Searched refs:gpios (Results 1451 – 1463 of 1463) sorted by relevance
1...<<515253545556575859
| /Zephyr-latest/doc/services/smf/ |
| D | index.rst | 406 GPIO_DT_SPEC_GET_OR(SW0_NODE, gpios, {0});
|
| /Zephyr-latest/drivers/serial/ |
| D | uart_ifx_cat1.c | 937 .gpios = {.pin_tx = NC, .pin_rts = NC, .pin_cts = NC}, in ifx_cat1_uart_init()
|
| /Zephyr-latest/doc/build/dts/api/ |
| D | api.rst | 455 - USB device node. If defined and has a ``vbus-gpios`` property, these
|
| /Zephyr-latest/doc/releases/ |
| D | release-notes-3.2.rst | 1198 properties are now ``scl-gpios`` and ``sda-gpios``.
1276 * :dtcompatible:`nxp,imx-lpi2c`: new ``scl-gpios``, ``sda-gpios`` properties.
1299 * :dtcompatible:`ti,ina237`: new ``alert-config``, ``irq-gpios`` properties.
1323 * WSEN-HIDS sensors: new ``drdy-gpios``, ``odr`` properties.
1324 * :dtcompatible:`sitronix,st7789v`: ``cmd-data-gpios`` is now optional.
|
| D | release-notes-3.3.rst | 1505 - removed property: ``supply-gpios``
1622 - new property: ``wakerx-gpios``
1703 - new property: ``reset-gpios``
1950 - new property: ``alert-gpios``
1951 - removed property: ``irq-gpios``
1959 - new property: ``alert-gpios``
1960 - removed property: ``irq-gpios``
3443 * :github:`51057` - Retrieve gpios used by a device (pinctrl)
3606 * :github:`47324` - drivers: modem: gsm_ppp: support common gpios
|
| D | release-notes-2.4.rst | 557 in the cs-gpios devicetree properties rather than the
561 selects that are not specified by a cs-gpios property.
1311 * :github:`26782` - boards: mchp: mec15xxevb_assy6853: Cannot set gpios as alternate function when…
1494 * :github:`25945` - devicetree: support generating symbols for -gpios properties w/o compatible
|
| D | release-notes-3.7.rst | 829 * Changed property names of the reset and interrupt gpios in the KSZ8081 DT binding.
947 * The ``in-gpios`` and ``output-pin`` properties of the respective
949 devicetree bindings have been renamed to ``gpios``.
|
| D | release-notes-4.0.rst | 688 * lp5562: added ``enable-gpios`` property to describe the EN/VCC GPIO of the lp5562.
692 * lp5569: added ``enable-gpios`` property to describe the EN/PWM GPIO of the lp5569.
|
| D | release-notes-2.5.rst | 87 GPIO-only regulators a devicetree property ``supply-gpios`` is defined as a
592 * Added support for power-gpios to enable ESP module.
|
| D | release-notes-2.0.rst | 786 * :github:`17778` - Microchip XEC rtos Timer breaks gpios and k_sleep?
|
| D | release-notes-2.7.rst | 1196 * :github:`38264` - Modbus over RS485 on samd21g18a re-gpios turning on 1 byte too early
|
| /Zephyr-latest/drivers/wifi/nrf_wifi/ |
| D | Kconfig.nrfwifi | 178 depends on $(dt_node_has_prop,nrf70, srrf-switch-gpios)
|
| /Zephyr-latest/doc/hardware/porting/ |
| D | board_porting.rst | 399 gpios = < /* GPIO your LED is hooked up to */ >;
|
1...<<515253545556575859
