Searched refs:has (Results 651 – 675 of 1361) sorted by relevance
1...<<21222324252627282930>>...55
55 #. Once the device has booted, you may see a notification from the browser: "Go
18 This dummy partition has a single secure service, which can index one of 5 dummy secrets inside the
38 hardware which has native 802.15.4 support.
14 Build the sample app by choosing the target board that has sensors drivers
20 so it has to be initialized after SPI driver.
52 subtree <alpha/beta> has static handler
11 Musca A1 board that has two MHU units. This sample only test MHU0, the
79 /* longan nano has LCD with st7735s controller.
31 present on the Pmod board. Once the tool has been installed, open it and
13 The ARCv2 interrupt unit has 16 allocated exceptions associated with
111 * project has defined for that board - a single image boot is
111 * compatible with what TF-M has defined for a single boot image,
74 After the board has automatically reset and booted, you should see the following
7 The breakout board has the RAK3172 as its core and with soldered to the
48 The EFR32MG24 SoC has one USART and two EUSARTs.
52 QSPI NOR flash chip is executed until the driver has been setup.
53 You can use ``minichlink`` to flash the board. Once ``minichlink`` has been set
12 nRF51 BLE Nano has two external oscillators. The frequency of the slow clock
125 has-dpd;
76 After the board has automatically reset and booted, you should see the following
28 might need it too). And of course it has to start before the net stack.
21 to a fixed storage partition that will be dedicated to the ITS. It has lower
21 Once correct configuration has been established and tested it is
130 * The neopixel on this board has its positive side hooked up to a GPIO pin
