Searched full:ground (Results 1 – 25 of 45) sorted by relevance
12
26 1 - Vout is loaded with 1 kOhm resistor to ground27 2 - Vout is loaded 100 kOhm resistor to ground28 3 - Vout is loaded with 500 kOhm resistor to ground
17 and ground, they are not mapped in the nexus.26 Reference Ground - GND GND - Reference Ground
25 JP1 pin 2 to GND (ground MEC172x XTAL1 pin)42 JP1 pin 2 to GND (ground MEC172x XTAL1 pin)53 JP1 pin 2 to GND (ground MEC172x XTAL1 pin)
1 # Copyright (c) 2024 Common Ground Electronics
2 * Copyright (c) 2024 Common Ground Electronics
29 /* ground truths */ in ZTEST()63 /* ground truths */ in ZTEST()
22 - GND: Ground
78 # We use BT_BAP_STREAM as a common ground for audio, as that is set whenever
37 assumed to be connected-ground, which usually means a pull-down resistance
24 and CAN L to ground.
39 share a common ground.49 #. Ensure your Zephyr board, and the LED strip share a common ground.
30 /* short to ground */
50 ground and the white wire to the SCL pin, i.e. pin P19 on the edge connector.
11 * at their 32-bit entry points to cover common ground.
55 * Ground is on pin4
54 * configuration which behaves like a switch that is either connected to ground
56 | 2 | GND | Ground |100 | 6 | GND | Ground |112 | 3 | GND | Ground |
64 * Ground is on pin4
28 and a 100nF capacitor to ground for debouncing.
10 ground for both data transmission and device power supply.
23 /* Select Vin2. Vin1 is not used and tied to ground on this chip. Vin2 is from VDDA_1P8_IN. */
25 other dongle's RX pin. The ground connection is not needed. Both dongles must
51 * Course over ground un 10^-2 degree.
7 number of small ground robotics useful sensors including chirp sensors for time of flight
66 | 6 | GND | Ground pin | - |68 | 7 | GND | Ground pin | - |112 | 29 | GND | Ground pin | - |
