Searched refs:pull_up (Results 1 – 9 of 9) sorted by relevance
| /Zephyr-latest/boards/arduino/nano_33_ble/ |
| D | board.c | 14 static const struct gpio_dt_spec pull_up = in board_init() local
19 if (!gpio_is_ready_dt(&pull_up)) { in board_init()
27 res = gpio_pin_configure_dt(&pull_up, GPIO_OUTPUT_HIGH); in board_init()
|
| /Zephyr-latest/soc/nuvoton/numicro/common/ |
| D | pinctrl_soc.h | 21 uint32_t pull_up : 1; member
35 .pull_up = DT_PROP(node_id, bias_pull_up), \
|
| /Zephyr-latest/soc/quicklogic/eos_s3/ |
| D | pinctrl_soc.h | 21 uint32_t pull_up: 1; member
36 .pull_up = DT_PROP(node_id, bias_pull_up), \
|
| /Zephyr-latest/soc/renesas/rzt2m/ |
| D | pinctrl_soc.h | 22 uint32_t pull_up: 1; member
40 .pull_up = DT_PROP(node_id, bias_pull_up), \
|
| /Zephyr-latest/drivers/gpio/ |
| D | gpio_cy8c95xx.c | 28 uint8_t pull_up; member
76 rc = i2c_reg_write_byte_dt(&cfg->i2c, CY8C95XX_REG_PULL_UP, pins->pull_up); in write_pin_state()
106 WRITE_BIT(pins->pull_up, pin, (flags & GPIO_PULL_UP) != 0U); in cy8c95xx_config()
251 .pull_up = 0xFF, in cy8c95xx_init()
|
| D | gpio_sx1509b.c | 43 uint16_t pull_up; /* 0x06 */ member
256 pin_buf.pins.pull_up = sys_cpu_to_be16(pins->pull_up); in write_pin_state()
319 pins->pull_up |= BIT(pin); in sx1509b_config()
321 pins->pull_up &= ~BIT(pin); in sx1509b_config()
356 pins->input_disable, pins->pull_up, pins->pull_down, in sx1509b_config()
683 pins->pull_up &= ~BIT(pin); in sx1509b_led_intensity_pin_configure()
|
| /Zephyr-latest/drivers/pinctrl/ |
| D | pinctrl_eos_s3.c | 106 } else if (pin->pull_up | pin->pull_down) { in pinctrl_eos_s3_configure_pin()
107 WRITE_BIT(reg_value, PAD_PULL_UP_BIT, pin->pull_up); in pinctrl_eos_s3_configure_pin()
|
| D | pinctrl_numicro.c | 67 if (pin->pull_up != 0) { in gpio_configure()
|
| /Zephyr-latest/drivers/pinctrl/renesas/rz/ |
| D | pinctrl_rzt2m.c | 43 pin->drive_strength, (pin->pull_up == 1 ? 1U : (pin->pull_down == 1 ? 2U : 0)), in pinctrl_configure_pin()
|
