Searched refs:and (Results 2851 – 2875 of 3855) sorted by relevance
1...<<111112113114115116117118119120>>...155
13 * Only ISM330DHCX and IIS2DLPC sensors are accessible from the main board mcu.
13 and provides the standard "system clock driver" interfaces.
10 # Select AIROC part and module
12 # Board Kconfig.defconfig enables USB CDC ACM and should disable USB remote
15 and other network configuration parameters to each device on a network so they
11 # 0 for Fast Interrupts (FIRQs) and 1-15 for Regular Interrupts (IRQs).
23 and proper functioning of the UDMA module */
25 # Board Kconfig.defconfig enables USB CDC ACM and should disable USB remote
11 # 0 for Fast Interrupts (FIRQs) and 1 for Regular Interrupts (IRQs).
10 used by network administrators to configure and diagnose mesh nodes.
6 # automatically, and I can't be bothered to figure out how to fix this.
11 # GNU ld and LLVM lld complains when used with llvm/clang:
13 # The driver requires tickless mode and ticks per
10 * and nRF5340 CPUNET (Network MCU).
11 software to select the data, config, and api from a number of linked
11 and should be enabled by other FlexIO drivers so
51 and.w r2, r1
12 test and therefore the higher likelihood an unlikely race/event will be triggered.
10 * (and be extended to test) real hardware.
13 # and the code pathing doing pointer comparison would not be tested
29 /* internally loop-back Tx and Rx on PAD0 */
13 # and rpmsg buffers. The METAL_MAX_DEVICE_REGIONS has to be redefined to add a
1 /* Enable the PLLI2s and set it as clock source for the MCO2 (with prescaler 2) : 25MHz */
13 * Short Pin PB9 to PA6, and PB8 to PA7, for the test to pass.
