Searched full:d6 (Results 1 – 25 of 200) sorted by relevance
12345678
19 D6 NC40 Arduino UNO layout, labeled from D0 at the bottom to D7 at the top, but D6
31 8 MISO D6 15
28 6 D6 D7 7
27 6 D6 D15 15
27 6 D6 A3/D17 17
39 D6 12
34 5 D5 D6 6
11 in-gpios = <&arduino_header 12 0>; /* Arduino D6 */
13 /* Pin D6 from Arduino Connector */
16 /* D6 */
23 /* D6 */
14 mdm-reset-gpios = <&arduino_header 12 0>; /* D6 */
17 The GPIO port of the LMP90xxx (D6 to D0) is exposed as a
18 enable-gpios = <&arduino_header 12 0>; /* D6 */
140 const struct sockaddr_in6 *d6 = in socks5_tcp_connect() local146 (uint8_t *)&d6->sin6_addr, in socks5_tcp_connect()149 cmd_req.ipv6_addr.port = d6->sin6_port; in socks5_tcp_connect()
25 disp-en-gpios = <&arduino_header 12 GPIO_ACTIVE_HIGH>; /* D6 */
21 mdm-keep-awake-gpios = <&arduino_header 12 GPIO_ACTIVE_HIGH>; /* D6 */
13 /* LMP90xxx supports GPIO D0..D6 */
19 <6 0 &gpio0 43 0>, /* D6 */
20 , <6 0 &portb 8 0> /* D6 */
19 <6 0 &gpio0 21 0>, /* D6 */
25 drdy-gpios = <&arduino_header 12 GPIO_ACTIVE_HIGH>; /* D6 */
21 , <6 0 &gpio1 11 0> /* D6 */
26 device-state-gpios = <&arduino_header 12 GPIO_ACTIVE_HIGH>; /* D6 */
26 softstart = [d7 d6 9d];
