x | 14 Mbps single pair Ethernet (SPE).
|
| D | Kconfig.adin2111 | 15 Mbps single pair Ethernet (SPE).
|
| /Zephyr-latest/samples/subsys/usb/audio/headset/ |
| D | README.rst | 12 ISO endpoints. The device will show up as single audio device.
|
| /Zephyr-latest/lib/posix/options/ |
| D | Kconfig.proc1 | 8 bool "POSIX single process support"
|
| /Zephyr-latest/doc/services/device_mgmt/ |
| D | smp_transport.rst | 20 All SMP communication utilizes a single GATT characteristic. An SMP request is
24 If an SMP request or response is too large to fit in a single GATT command, the
74 entire body with preceding length and following it CRC in a single
|
| /Zephyr-latest/samples/subsys/usb/uac2_implicit_feedback/ |
| D | README.rst | 24 single sample accuracy.
|
| /Zephyr-latest/drivers/w1/ |
| D | Kconfig | 64 which is otherwise used in case of a single
|
| /Zephyr-latest/boards/aspeed/ast1030_evb/doc/ |
| D | index.rst | 51 This board comes with a JTAG port which facilitates debugging using a single physical connection.
|
| /Zephyr-latest/cmake/sca/eclair/ |
| D | sca_options.cmake | 7 by analysing the single translation units independently." OFF)
|
| /Zephyr-latest/boards/others/esp32c3_supermini/doc/ |
| D | index.rst | 6 ESP32-C3-SUPERMINI is based on the ESP32-C3, a single-core Wi-Fi and Bluetooth 5 (LE) microcontroll…
17 - 32-bit RISC-V single-core processor, up to 160MHz
68 The board could be loaded using the single binary image, without 2nd stage bootloader.
|
| /Zephyr-latest/boards/nxp/imx8mn_evk/doc/ |
| D | index.rst | 7 processor, composed of a quad Cortex®-A53 cluster and a single Cortex®-M7 core.
82 This board configuration uses a single serial communication channel with the
|
| /Zephyr-latest/boards/nuvoton/npcm400_evb/doc/ |
| D | index.rst | 45 using a single physical connection. In addition, it comes with sockets for
|
| /Zephyr-latest/tests/bsim/bluetooth/host/att/open_close/src/ |
| D | main.c | 184 closet[p].single.handle = chrc_value_handle; in a_test_iteration()
|
| /Zephyr-latest/boards/snps/nsim/arc_classic/doc/ |
| D | index.rst | 42 In case of single-core configurations it would be ``.props`` file which contains configuration
54 I.e. for the single-core ``nsim/nsim_hs5x`` platform there are
74 To run single-core Zephyr RTOS applications in simulation on this board,
163 * Allows to debug both single-core and multi-core ``nsim`` targets.
167 (regardless if single- or multi-core configuration is used):
229 Debugging on nSIM via GDB is only supported on single-core configurations (which use standalone
279 reasons for that. ``.tcf`` perfectly suits building of bare-metal single-thread application -
|
| /Zephyr-latest/boards/franzininho/esp32s2_franzininho/doc/ |
| D | index.rst | 6 …lopment board based on ESP32-S2 which is a highly integrated, low-power, single-core Wi-Fi Microco…
53 The board could be loaded using the single binary image, without 2nd stage bootloader.
|
| /Zephyr-latest/boards/renesas/ek_ra4w1/doc/ |
| D | index.rst | 7 (HT) and Long Range support in a single chip MCU of Renesas RA4 product series for IoT applications
131 …ducts/microcontrollers-microprocessors/ra-cortex-m-mcus/ra4w1-low-energy-single-chip-32-bit-microc…
|
| /Zephyr-latest/doc/services/input/ |
| D | index.rst | 14 of a single button, or a movement in a single axis.
|
| /Zephyr-latest/boards/espressif/esp32c3_rust/doc/ |
| D | index.rst | 6 ESP32-C3-DevKit-RUST is based on the ESP32-C3, a single-core Wi-Fi and Bluetooth 5 (LE) microcontro…
19 - 32-bit RISC-V single-core processor, up to 160MHz
115 The board could be loaded using the single binary image, without 2nd stage bootloader.
|
| /Zephyr-latest/boards/nxp/rd_rw612_bga/doc/ |
| D | index.rst | 15 operation in a space- and cost-efficient wireless MCU requiring only a single 3.3 V power supply.
217 with the application image directly, forming one single monolithic image.
227 with the application image directly, forming one single monolithic image.
|
12345678910>>...23
