Searched refs:requires (Results 101 – 125 of 641) sorted by relevance
12345678910>>...26
23 a specific FLASH interface that requires aligned read access.30 Explicit erase (non-erase-on-write) Flash, which is device that requires erase
25 The application requires a STWIN.box board connected to the PC43 Please note that flashing the board requires a few preliminary steps described
24 The application requires a SensorTile.box board connected to the PC42 Please note that flashing the board requires a few preliminary steps described
58 /* Uncomment if IRQ line is available (requires to solder jumper) */
12 # the ASYNC implementation requires a DMA controller
31 # FIXME: openocd runner requires use of STMicro openocd fork.
18 It requires a correct fixture setup. Please connect a PS/2 mouse in order to
15 Test requires that two pairs of pins are shortened: TX with RX and CTS with RTS.
7 specific. It requires an SDIO card be connected to the board to pass.
9 /* USART Wakeup requires automatic HSI16 switch on in deepsleep mode
26 This project outputs sensor data to the console. It requires an LPS22HB
38 # RAM load mode requires XIP be disabled and flash size be set to 0
59 /* Uncomment if IRQ line is available (requires to solder jumper) */
19 improve throughput, but that requires more transient memory.
26 This project outputs sensor data to the console. It requires an HTS221
7 # Enable MIPI DSI, as this display controller requires it.
24 # EM9D requires 8 MHz.
24 # EM11D requires 10 MHz.
6 # Default cmsis-dap, it will be overwritten below if requires
26 This project outputs sensor data to the console. It requires an LPS22HH
27 This project outputs sensor data to the console. It requires a sensor from the
44 The board Bluetooth/WiFi module requires fetching some binary blob files, to do56 The dual core nature of STM32H747 SoC requires sharing HW resources between the82 This board requires dfu-utils for flashing. It is recommended to use at least
71 /* Uncomment if IRQ line is available (requires to solder jumper) */
28 you know what you are doing. Beware rf2xx requires gpio and spi to
22 /* The ARM SAU requires regions to be 32-byte-aligned. */
