Searched refs:UART0 (Results 1 – 25 of 87) sorted by relevance
1234
6 For single uart configuration - UART0 TX connected to RX and CTS to RTS7 For dual uart configuratiom - UART0 and UART1 TXs and RXs cross-connected
10 /* UART0 */
11 /* UART0 */
14 /* Alternative pin configuration for UART0 */
27 | GP0 (UART0 TX) | D1 |29 | GP1 (UART0 RX) | D0 |
19 - UART0 and UART139 UART0 is configured for serial logs. The default serial setup is 115200 8N1.
66 -C fvp_mps2.UART0.out_file=-67 -C fvp_mps2.UART0.unbuffered_output=1
21 # UART0 config55 # UART0 config
68 * UART0 connected to the USB serial port (pins K18, K19),72 The Zephyr console uses UART0.
46 CPU's UART0.
11 # UART0 config
15 /* UART0: TX(PB2), RX(PB3) */
60 * UART0 connected to the USB serial port (pins G12, G11),64 The Zephyr console uses UART0.
62 * UART0 connected to the USB serial port (pins H15, G11),66 The Zephyr console uses UART0.
16 - UART0 and UART1
77 - Reboot, then observe Zephyr log output via ISH UART0.
40 On board debugger Nu-link2 can emulate UART0 as a virtual COM port over usb,
