Searched full:transmitted (Results 1 – 25 of 138) sorted by relevance
123456
/Zephyr-Core-3.5.0/subsys/bluetooth/controller/ll_sw/nordic/hal/nrf5/radio/ |
D | radio_nrf5_resources.h | 16 * received or transmitted. 40 * received or transmitted. 56 * received or transmitted. 92 * received or transmitted. 117 * received or transmitted.
|
/Zephyr-Core-3.5.0/drivers/i2c/ |
D | i2c_rcar.c | 64 #define RCAR_I2C_MST BIT(4) /* Master Stop Transmitted */ 66 #define RCAR_I2C_MDT BIT(2) /* Master Data Transmitted */ 68 #define RCAR_I2C_MAT BIT(0) /* Master Address Transmitted */ 128 /* Wait for STOP to be transmitted */ in i2c_rcar_finish() 150 /* Wait for address & transfer mode to be transmitted */ in i2c_rcar_set_addr() 199 /* Wait for all data to be transmitted */ in i2c_rcar_transfer_msg()
|
/Zephyr-Core-3.5.0/soc/xtensa/intel_adsp/common/include/ |
D | intel_adsp_ipc.h | 33 * @note Further messages on the link will not be transmitted or 53 * @note On Intel ADSP hardware the DONE interrupt is transmitted 121 * @note Further messages on the link will not be transmitted or 150 * @return message successfully transmitted.
|
/Zephyr-Core-3.5.0/soc/arm/nordic_nrf/nrf52/ |
D | CMakeLists.txt | 21 …SPIM, TWIM or PWM enabled. This will occasionally cause the first byte transmitted to be incorrect…
|
/Zephyr-Core-3.5.0/subsys/net/l2/ieee802154/ |
D | Kconfig | 38 This will print-out both received and transmitted packets. 48 This will print-out transmitted packets only.
|
D | ieee802154_priv.h | 71 * @param iface A valid pointer on the network the packet will be transmitted to 90 * @param iface A valid pointer on the network the packet was transmitted to
|
/Zephyr-Core-3.5.0/drivers/ethernet/ |
D | Kconfig.cyclonev | 21 of a full-size packet to be transmitted or the packet will be
|
D | Kconfig.dwmac | 49 of a full-size packet to be transmitted or the packet will be
|
D | eth_xlnx_gem_priv.h | 323 * [25] PTP pdelay_resp frame transmitted 324 * [24] PTP pdelay_req frame transmitted 327 * [21] PTP sync frame transmitted 328 * [20] PTP delay_req frame transmitted 334 * [14] Pause frame transmitted
|
/Zephyr-Core-3.5.0/samples/subsys/mgmt/mcumgr/smp_svr/ |
D | overlay-bt.conf | 23 # transmitted with the maximum possible MTU value: 498 bytes.
|
/Zephyr-Core-3.5.0/tests/net/socket/tcp/ |
D | prj.conf | 27 # Allow tapping into the number of transmitted packets
|
/Zephyr-Core-3.5.0/tests/bsim/bluetooth/mesh/tests_scripts/advertiser/ |
D | proxy_mixin.sh | 19 # With the separate scanner, observe that the submitted buffer is transmitted
|
/Zephyr-Core-3.5.0/drivers/wifi/esp32/ |
D | Kconfig.esp32 | 128 For each transmitted data frame from the higher layer TCP/IP stack, 155 transmitted data frame. 157 For each transmitted frame from the higher layer TCP/IP stack,
|
/Zephyr-Core-3.5.0/subsys/net/l2/ethernet/gptp/ |
D | gptp_mi.h | 32 /** Copy of the gptp_md_sync_info to be transmitted. */
|
D | gptp_state.h | 193 /** Pointer to the Path Delay Request to be transmitted. */ 279 /** PortSyncSync structure to be transmitted to the Site Sync Sync. */ 336 /** Sync send to be transmitted to the MD Sync Send State Machine. */ 400 /** PortSyncSync structure transmitted by the state machine. */
|
/Zephyr-Core-3.5.0/include/zephyr/drivers/ |
D | i2s.h | 47 * Serial data is transmitted in two's complement with the MSB first. Both 66 * Serial data is transmitted in two's complement with the MSB first. Both 85 * Serial data is transmitted in two's complement with the MSB first. Both 106 * Serial data is transmitted in two's complement with the MSB first. Both 127 * Serial data is transmitted in two's complement with the MSB first. Both 249 * RX block is transmitted / received the state is changed to READY. 260 * are transmitted the state is changed to READY. 457 * block and will release it when all data are transmitted.
|
/Zephyr-Core-3.5.0/subsys/bluetooth/controller/ll_sw/nordic/lll/ |
D | lll_peripheral.c | 180 * is transmitted, an incorrect acknowledgment by peer should not 181 * dequeue a PDU that has not been transmitted on air. 190 * PDU was transmitted prior to this connection event.
|
/Zephyr-Core-3.5.0/doc/connectivity/networking/api/ |
D | ppp.rst | 17 cannot be transmitted over a modem line on their own, without some data link
|
/Zephyr-Core-3.5.0/subsys/bluetooth/mesh/ |
D | adv_legacy.c | 62 * transmitted without delay when advertising is enabled. No need to in bt_data_send() 73 * being transmitted. Increase the advertising duration by the in bt_data_send()
|
/Zephyr-Core-3.5.0/dts/bindings/can/ |
D | microchip,mcp251xfd.yaml | 68 a Start bit of a CAN message is transmitted or received. If this option
|
/Zephyr-Core-3.5.0/include/zephyr/bluetooth/ |
D | iso.h | 310 /** @brief ISO Meta Data structure for transmitted ISO packets. */ 312 /** CIG reference point or BIG anchor point of a transmitted SDU, in microseconds. */ 476 * The number of times the scheduled payloads are transmitted in a 580 /** The number of times a payload is transmitted in a BIS event */ 910 /** Number of times a payload is transmitted in a BIS event */ 928 /** Number of times a payload is transmitted in a BIS event */ 994 * @details Reads timing information for transmitted ISO packet on an ISO channel. 998 * @note An SDU must have already been successfully transmitted on the ISO channel
|
/Zephyr-Core-3.5.0/subsys/console/ |
D | tty.c | 127 * Otherwise, return how much we transmitted. If error in tty_write() 226 * Otherwise, return how much we transmitted. If error in tty_read()
|
/Zephyr-Core-3.5.0/doc/connectivity/bluetooth/api/ |
D | gatt.rst | 61 the data has been transmitted over the air. Indications are supported by
|
/Zephyr-Core-3.5.0/subsys/bluetooth/controller/ |
D | Kconfig.df | 182 int "Maximum number of transmitted PDUs with Constant Tone Extension in connectionless mode" 187 Maximum supported number of PDUs, that have Constant Tone Extension, transmitted in single
|
/Zephyr-Core-3.5.0/include/zephyr/drivers/i3c/ |
D | target_device.h | 157 * The value returned in @p val will be transmitted. A success 180 * The value returned in @p val will be transmitted. A success
|
123456