Searched refs:SPI0 (Results 1 – 25 of 26) sorted by relevance
12
| /Zephyr-latest/tests/drivers/spi/spi_loopback/boards/ |
| D | ucans32k1sic.overlay | 7 /* Short P1.3 (SPI0/MISO) with P1.4 (SPI0/MOSI) */
|
| /Zephyr-latest/boards/shields/rpi_pico_uno_flexypin/doc/ |
| D | index.rst | 53 | GP16 (SPI0 RX/CIPO) | D12 |
55 | GP17 (SPI0 CS) | D10 |
57 | GP18 (SPI0 SCK) | D13 |
59 | GP19 (SPI0 TX/COPI) | D11 |
|
| /Zephyr-latest/boards/atmel/sam/sam_v71_xult/ |
| D | sam_v71_xult-common.dtsi | 91 <12 0 &piod 25 0>, /* SPI0(NPCS1) */
92 <13 0 &piod 21 0>, /* SPI0(MOSI) EXT2 */
93 <14 0 &piod 20 0>, /* SPI0(MISO) EXT2 */
94 <15 0 &piod 22 0>; /* SPI0(SCK) EXT2 */
116 <12 0 &piod 27 0>, /* SPI0(NPCS3) */
117 <13 0 &piod 21 0>, /* SPI0(MOSI) EXT1 */
118 <14 0 &piod 20 0>, /* SPI0(MISO) EXT1 */
119 <15 0 &piod 22 0>; /* SPI0(SCK) EXT1 */
|
| /Zephyr-latest/boards/ti/cc1352r_sensortag/ |
| D | cc1352r_sensortag-pinctrl.dtsi | 43 /* SPI0 */
|
| /Zephyr-latest/boards/ti/common/ |
| D | launchxl-pinctrl.dtsi | 54 /* SPI0 */
|
| /Zephyr-latest/tests/drivers/flash/common/boards/ |
| D | nrf52840dk_spi_nor.overlay | 42 spi-max-frequency = <8000000>; // chip supports 80Mhz, SPI0 supports 8MHz
|
| D | nrf52840dk_spi_nor_wp_hold.overlay | 42 spi-max-frequency = <8000000>; // chip supports 80Mhz, SPI0 supports 8MHz
|
| /Zephyr-latest/boards/beagle/beagleconnect_freedom/ |
| D | beagleconnect_freedom-pinctrl.dtsi | 54 /* SPI0 */
|
| /Zephyr-latest/boards/nxp/twr_ke18f/ |
| D | twr_ke18f-pinctrl.dtsi | 98 /* Enable PCS2 for SPI0 */
|
| /Zephyr-latest/dts/arc/synopsys/ |
| D | emsdp.dtsi | 130 /* DFSS-SPI0 */
|
| /Zephyr-latest/boards/arduino/nicla_sense_me/ |
| D | arduino_nicla_sense_me.dts | 110 /* SPI0 in datasheet */
|
| /Zephyr-latest/boards/ezurio/rm1xx_dvk/ |
| D | rm1xx_dvk.dts | 60 /* SPI0 cannot be used with I2C0 */
|
| /Zephyr-latest/boards/particle/boron/doc/ |
| D | index.rst | 79 * SPI0 disabled due to TWI0 conflict
|
| /Zephyr-latest/boards/particle/argon/doc/ |
| D | index.rst | 83 * SPI0 disabled due to TWI0 conflict
|
| /Zephyr-latest/boards/sensry/ganymed_bob/doc/ |
| D | index.rst | 61 …odule type 1 with top level sensors (Bosch BME680 - SPI1 , Bosch BMA456 - SPI0, Bosch BMG250 - SPI…
|
| /Zephyr-latest/boards/particle/xenon/doc/ |
| D | index.rst | 84 * SPI0 disabled due to TWI0 conflict
|
| /Zephyr-latest/boards/madmachine/mm_feather/doc/ |
| D | index.rst | 75 | P7 | GPIO_AD_B1_14 | D7 | GPIO1_IO30 | SPI0 | SPI_3 |
|
| /Zephyr-latest/boards/wiznet/w5500_evb_pico2/doc/ |
| D | index.rst | 45 Pi Pico, the blinky example works as intended. The W5500 is routed to the SPI0
|
| /Zephyr-latest/boards/madmachine/mm_swiftio/doc/ |
| D | index.rst | 58 +-----------+---------------+----------+---------------+ SPI0 | SPI_4 |
|
| /Zephyr-latest/boards/norik/octopus_io_board/doc/ |
| D | index.rst | 56 * 2x SPI0 bus
|
| /Zephyr-latest/boards/wiznet/w5500_evb_pico/doc/ |
| D | index.rst | 44 Pi Pico, the blinky example works as intended. The W5500 is routed to the SPI0
|
| /Zephyr-latest/boards/snps/emsdp/doc/ |
| D | index.rst | 87 Note: DW SPI only available on SPI0 and SPI1.
|
| /Zephyr-latest/boards/snps/hsdk/doc/ |
| D | index.rst | 227 read though SPI0 using SPI chip select 1.
|
| /Zephyr-latest/boards/snps/hsdk4xd/doc/ |
| D | index.rst | 224 read though SPI0 using SPI chip select 1.
|
| /Zephyr-latest/modules/hal_nordic/nrfx/ |
| D | Kconfig | 479 bool "SPI0 driver instance"
|
12
